Instrukcja obsługi GE VTD56GASVWB

GE suszarka VTD56GASVWB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE VTD56GASVWB (12 stron) w kategorii suszarka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/12
Commercial Laundry
Coin Drop
Installation
Instructions
03-23 GEA
31-3000319 Rev 1
Ŷ
Ŷ
Ŷ
Ŷ
Ŷ
S
ingle
C
oin Drop
with 11/32" Mounting
N
uts
a
n
d
B
o
l
ts
Ŷ
Ŷ
Ŷ
Ŷ
Ŷ Double Coin Drop
with 11/32" Mounting
Nuts and Bolts
CONTENTS
Wear gloves.
Failure to do so may result in lacerations.
WARNING
TOOLS YOU WILL NEED
Ŷ
Ŷ
Ŷ
Ŷ
Ŷ Gloves Ŷ
Ŷ
Ŷ
Ŷ
Ŷ 11/32" Socket & Nut Driver
Questions, call GE Appliances at 866-531-9828 or visit our Website at: GEAppliances.com/commerciallaundry
Disconnect power before installing.
Replace all parts and panels before operating.
Failure to do so could result in serious injury or death.
- Electrical Shock Hazard
WARNING
Failure to comply with the requirements stipulated in
this manual can result in personal injury or component
failure.
Component failure due to improper installation will void
the warranty.
WARNING
OR
GE is a trademark of the General Electric Company. Manufactured under trademark license.
Features and appearance will vary throughout
For use on
standalone models
For use on
stacked models
Ŷ
Ŷ
Ŷ
Ŷ
Ŷ Phillips-Head Screwdriver
Ŷ
Ŷ
Ŷ
Ŷ
Ŷ Coin Drop Cover
For use on stacked dryers only.
(Shipped in dryer components
bag inside drum.)
IMPORTANT
See page 6 for VTW56 & VTD56 models coin box
installation instructions.
See pages 1-6 for VFW310 and VFD31 models coin
drop and coin box installation instructions.
2
Installation Instructions
1 REMOVE MOUNTING PLATE
FROM WASHER
Ŷ Disconnect power before installing.
Ŷ Unlock the coin drop mounting plate from the front of
the washer using the key shipped with the washer.
Ŷ Partially pull out the left side of the mounting plate,
slide it to the left and remove it from the washer.
WASHER - COIN DROP INSTALLATION
For Double Coin Drop/Stacked Models Only
2 REMOVE CONTROL PANEL
FROM STACKING (TOP) DRYER
Ŷ Disconnect
power.
Ŷ Unlock the
control panel
from the front of
the dryer using
the key shipped with the dryer.
Ŷ Rotate it and
tuck it onto the
dryers upper
shelf.
NOTE: Do not
disconnect
wires.
Control Panel
For Double Coin Drop/Stacked Models Only
4
IMPORTANT!
FOLLOW THE STACKING
SECTION IN
THE WASHERS OWNER'S MANUAL
& INSTALLATION INSTRUCTIONS
TO INSTALL THE STACKING DRYER
ONTO THE WASHER
Ŷ Reach into the dryer's opening, unbundle the wiring
harness connectors, and pull the two connectors
down through the two knocked-out areas in the right
corners of the dryer and the washer.
COIN 2
COIN 1
Pull the two connectors down and through
the two knockouts (bottom knockout in the
dryer and top knockout in the washer)
3 ASSEMBLE COIN DROP FACE
PLATE TO MOUNTING PLATE
Ŷ Place the coin drop body to rear side of mounting
plate (removed in step 1).
Ŷ Align the corner mounting holes and insert a bolt
through each hole in the face plate/mounting plate
assembly. Secure each bolt with a nut.
Single Coin Drop - Install on Standalone Models
Nuts
Bolts
Mounting
Plate
Face
Plate
Double Coin Drop - Install on Washer on Stacked Models
Nuts
Bolts
Mounting
Plate
Face
Plate
Installation Instructions
6
INSTALL COIN DROP ASSEMBLY
ONTO WASHER
Ŷ Push wiring back into the appliance opening and
make sure it will not interfere with the coin paths or
the coin slots in the top of the coin box.
Ŷ Hook the right retaining tab of the coin drop assembly
under the retaining edge on the washer, push the left
side in to close, and lock it with the key.
3
5
CONNECT COIN DROP ASSEMBLY
WIRING TO WASHER WIRING
Ŷ Reach into the washers opening and pull the wiring
harness connectors out into the opening just enough
to enable connection.
Ŷ For Single Coin Drop/Standalone Models Only:
Connect “Coin 1” or “Coin 2” connector into the
connector on the coin drop.
Ŷ For Double Coin Drop/Stacked Models Only:
Connect "Coin 1" or "Coin 2" connector from the lower
washer's harness into the connector on the right
coin drop (with colored dot).
Connect "Coin 1" or "Coin 2" connector
from the upper
dryer's harness into the connector on the left coin
drop (without colored dot).
COIN 2
COIN 1
Connect
Coin 1 or Coin 2
connector
into the
coin drop connector
or
COIN 2
COIN 1
COIN 1
COIN 2
Connect
Coin 1 or Coin 2
from upper harness
into the left coin drop
connector
(without colored dot)
Connect
Coin 1 or Coin 2
from lower harness
into the right coin drop
connector
(with colored dot)
or
or
Left
coin drop
Right
coin drop
Hook, close
and lock
WASHER - COIN DROP INSTALLATION
For Double Coin Drop/Stacked Models Only
7
REINSTALL CONTROL PANEL AND
INSTALL COVER PLATE ON DRYER
Ŷ Replace the dryer's control panel and lock it with the
access key.
Ŷ Snap the white cover into the coin meter opening of
the dryer.


Specyfikacje produktu

Marka: GE
Kategoria: suszarka
Model: VTD56GASVWB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z GE VTD56GASVWB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje suszarka GE

Instrukcje suszarka

Najnowsze instrukcje dla suszarka

Asko

Asko TDC1773VP.S Instrukcja

28 Października 2024
Sharp

Sharp KD-NHH8S8GW3 Instrukcja

19 Października 2024
Miele

Miele TSF763WP Instrukcja

9 Października 2024
Miele

Miele TCF770WP Instrukcja

9 Października 2024
Miele

Miele PT 8303 SL Instrukcja

8 Października 2024
Miele

Miele WT 2789 i WPM Instrukcja

8 Października 2024
Miele

Miele T 4819 Ci Instrukcja

8 Października 2024
Daewoo

Daewoo T8HT1W2ES Instrukcja

26 Września 2024
Siemens

Siemens WQ45B2A5NL Instrukcja

23 Września 2024