Instrukcja obsługi GE ETD48GASWWB

GE suszarka ETD48GASWWB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE ETD48GASWWB (40 stron) w kategorii suszarka. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/40
- Risk of Fire
Clothes dryer installation must be performed by a
qualified installer.
Install the clothes dryer according to these instructions
and local codes.
DO NOT install a clothes dryer with flexible plastic venting
materials. If flexible metal (semi-rigid or foil-type) duct is
installed, it must be UL-listed and installed in accordance
with the instructions found in “Connecting the Dryer
to House Vent” later in this manual. Flexible venting
materials are known to collapse, be easily crushed and
trap lint. These conditions will obstruct dryer airflow and
increase the risk of fire.
DO NOT install or store this appliance in any location
where it could be exposed to water or weather.
To reduce the risk of severe injury or death, follow all
installation instructions.
Save these instructions. (Installers: Be sure to leave
these instructions with the customer.)
In the Commonwealth of Massachusetts,
the following installation instructions apply:
Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
If using a ball valve, it shall be a T-handle type.
A flexible gas connector, when used, must not
exceed 4 feet.
FOR GAS DRYERS ONLY
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for local electrical
inspector’s use.
IMPORTANT
Observe all governing codes and
ordinances.
Install the clothes dryer according to the manufacturer’s
instructions and local codes.
Note to Installer Be sure to leave these instructions
with the Consumer.
Note to Consumer Keep these instructions for future
reference.
Clothes dryer installation must be performed by a qualified
installer.
This dryer must be exhausted to the outdoors.
Before the old dryer is removed from service or discarded,
remove the dryer door.
Do not allow children on or in the appliance. Close
supervision of children is necessary when the appliance
is used near children.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
Install the dryer where the temperature is above 50°F for
satisfactory operation of the dryer control system.
Remove and discard existing plastic or metal foil duct
and replace with UL-listed duct.
Service information and the wiring diagram are located
in the control console.
Questions? Call GE Appliances at 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
Dryers
Installation Instructions
WARNING
Failure to follow safety warnings exactly could
result in serious injury, death, or property damage.
- DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
DO NOT try to light any appliance.
DO NOT touch any electrical switch; DO NOT
use any phone in your building.
Clear the room, building, or area of any occupants.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by
a qualified installer, service agency, or the gas
supplier.
- Fire or Explosion
Hazard
WARNING
31-3000293 Rev 2
07-23 GEA
Installation Instructions
2
Tilt the dryer sideways and remove the foam
shipping pads by pulling at the sides and breaking
them away from the dryer legs. Be sure to remove
all of the foam pieces around the legs.
Remove the bag containing the literature.
UNPACKING YOUR DRYER
ROUGH-IN
DIMENSIONS
GE Appliances strongly recommends the use of factory
specified parts. These hoses are manufactured and tested
to meet GE Appliances specifications.
GE Appliances strongly recommends the use of new water
supply hoses. Hoses degrade over time and need to be
replaced every 5
years to reduce the risk of hose failures
and water damage.
Parts and Accessories
Order on-line at , 24 hours a day GEApplianceparts.com
or by phone at during normal business hours.877.959.8688
STEAM WATER HOSES (for steam dryer models only):
ACCESSORIES:
Order on-line at , 24 hours a day or GEApplianceparts.com
by phone at during normal business hours.877.959.8688
Part Number Accessory
PM14X10056
Dryer door opening vent brush
WX14X10007
LintEater™ Dryer rotary tube brush
PM08X10085
Flexible Metal Dryer Transition Duct
Part Number Accessory
WE25X20060
Complete Kit (hoses, Y-adapter, washers)
or
WE49X25794
Kit (Short hose, Y-adapter, washers)
and
WE1M847 Long Hose
OR SEPARATELY
WE1M847 Long Hose and
WE1M848 Short Hose
4 5/8
(11.7 cm)
or
6 1/2
(16.5 cm)
with Riser
Y
X
27”
(68.8 cm)
X
4 1/4
(10.8 cm)
Side ViewFront View
Cubic
Foot X Y
6.2 43 3/8”
(110 cm)
26 3/4”
(68 cm)
7.2 43 3/8”
(110 cm)
29 1/2”
(75 cm)
7.4 43 3/4”
(111 cm)
30 1/2”
(78 cm)
Installation Instructions
MOBILE OR MANUFACTURED
HOME INSTALLATION
Installation MUST conform to the MANUFACTURED
HOME CONSTRUCTION AND SAFETY
STANDARD, TITLE 24, PART 3280 or STANDARD
FOR MOBILE HOMES CAN/CSA-Z240 MH, or,
when such standards are not applicable, with
AMERICAN NATIONAL STANDARD FOR MOBILE
HOME, ANSI/NFPA NO. 501B.
The dryer MUST be vented to the outdoors.
The exhaust vent MUST be securely fastened to a
non-combustible portion of the mobile home.
The vent MUST NOT be terminated beneath a
mobile or manufactured home.
The vent duct material MUST BE METAL.
KIT 14-D346-33 MUST be used to attach the dryer
securely to the structure.
The vent MUST NOT be connected to any other
duct, vent or chimney.
DO NOT use sheet metal screws or other
fastening devices which extend into the interior of
the exhaust vent.
Provide an opening with a free area of at least 25
square inches for introduction of outside air into
the dryer room.
See the sections for electrical connection information.
REQUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18” (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
The dryer MUST be vented to the outdoors.
Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is:
0” either side
0” rear
0” front
1” top
Consideration must be given to provide adequate
clearance for installation and service.
Closet doors must be louvered or otherwise ventilated
and have at least 60 square inches of open area. If
the closet contains both a washer and a dryer, doors
must contain a minimum of 120 square inches of
open area.
NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT
THE REAR OF THE DRYER, THE CONFIGURATION
OF THE DUCTING MAY REQUIRE GREATER THAN
1” OF REAR CLEARANCE.
Gas Dryers Only:
No other fuel burning appliance shall be installed in
the same closet as a gas dryer.
The dryer must be disconnected from the gas
supply piping during pressure testing at pressures
greater than ½ psi (3.5 kPa).
A 1/8 inch NPT minimum plugged tapping,
accessible for test gauge connection, must be
installed immediately upstream of the gas supply
connection to the dryer.
- Explosion Hazard
WARNING
MINIMUM CLEARANCE OTHER THAN
ALCOVE OR CLOSET INSTALLATION
Minimum clearance to combustible surfaces and
for air opening are: 0both sides, 0” rear and 1” top.
Consideration must be given to provide adequate
clearance for installation and service.
3


Specyfikacje produktu

Marka: GE
Kategoria: suszarka
Model: ETD48GASWWB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z GE ETD48GASWWB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje suszarka GE

Instrukcje suszarka

Najnowsze instrukcje dla suszarka

Daewoo

Daewoo T8HT1W2ES Instrukcja

26 Września 2024
Siemens

Siemens WQ45B2A5NL Instrukcja

23 Września 2024
Siemens

Siemens WT45N202GB Instrukcja

22 Września 2024
Speed Queen

Speed Queen FG3840 Instrukcja

17 Września 2024
Vedette

Vedette EG33 Instrukcja

17 Września 2024
Mabe

Mabe SMV745NXEBB Instrukcja

16 Września 2024
Hoover

Hoover HLE V8LG-80 Instrukcja

16 Września 2024
Hoover

Hoover HLE V9TG-80 Instrukcja

16 Września 2024
Gram

Gram TPS 7731-92 Instrukcja

16 Września 2024