Instrukcja obsługi Ecowater Comfort 400

Ecowater Filtr wody Comfort 400

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Ecowater Comfort 400 (56 stron) w kategorii Filtr wody. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/56
English Comfort Series Water Softener ............... 2
Español Ablandador de agua serie Comfort......... 8
Français Adoucisseur d’eau, série Comfort ........ 14
Italiano Addolcitore d’acqua serie Comfort....... 20
Deutsch Wasserenthärter der Comfort Serie ...... 26
Nederlands Comfort-serie waterontharder ............... 32
Polski Zmiękczacz wody serii Comfort ............ 38
Русский Умягчитель воды серии Comfort........ 44
Română Dedurizatorul de apă seria Comfort...... 50
7358030 (Rev. A 8/25/16)
EcoWater Systems Europe
www.ecowater-europe.com
2
INSTRUCTIONS
Comfort Series Water Softener
Models
Comfort 200
Comfort 300
Comfort 400
TABLE OF CONTENTS Page
Installation Requirements . . . . . . . . . . . . 2
Safety Guides . . . . . . . . . . . . . . . . . . . . . 2
Installation Illustrations . . . . . . . . . . . . . . . 3
Water Softener Programming . . . . . . . . 4-6
Adding Salt . . . . . . . . . . . . . . . . . . . . . . . . 7
Sanitizing . . . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting . . . . . . . . . . . . . . . . . . . . 7
EcoWater Systems Europe www.ecowater-europe.com=
A detailed manual can be obtained from your local dealer or from the EcoWater website in your country.
SAFETY GUIDES
=Before beginning installation, read the manual and obtain
tools and materials needed.
=The installation must conform to local plumbing and
electrical codes.
=Use only lead-free solder and flux for all sweat solder con-
nections.
=Handle the water softener with care. Do not turn upside
down, drop, or set on sharp protrusions.
=Do not locate the water softener:
where freezing temperatures may occur.-
in direct sunlight.-
where it may be exposed to wet weather.-
=Do not attempt to treat water over 49°C.
=The softener requires a minimum water flow of 11 liters per
minute at the inlet.
=Maximum allowable inlet water pressure is 8.6 bar. If daytime
pressure is over 5.5 bar, nighttime pressure may exceed the
maximum. Use a pressure reducing valve if necessary.
=This system works on 28 volt DC electrical power. Be sure to
use the included power supply and plug it into a nominal
220-240V, 50 Hz household outlet that is in a dry location
only, grounded and properly protected by an over current
device such as a circuit breaker or fuse.
=This system is not intended to be used for treating water that
is microbiologically unsafe or of unknown quality without ade-
quate disinfection before or after the system.
European Directive 2002/96/EC requires all electrical
and electronic equipment to be disposed of according
to Waste Electrical and Electronic Equipment
(WEEE) requirements. This directive or similar laws
are in place nationally and can vary from region to
region. Please refer to your state and local laws for
proper disposal of the equipment.
INSTALLATION REQUIREMENTS
=Installation should only be performed by a
trained professional.
=Make sure that the main water supply is shut
off before starting installation.
=Always install either an EcoWater Systems
bypass valve or a 3-valve bypass system.
Bypass valves allow you to turn off water to
the softener for repairs if needed, but still
have water in house pipes.
=A drain is needed for recharge discharge
water. A floor drain is preferred, close to the
EcoWater Systems water softener.
A laundry tub, standpipe, etc., are other
options.
=A 220-240V, 50 Hz, grounded, continuously
“liveelectrical outlet is needed, in a dry
location within 2 meters of the EcoWater
Systems softener.
=After completing installation of the system,
perform a pressure test to detect any leaks.
=After completing pressure test, perform a
manual recharge.
English
3
FIG. 1
TYPICAL INSTALLATION
FIG. 2B
4 cm
air gap
220-240V,
50 Hz
electrical outlet
floor drain
brine tank
overflow hose
(do not elevate)
valve drain hose
(do not elevate more
than 2.5 meters)
Tie or wire valve drain
hose in place to keep
over floor drain
NOTE: Faceplate and support not
shown for clarity of drawing
EcoWater Systems
bypass valve
WATER
SOFTENER
OUTLET
INLET
power supply
(included)
power cord
to controller
(2 m long)
HARD
WATER
SOFT
WATER
MAIN WATER PIPE
BYPASS OPTIONS
3-Valve Bypass
FIG. 2A
bypass
valve
outlet
valve
inlet
valve
from
softener
to
softener
=for SERVICE:
- open input and output valves
- close bypass valve
=for BYPASS:
- close input and output valves
- open bypass valve
INSTALLATION USING
THREADED BYPASS VALVE
Installation Illustrations
ECOWATER
S Y S T E M S English
EcoWater Systems
Bypass Valve
Pull OUT for
SERVICE
(normal operation)
Push IN for
BYPASS
Blend adjusting knob -
turn counterclockwise
to increase hardness
of treated water
Inlet
Outlet
Clips
Flexible
Hose
Bypass
Valve
FIG. 3A
Lubricated
O-ring
INSTALLATION USING
CLIP STYLE BYPASS VALVE
Inlet
Outlet
Clips
Flexible
Hose
Lubricated
O-ring
FIG. 3B
Clip
INSTALLATION USING
ADAPTOR ELBOWS
FIG. 3C
Bypass
Valve
Inlet
Outlet
Clips
Lubricated
O-ring
Adaptor
Elbows
Flexible
Hose


Specyfikacje produktu

Marka: Ecowater
Kategoria: Filtr wody
Model: Comfort 400

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Ecowater Comfort 400, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Filtr wody Ecowater

Instrukcje Filtr wody

Najnowsze instrukcje dla Filtr wody

Eden

Eden 521 Instrukcja

30 Grudnia 2025
Laica

Laica C3M Instrukcja

27 Grudnia 2024
Laica

Laica H0M Instrukcja

26 Grudnia 2024
Philips

Philips ADD6830 Instrukcja

20 Grudnia 2024
JANDY

JANDY CS100 Instrukcja

19 Grudnia 2024
JANDY

JANDY CS150 Instrukcja

19 Grudnia 2024
JANDY

JANDY CS250 Instrukcja

19 Grudnia 2024