Instrukcja obsługi DeLonghi PACEL92HP

DeLonghi klimatyzacja PACEL92HP

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla DeLonghi PACEL92HP (7 stron) w kategorii klimatyzacja. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/7

INTRODUCTION

Thank you for choosing a De’Longhi product. Please take a few

moments to read the instructions to avoid risks or damage to the

appliance.

DESCRIPTION

Description of the appliance (see page 2 - A)

A1 air outlet grille

A2 control panel

A3 handles

A4 castors

A5 silver ion lter

A6 air intake grille

A7 air exhaust hose housing

A8 air intake grille

A9 power cable

A10 drainage hose with cap

A11 remote control signal receiver

A12 remote control compartment

Description of the accessories (see page 2- B)

B1 wall ange with cap

B2 air exhaust hose

B3 hose adaptor

B4 adapter for window bracket

B5 window bracket with wing nut

B6 adapter for wall mounting/window outlet

B7 window outlet

B8 remote control

B9 window bracket cap

ELECTRICAL CONNECTION

Before plugging into the mains, check the following:

• the mains voltage is the same as that indicated on the plate

on the back of the appliance;

• the socket and electrical line are sized to support the load

required;

• the socket is the proper type for the plug, otherwise, re-

place the socket;

• the socket is connected to an ecient earthing system.

The manufacturer is not responsible in the event of non-

compliance with these injury prevention standards.

• The power cable must only be replaced by special-

ised technicians.

USE

The instructions below will enable you to prepare your air con-

ditioner for operation as eciently as possible. Before use, make

sure the air intake and outlet grilles are unobstructed.

Please note: This appliance is provided with an auto-evapora-

tion feature for condensate removal during cooling and dehu-

midifying modes.

AIR CONDITIONING WITHOUT INSTALLATION

CASEMENT WINDOW

If you have a casement window proceed as follows:

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Screw the window outlet (B7) and place outside the win -

dow to exhaust the hot air (g. 2).

DOUBLEHUNG WINDOW

If you have a double-hung window proceed as follows:

• Insert and lock the adapter for window bracket (B4) into

the slot of the window bracket (B5) (g.3)

• Place the window bracket in the window sill, and extend

the bracket fully within the window frame (g. 4).

• Fix the bracket by the wing nut (g. 5) (Should the window

bracket be too large for the window the plastic can be cut

with a saw by a qualied professional).

• Insert the air exhaust hose (B2) into the adapter for win-

dow bracket (B4) and rotate it as shown in g. 6.

• In order to facilitate the tting of the air exhaust hose (B2)

in the relevant housing located on the rear side of the appli-

ance, position the hose adapter ‘s tabs (B3) in a horizontal

axis as shown in g. 7 and proceed as shown in g.1.

SLIDING WINDOWS

• Thanks to the locking wing nut, it’s possible to use the win-

dow bracket also for sliding windows. Position the bracket

vetically with the hole in the lower part so to allow a correct

installation of the exhaust hose.

AIR CONDITIONING WITH INSTALLATION

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Drill a hole 150 mm in an outside wall or through a window

panel. Respect the distances, dimensions and heigh of the

hole given in gure 8.

ø 150mm

in the

window

panel

in the wooden

kickboard of a

French window

in the wall: you are

recommended to in-

sulate the section of

wall using suitable

insulation.

• Fit the wall ange (B1) into the hole.

• Fit the air exahaust hose (B2) into the wall ange (B1) (Fig.

• When the hose (B2) is not connected, the drilled hole can

be closed with the ange cap (B1).

Please note: As special tools are required for installation, we

suggest you have the appliance installed by specialized person-

nel.

• When installing the air conditioner, you should leave a door

slightly open little as 1 cm to guarantee correct ventilation

and room pressure.

• Keep the air hose as short and free of curves as possible to

avoid constrictions.

OPERATING FROM THE CONTROL PANEL

C1C2

C14

C11

C15

C10

C16

C13

C12

DESCRIPTION OF THE CONTROL PANEL (C)

C1 ON/STAND-BY (on/o) key

C2 Function selection key MODE (air conditioning, dehumidi-

fying, fan, heating)

C3 Decrease key

C4 Increase key

C5 Temperature indicator

C6 Timer indicator

C7 Timer symbol

C8 Air conditioning symbol

C9 Dehumidifyìng symbol

C10 Fan symbol

C11 Heating symbol (only in some models)

C12 Set temperature values, programmed on/o time

C13 Silent symbol

C14 Auto indicator

C15 Air ow indicators

C16 Alarm symbol

TURNING THE APPLIANCE ON/OFF

Before plugging the appliance check

the cap on back of the unit is correct-

ly inserted on drainage hose (A10).

Insert the plug in the socket.

Two dashes appear on the display

indicating that the appliance is in

stand-by.

Touch the (C1) key to turn on the

appliance.

When the appliance comes on, the

last function set before it was shut

o is activated.

Please note: After few seconds

of the control panel inactivity, its

brightness will be automatically re-

duced and in the next few minutes

it will be further reduced.

To turn the appliance o, touch the

(C1) key again.

Please note: Never turn o the air conditioner by simply pull-

ing the plug. Touch the (C1) key in order to put your air

conditioner in stand-by and wait a few minutes before pulling

the plug. In this way, the appliance can perform the operating

status checks.

MODES SELECTION

To select the desired operating

mode, touch repeatedly the MODE

key (C2) until the desired function

is selected.

Please note:The appliance may take a few minutes before start-

ing to cool, heat or dehumidify. Meanwhile, the indicator of the

selected mode ashes.

AIR CONDITIONING MODE

This is ideal for hot and humid weath-

er when the room needs to be both

cooled and dehumidied.

To correctly set this mode:

• Touch repeatedly the MODE key

(C2) until the air conditioning

symbol appears. The display will

show the desired temperature and

the AUTO fan speed.

. • To change the temperature to be

reached, touch the (C4) or (C3)

key.

Please note: The most suitable temperatures, during the sum-

mer range from 24 to 27°C. However, setting the temperature

signicantly lower than the outdoor temperature is not recom-

mended.

In conditioning mode, the air ow can be selected only from the

remote control.

DEHUMIDIFYING MODE

This is ideal for reducing humidity in

the room (spring and autumn, damp

rooms, rainy periods, etc). For this

type of use, the appliance must be

set up as for air conditioning mode.

That is, the air exhaust hose (B2)

must be tted to the appliance to allow the humidity to be dis-

charged outside.

To correctly set this mode:

• Touch repeatedly the MODE key (C2) until the dehumidify-

ing symbol appears.

• The appliance automatically chooses the best air ow.

HEATING MODE (ONLY IN SOME MODELS)

This is ideal in spring and autumn

when outdoor temperatures are not

particularly severe. For this mode,

the appliance should be prepared in

the same way as for air condition-

ing, with the air exhaust hose (B2)

attached.

To set this mode:

• Touch repeatedly the MODE button until the heating

symbol is displayed (C11).

• Touch the increase (C4) or decrease (C3) keys to adjust the

desired temperature.

Notes:

• In this mode, the air ow is selected automatically by the

appliance and cannot be set manually.

• When operating in very cold rooms, the appliance defree-

zes automatically, momentarily interrupting normal opera-

tion. In this case, “ Lt “ appears on the display. During this

operation, it is normal for the noise made by the appliance

to change.

• In this mode, you may have to wait a few minutes before

the appliance starts giving out hot air.

• It may happen that the display shows “HL” alarm. In this

case, empty the internal water tank following the instruc-

tions in the Section “End of Season operations”. After, press

again the button to restore the heating function.

FAN MODE

When using this mode, the air ex-

haust hose (B2) does not need to be

attached to the appliance.

To correctly set this mode:

• Touch repeatedly the MODE key until the fan symbol

appears.

• Select the desired air ow by touching the increase (C4)

or decrease (C3) key.

The air ows available are:

Minimum air ow: when most silent operation is

desired.

Medium air ow: when the noise level needs to

be low but with a good comfort level.

Maximum air ow: for maximum performance.

Specyfikacje produktu

Marka:	DeLonghi
Kategoria:	klimatyzacja
Model:	PACEL92HP

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z DeLonghi PACEL92HP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje klimatyzacja DeLonghi

DeLonghi Pinguino PAC L 35 Instrukcja

13 Stycznia 2025

DeLonghi Pinguino PACAN112SILENT Instrukcja

10 Stycznia 2025

DeLonghi PAC AN98ECO Real Feel Instrukcja

8 Października 2024

DeLonghi PACEL92HP Instrukcja

7 Października 2024

DeLonghi Pinguino Compact Arctic Whisper PACEM375WRC-6ALLG Instrukcja

6 Października 2024

DeLonghi Pinguino PACEX390UVCARE-6ALWH Instrukcja

6 Października 2024

DeLonghi Pinguino PACEX130ECOREALFEEL Instrukcja

6 Października 2024

DeLonghi Pinguino PAC ANK92 SILENT Instrukcja

2 Października 2024

DeLonghi Pinguino PAC T 40 Instrukcja

12 Września 2024

DeLonghi PAC WE128ECO Instrukcja

5 Września 2024

Instrukcje klimatyzacja

Najnowsze instrukcje dla klimatyzacja

Gree CE52-24/F(C) Instrukcja

15 Stycznia 2025

Maxicool SGL 18COC Instrukcja

15 Stycznia 2025

Frigidaire FAA082P7A Instrukcja

15 Stycznia 2025

Daikin RXM50A5V1B8 Instrukcja

15 Stycznia 2025

Daikin RXP50N5V1B8 Instrukcja

15 Stycznia 2025

Ausclimate Smart Compact Cold + Dry ACPAC205CB Instrukcja

14 Stycznia 2025

Haier HSU-12HIPEQW01 Instrukcja

14 Stycznia 2025

Haier HSU-18HIPEQW01 Instrukcja

14 Stycznia 2025

Haier HSU-24HIPEQW02 Instrukcja

14 Stycznia 2025

GE AGM06LA Instrukcja

13 Stycznia 2025