Instrukcja obsługi Extech 380396

Extech Niesklasyfikowane 380396

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Extech 380396 (17 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/17
User Manual
Digital High Voltage Insulation Tester
Model 380395 380396 or
2 380395_380396- - _V1.5 /en US 10 23
Introduction
Congratulations on your purchase of the Extech 380395 (120V) or 380396 (220V) High Voltage Insulation
Tester is meter provides four Insulation Resistance test ranges plus Continuity, AC/DC Voltage, . Th
Polarization Index and Dielectric Absorption Ratio measurements. This meter is shipped fully tested and
calibrated and, with proper care and , will provide years of reliable service. use
Features
• Auto ranging 6000 count LCD display with bargraph
• Selectable LCD backlight level function facilitates working dimly illuminated areas. in
• MAX/MIN, PEAK, Relative, and Data hold functions for DC/AC voltage measurements.
• Designed to the following safety standards:
IEC 61010-1 (CAT IV 600V Pollution degree 2)
IEC 61010-031 (Requirements for hand-held probes)
• Insulation test range: 0. 61MΩ to 0GΩ.
• Insulation test voltages: 500 0V, 100 V, 1 5 . 500V, and 000V
• AC/DC voltage: 0.5 V to 600 V.
• 200mA Continuity.
• Resistance: 0.1 Ω to 6kΩ.
• Auto-discharge function & voltage output warning function.
• E cally discharged after measurements. Discharge lectric charges stored in capacitive circuits are automati
status can be check using the real time voltage graph. ed bar
• LIVE circuit warning symbols plus audible warning.
• Live circuit detection prevents insulation test if voltage > 30 V is detected.
• Auto-power off function and battery check.
• Programmable Test Timer measurement function.
• Polarization Index measurement (PI).
• Dielectric Absorption Ratio measurement (DAR).
• Power source: Eight (8) 1.5V ‘C’ Cell Batteries.
3 380395_380396- - _V1.5 /en US 10 23
Safety
International Safety Symbols
This symbol, adjacent to another symbol or terminal, indicates the user must refer to the manual for
further information.
This symbol, adjacent to a terminal, indicates that, under normal use, hazardous voltages may be
present.
Danger: identifies conditions and actions that pose hazard(s) to the user.
Warning: alerts the user to avoid electric shock.
Caution: identifies conditions and actions that may damage the Insulation Resistance tester.
Operating Caution: identifies conditions where the user needs to take extra care during the
operation of the Insulation resistance tester
Danger: Use of this instrument in a manner not specified by the manufacturer may impair safety
features/protection provided by the equipment. Read all of the safety information carefully before
using or servicing the instrument.
This symbol indicates that the meter uses double or reinforced insulation.
Safety Notes
• Do not exceed the maximum allowable input range for any functions. of the meter’s
• Set the function switch OFF when the meter is not in use.
• Remove the batteries the meter is to be stored for longer than 60 days.if
Warnings
• Set the function switch to the appropriate position before measuring.
• Do not measure current on a circuit whose voltage exceeds 600V.
• When changing ranges always disconnect the test leads from the circuit under test.
• Do not use the Insulation resistance tester if it is damaged or if metal parts are exposed. Also, check
the meter for cracks or missing plastic.
• Be careful when working above 30V AC rms or 30V DC. Such voltages pose a shock hazard. Discharge all
circuit loads under test after measuring high voltage.
• Do not replace the batteries with the tester in a wet environment.
• Place the test leads in the proper input terminals. Ensure that the test leads are firmly connected to the
Insulation Resistance tester’s input terminals.
• Ensure that the Insulation Resistance tester is switched off when opening the battery compartment.

Specyfikacje produktu

Marka: Extech
Kategoria: Niesklasyfikowane
Model: 380396

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Extech 380396, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Extech

Extech

Extech 380396 Instrukcja

3 Października 2024
Extech

Extech HDV600 Instrukcja

3 Października 2024
Extech

Extech 380395 Instrukcja

3 Października 2024
Extech

Extech SD200 Instrukcja

28 Sierpnia 2024
Extech

Extech 382280 Instrukcja

25 Sierpnia 2024
Extech

Extech EMF510 Instrukcja

18 Sierpnia 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024