Instrukcja obsługi Friedland D417E

Friedland dzwonek do drzwi D417E

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Friedland D417E (1 stron) w kategorii dzwonek do drzwi. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/1

D417E

Fig 6

1. Open the bell push

To open the front cover carefully

insert a flat bladed screw driver, into

the slot and twist gently (A). When

refitting the front cover to ensure

the weather proofing is maintained,

always mount the bell push in the

upright position and replace the

cover securely. Fig 1

2. To fit or replace the battery

Open the front cover and insert

the CR 2032 Lithium coin cell

battery into the base as shown

in Fig 2. Any debris created

during installation must be

removed from the base before

fitting battery, to ensure good contact.

3. Mount the bell push

Ensure the wall surface is clean

and dry. Mount using either the

double sided sticky pad on a

smooth surface, or the screws

and wall plugs provided, See Fig 3.

Do not mount the push on or near

(< 30cm) large metal objects, as it

will block signals from the push.

4. Test the bell push

When the bell push button is pressed,

the confidence light (B) in Fig 4, will

illuminate to reassure the caller that

the bell push is working.

The light will flash 5 times when

the battery needs replacing.

5. Use of the door chime

Plug the chime into any

220-240V BS 1363 socket,

installed in a clean dry

environment, situated

within transmission

range of the bell push,

as shown in Fig 5.

6. Automatic Programming of bell pushes

The first time a chime unit is powered up, the sounds available

are demonstrated. Press the door push until the chime

responds with a tune. You can leave this tune or change it to a

desired tune by using button A (see fig 6) (see Sound Selection).

To programme a second push, press the push button until the

chime sounds, then use button B to change the tune if

required. Programming is now completed.

If more than 5 minutes has elapsed, you will have to reset the

chime programing by pressing and holding buttons A and B

until the chime sounds, this takes approximately 5 seconds.

The chime can then be programmed to 1 or 2 door pushes.

All EVO and Décor Chimes and Bell Pushes use a self learning

feature to ensure no interaction from other neighbouring

systems.

7. Sound Selection

A = Main push sound selection

B = Second push sound selection

Chime tune options are as follows:

1. Tone Bar 2 Note (Default Tune for 1st Push)

2. Bass clarinet (Default Tune for 2nd Push)

Fig 1

Fig 2

Fig 4

Fig 5

Fig 3

Evo 50m* Wirefree

Plug-In Chime Kit

Declaration

Novar ED&S hereby declares that this

wirefree chime kit is in compliance with

the essential requirements and other

relevant provisions of the Radio and

Telecommunications Terminal Equipment

(R & TTE) directive, 1999/5/EC

Pack contents:

50m Plug-In Chime 230v

Bell push & CR2032 Lithium coin cell battery

Adhesive pad, 2 x screws (ø3x20mm) 2 x wall plugs (ø5x25mm)

for mounting the bell push

You will require:

A small crosshead and flathead screwdriver, a ø5 masonry drill

The stated transmission range of this product is measured in

open field conditions. Walls ceilings, and metal structures will

reduce the maximum range.

Friedland guarantees this product for 3 years from date of purchase.

Proof of purchase is required, this does not affect your statutory rights.

If you require further information about our products, call the Friedland

helpline on 01268 563066.

Friedland a Novar business, Novar ED&S, The Arnold Centre,

Paycocke Road, Basildon, Essex, SS14 3EA, England

www.friedland.co.uk

Trouble Shooting

Chime not Sounding

Chime may be positioned out of range of the bell push

Move your chime closer to the bell push

A metallic object may be blocking the signal from bell push

position



Experiment with the location of the chime to see if you can

move it in a more suitable place

The battery in the bell push may need replacing

Press the bell push. If the confidence light (B) flashes 5 times

after being pushed, replace the battery.

Note: In cold conditions, poor location or environment,

operating at maximum range it is advisable to replace the

battery more frequently before the indicator light flashes

(i.e every 12 - 18 months) to maintain optimum performance

Your bell push and chime haven't been programmed

Reset the automatic programming of your chime and bell push

Instructions – Please retain these instructions for future reference

Specyfikacje produktu

Marka:	Friedland
Kategoria:	dzwonek do drzwi
Model:	D417E

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Friedland D417E, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje dzwonek do drzwi Friedland

Friedland Evo Wirefree 200m - D412 Instrukcja

23 Września 2024

Friedland L430N Spectra Plus Instrukcja

23 Września 2024

Friedland Evo 100m - D421E Instrukcja

19 Września 2024

Friedland D3005S Instrukcja

11 Września 2024

Friedland EvoHome D426E Instrukcja

9 Września 2024

Friedland D962S Instrukcja

8 Września 2024

Friedland EvoHome and Garden Kit - D426E Instrukcja

8 Września 2024

Friedland D3200 Instrukcja

7 Września 2024

Friedland D359 Instrukcja

6 Września 2024

Friedland D3120S Instrukcja

5 Września 2024

Instrukcje dzwonek do drzwi

Najnowsze instrukcje dla dzwonek do drzwi

Gira 2506 20 Instrukcja

15 Października 2024

Panasonic VL-VM902EX Instrukcja

12 Października 2024

Elro DB260F Instrukcja

10 Października 2024

Eufy Video Doorbell C30 Instrukcja

9 Października 2024

Velleman HAM9011 Instrukcja

9 Października 2024

CATA THALASSA PRO 90 GGR Instrukcja

8 Października 2024

CATA CK 6000 X Instrukcja

8 Października 2024

CATA THALASSA 600 GWH Instrukcja

8 Października 2024

CATA THALASSA PRO 700 GBK Instrukcja

8 Października 2024

CATA THALASSA PRO 800 GBK Instrukcja

8 Października 2024