Instrukcja obsługi Euky Bear Warm Steam Vaporiser

Euky Bear nieskategoryzowany Warm Steam Vaporiser

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Euky Bear Warm Steam Vaporiser (4 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
Trouble Shooting
1. The vaporiser is spitting/spurting water out of the steam vent
Common causes: Inhalant added after water. Incorrect inhalant used or too much inhalant. Water level too high or
low. Vaporiser needs cleaning.
Solution: Shake inhalant bottle well before use. Always add inhalant before water and ensure well mixed. Only use
Euky Bear or Bosisto’s inhalants (water soluble). Use no more than 2 capfuls (10mL) of inhalant. Ensure water
level is filled to the maximum fill line. Do not overfill. Clean vaporiser using Euky Bear Vaporiser Cleaning Tablets.
2. Vaporiser tripped the safety switch or blew a fuse:
Common cause: In some households safety switches are sensitive when an additional load is placed on the circuit.
Solution: Turn off the vaporiser at the power point. Switch to a power point not connected to other appliances.
Leave for 2 minutes. Switch on and reset power point to check if vaporiser is working. If not, the safety fuse in the
vaporiser may have been activated. In this case contact FGB Customer Service on details below.
3. Vaporiser producing too much steam or condensation
Common cause: The vaporiser should not operate in a closed, poorly ventilated room.
Solution: Open the door and/or window and ensure that the room has proper ventilation.
4. Vaporiser producing insufficient steam
Common cause: There is a build up of mineral deposits on and around the heating module (these are naturally
caused by the heating of water by an electrical device).
Solution: Use Cleaning Tablets every 3rd or 4th use or during every operation if you are using dam or hard water.
Failure to maintain this procedure may damage the unit. This may also void the warranty.
5. The vaporiser has stopped steaming but the light is on
Common cause: The vaporiser will stop steaming when the heating unit is no longer in contact with water, but will
remain on. The heating unit has been specifically designed to avoid overheating. The vaporiser may stay warm until it
is switched off at the power point. To help remind you to switch off the power after use, the night light will stay on also.
Solution: Always switch the power off at the power source when steaming has stopped or when not in use. Failure
to switch off your vaporiser when it is no longer steaming may void any warranty claims. After power is switched
off, remove plug from socket. To continue use, refill with water as per instruction manual.
6. The vaporiser is emitting an unusual smell
Common cause: The vaporiser has been run dry (with no water for at least an hour). NOTE: If vaporiser is still
working, this will not affect the overall effectiveness of the unit.
Solution: Rinse water container. Fill with water to the maximum fill line. Insert two Cleaning Tablets. Run vaporiser
for 1 hour to allow cleaning tablets to clean the vaporiser. Empty water (NOTE: You may notice an orange colour
in the water, this is the sediment being cleaned from the unit). Empty unit and rinse again. The vaporiser should be
ready to use again.
This product has been produced with the greatest care
for normal, household use. Following directions carefully
will ensure dependable operation. If you experience
unsatisfactory operation or are dissatisfied with your
Euky Bear Warm Steam Vaporiser please contact our
friendly Customer Service team at FGB Natural Products.
Modification to the product by the consumer or failure to
follow the manufacturer's operating instructions will void
the warranty.
If repair is required under the warranty period, the product
should be returned with proof of purchase.
The purchaser assumes responsibility for the proper care
and use of the product in accordance with the printed
operating manual. The purchaser or user must make his
or her judgment as to when to use the product and the
length of use. Keep the operating manual available as it
is your guide to safe, efficient operation.
Our goods come with guarantees that cannot be excluded
under the Australian Consumer Law 2011. You are entitled
to a replacement of the faulty heating unit or refund for
a major failure.
For warranty claims please visit
www.eukybear.com.au/faulty-vaporiser
AUST L 297553 | Model No EBSV2013 | Patent No 634634 | 230-240V a.c. 50Hz, 200W
Felton Grimwade & Bosisto’s Pty. Ltd.
61-81 Clarinda Road (PO Box 74),
Oakleigh South, VIC 3167, Australia
Website: www.fgb.com.au
E-mail: mail@fgb.com.au
Free Call: 1800 655 841
5 Year Warranty
A12000
www.eukybear.com.au
Australian Owned
INSTRUCTION MANUAL
FOR USE & CARE
IMPORTANT: For safety
and warranty, please read
instructions carefully
before use.
Please keep
these instructions.
Suitable for all ages Year warranty
5
Humidifies all night
Euky Bear
Warm Steam Vaporiser
TM
For maximum benefits, use
with Euky Bear Inhalant and
Euky Bear Cleaning Tablets.
5 Place in a safe position
Position your vaporiser on the floor at least 1.2 meters away
from any person.
Ensure the room is well-ventilated so air is free to circulate
to prevent excess humidity (e.g. keep door slightly ajar).
Make sure the cord lies flat and out of the way.
For extra floor or carpet protection, place your vaporiser on a rubber mat or other heat
resistant, non-metallic barrier.
Do not place vaporiser on a table, chair or other piece of furniture
6 Plug into power point
Plug into power point and switch on power. Your vaporiser will produce steam within
3-4 minutes. Ensure you have sufficient water for each use.
7 Switch off after use
Always switch off your vaporiser at the power point after use, or as soon as it has
finished steaming. Failure to switch off your vaporiser when it is no longer steaming
may void any warranty claims.
After power is switched off, unplug your vaporiser from power point for cleaning.
Night light: The safety night light ensures your vaporiser is visible at all times, and will remain on as
long as there is power. This acts as a reminder for you to switch off the power after use.
8 Clean vaporiser
Cleaning your vaporiser is very important. To help keep your vaporiser clean and
germ-free, empty the water container and rinse after each use. Also rinse the base of the
unit (do not submerge power cords in water). Dry all parts thoroughly.
Do not use any cleaning products on vaporiser. Continue to use the Cleaning Tablets during
regular operation.
CAUTION: SAFETY INFORMATION
Euky Bear is safety conscious when designing and manufacturing consumer products. It is also
essential the product user exercises care when using an electrical appliance.
Listed below include important safety precautions, essential for the safe use of this appliance:
• Vaporiser produces hot steam which can scald. NEVER touch the steam outlet while unit is in use.
• Keep out of reach of children and ensure children cannot access the unit while in use.
• Do not overfill.
• Disconnect the power cord before filling, cleaning or moving.
• Turn off after steaming is complete. Do not operate the unit when removed from the vaporiser
water tank.
IMPORTANT: Ensure vaporiser is unplugged during set up.
1 Remove unit
Remove unit by gently twisting anti-clockwise. This will unlock
the unit and allow you to easily lift it out of the water container.
2 Add inhalant and cleaning tablets
First shake bottle, then add 2 capfuls into empty water Euky Bear Inhalant
container before filling with water, to ensure it is well mixed.
When using Euky Bear Cleaning Tablets, place one tablet
in the centre of the water container before filling with water.
It is recommended to use Cleaning Tablets when using your vaporiser
for the first time, as well as with every 3rd or 4th use to keep it running at
optimal condition. Cleaning Tablets are non-toxic and designed to be used during normal
operation. No separate cleaning cycle required.
NOTE: In areas with hard or mineralised water, use two Cleaning Tablets each time you use
your vaporiser. Do not add any other substances (ie. salt) to change the water quality.
The vaporiser will operate efficiently in all kinds of water.
3 Add water
Add water to container, up to the maximum fill line as indicated
on the sides of the water container. Do not overfill.
Rinse and refill with fresh water each time you use your vaporiser.
4 Re-insert unit
Re-insert unit, gently twisting clockwise to lock it into place.
Instructions

Specyfikacje produktu

Marka: Euky Bear
Kategoria: nieskategoryzowany
Model: Warm Steam Vaporiser

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Euky Bear Warm Steam Vaporiser, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Euky Bear

Euky Bear

Euky Bear Warm Steam Vaporiser Instrukcja

30 Maja 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Asko

Asko DBI644MIB.S.TW/1 Instrukcja

28 Października 2024
Asko

Asko DFS233IB.S.TW/1 Instrukcja

28 Października 2024
Emko

Emko EZM-9920 Instrukcja

27 Października 2024
Emko

Emko ESM-3712-H Instrukcja

27 Października 2024
Emko

Emko ATS-10 Instrukcja

27 Października 2024
Emko

Emko EAOM-11.2 Instrukcja

27 Października 2024
Emko

Emko EPM-3790 Instrukcja

27 Października 2024
Emko

Emko EPM-7790 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux IAN 108340 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux HG06009A-BS Instrukcja

27 Października 2024