Instrukcja obsługi Fluval Nano \

Fluval Filtr wody Nano \

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fluval Nano \ (32 stron) w kategorii Filtr wody. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/32
Instruction
Manual
Gebrauchsin-
formation
Mode
d’emploi
Gebruiksaan-
wijzing
Manual de
instrucciones
CONGRATULATIONS
on your purchase of the Fluval Nano
Aquarium Filter. For a complete understanding of the filter’s operation
and capabilities, please read carefully and follow these instructions.
Be certain to read the SAFETY INSTRUCTIONS before using your filter.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING - To guard against injury, basic safety precautions should be
observed, including the following:
1.
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
2. DANGER –To avoid possible electric shock, special care should be
taken since water is employed in the use of aquarium equipment.
For each of the following situations, do not attempt repairs
yourself; return the appliance to an authorized service facility for
service or discard the appliance.
A.
If the appliance shows any sign of abnormal water leakage or
if RCD (or GFCI- Ground Fault Current Interrupter) switches off,
disconnect the power supply cord from mains and remove the
filter pump from water.
B.
Carefully examine the appliance after installation. It should not
be plugged if there is water on parts not intended to be wet.
C.
Do not operate any appliance if it has a damaged cord or plug,
or if it is malfunctioning or it is dropped or
damaged in any manner. The power cord
of this appliance cannot be replaced; if the
cord is damaged, the appliance should be
discarded. Never cut the cord.
D.
To avoid the possibility of the appliance
plug or receptacle getting wet, position the
appliance to one side of a wall mounted
receptacle to prevent water from dripping
onto the receptacle or plug. A “drip loop”
(see illustration 1) should be arranged by the
user for the cord connecting appliance to a
receptacle. The “drip loop” is that part of the
cord below the level of the receptacle or the connector if an
extension cord is used, to prevent water travelling along the
cord and coming in contact with the receptacle. If the plug or
receptacle does get wet, DON’T unplug the cord. Disconnect
(illustration 1)
the fuse or circuit breaker that supplies power to the appliance.
Then unplug and examine for presence of water in receptacle.
3.
- Close supervision is necessary when any appliance WARNING
is used by or near children. This appliance is not intended for use
by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with
the appliance.
4.
To avoid injury, do not touch moving parts or hot parts.
5.
– Always unplug or disconnect all appliances in the CAUTION
aquarium from electricity supply before placing hands in water,
before putting on or taking off parts and whilst the equipment is
being installed, maintained or handled. When inserting or removing
the filter pump from the water, always pull out the main electricity
plug. Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect. Always unplug an appliance from an outlet
when not in use.
6.
This is an aquarium filter pump. Do not use this filter pump for
other than intended use (i.e.: do not use in swimming pools,
bathrooms, etc.). The use of attachments not recommended or sold
by the appliance manufacturer may cause an unsafe condition.
 •Donotusethislterpumpinswimmingpoolsorothersituations
where people are immersed.
 •Thislterpumpissuitableforuseinwatertemperaturesupto35°C.
 •Donotusethislterpumpwithinammableordrinkableliquids.
7.
This filter pump is suitable for Indoor Household Use Only.
8.
Use only with fresh water. Not for use in salt water aquariums.
9.
Do not install or store the appliance where it will be exposed to
the weather or to temperatures below freezing.
10.
Make sure that the filter pump is securely installed before operating
it. Do not allow pump to run dry. The filter pump must be immersed
in water completely. This filter pump must never operate outside
of water.
11.
If an extension cord is necessary, a cord with proper rating should
be used. A cord rated for less amperes or watts than the appliance
rating, may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled.
12.
For the complete use and understanding of this product it is
recommended that this manual is thoroughly read and understood.
Failure to do so may result in damage to this product.

Specyfikacje produktu

Marka: Fluval
Kategoria: Filtr wody
Model: Nano \

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Fluval Nano \, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Filtr wody Fluval

Fluval

Fluval AquaClear AC30 Instrukcja

9 Października 2024
Fluval

Fluval AquaClear AC50 Instrukcja

9 Października 2024
Fluval

Fluval AquaClear AC20 Instrukcja

9 Października 2024
Fluval

Fluval AquaClear AC70 Instrukcja

9 Października 2024
Fluval

Fluval Nano \ Instrukcja

7 Października 2024
Fluval

Fluval FL 407 Instrukcja

23 Września 2024

Instrukcje Filtr wody

Najnowsze instrukcje dla Filtr wody

Laica

Laica J35-AD Instrukcja

15 Października 2024
Laica

Laica J35-EB Instrukcja

15 Października 2024
Laica

Laica J11-AB Instrukcja

15 Października 2024
Laica

Laica J51-BC Instrukcja

15 Października 2024
GE

GE GX1S15C Instrukcja

13 Października 2024
Grohe

Grohe Red Instrukcja

11 Października 2024
Eden

Eden 316 Instrukcja

8 Października 2024
Eden

Eden 126 Instrukcja

8 Października 2024
Eden

Eden 105 Instrukcja

8 Października 2024
T.I.P.

T.I.P. WDF 20000 UV 18 Instrukcja

8 Października 2024