Instrukcja obsługi EverFocus ECD230


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla EverFocus ECD230 (6 stron) w kategorii Kamera monitorująca. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/6
EVERFOCUS
Color Dome Camera
Operation Instructions
Model: ECD230
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1. Do not have camera immersed in water.
2. Do not disassemble it or place it on an unstable base.
3. Do not touch the surface of CCD sensor by hand directly.
4. Never face the camera toward the sun.
5. Use proper power source otherwise the camera will not function correctly.
6. Use the camera at temperatures within 0 ~ 50/32℉ ℉~122 and humidity between 20%~
80%. The input power sources is 12VDC only.
1
PREFACE
These cameras are compact, full functioned CCD cameras. Their stylish appearance can be
applied as per installer's ideal locations. These dome cameras can be mounted either on the
ceiling or on the wall easily. The camera uses high sensitive 1/3" color interline transfer CCD
sensor with DSP. The camera is featured with Auto Electronic Shutter, Automatic Gain Control,
and Auto White Balance functions.
FEATURES
z The high sensitivity is achieved by using 1/3” SONY Super HAD interline transfer color
CCD
z The electronic shutter and AGC functions allow the camera to be used in environment with
varying light levels.
z Built-in anti-aliasing and IR-cut optical filter
z Compact size: 87 mm (D). x 58 mm (H) / 3.48” (D) x 2.31” (H)
z System available for NTSC or PAL
STANDARD ACCESSORIES
z Camera Unit
z Operation Instructions (this document)
2
LENS AVAILABLE
* Standard board lens f=3.6 mm, F=2.0 mm.
* Other available lens : 4 Lens f=4.3 mm, F=2.0 mm
6 Lens f=6.0 mm, F=2.0 mm
8 Lens f=8.0 mm, F=2.0 mm
INSTALLATION
1. Remove the plastic dome cover.
2. Loosen the two screws of the supporting bracket to remove the camera body.
3. Using four screws to fix the camera base on the ceiling.
4. Put the camera body back to the supporting bracket, the connector of the back panel
should always be placed to camera’s left lower corner, in order to obtain the image of best
quality. Tighten the 2 screws to fix the camera. Please refer to the back panel diagram
shows as below:
a. Floor Mount b. Ceiling Mount
c. Wall mount, aim to the right d. Wall mount, aim to the left
Main
Board
Bottom Connector


Specyfikacje produktu

Marka: EverFocus
Kategoria: Kamera monitorująca
Model: ECD230

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z EverFocus ECD230, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Kamera monitorująca EverFocus

Instrukcje Kamera monitorująca

Najnowsze instrukcje dla Kamera monitorująca