Instrukcja obsługi Dell PowerEdge 2100

Dell serwer PowerEdge 2100

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dell PowerEdge 2100 (34 stron) w kategorii serwer. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/34
Throughout this guide, blocks of text may be accompanied by an icon and printed in
bold type or in italic type. These blocks are notes, notices, cautions, and warnings,
and they are used as follows:
NOTE: A NOTE indicates important information that helps you make better use of
your computer system.
____________________
Information in this document is subject to change without notice.
© 1999–2000 Dell Computer Corporation. All rights reserved.
Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of
Dell Computer Corporation. Other trademarks and trade names may be used in this document
to refer to either the entitie their products. Dell Computers claiming the marks and names or
Corporation disclaims any proprietary interest in trademarks and trade names other than its own.
April 2000 P/N 4095D Rev. A05
support.dell.com Dell PowerEdge 2100 and 2200 LVD Hard-Disk Drive Installation 1-1
This document explains how to install the terminated low-voltage differential (LVD)
small computer system interface (SCSI) cables and LVD hard-disk drives into a
computer system that contains Ultra/Wide SCSI devices. The term LVD encompasses
the same technology for Ultra 2 and Ultra 3 (U160) hard-disk drives.
NOTE: Single-ended devices on the SCSI bus, such as Ultra/Wide devices, cause the
SCSI bus to run at the slower Ultra SCSI speeds instead of the faster LVD SCSI
speeds.
If you are adding LVD hard-disk drives, replacing Ultra/Wide hard-disk drives with LVD
hard-disk drives, or both, perform the appropriate steps for your system as follows.
NOTE: Be sure to read all of the installation instructions before you begin the
procedures.
If your system already has only LVD hard-disk drives and terminated LVD cables
installed, you do not need to perform the steps in this document.
If your system does not have a redundant array of independent disks (RAID)
controller or an Adaptec 2940UW SCSI controller installed, perform the steps in
“Replacing the SCSI Cable in a System Without a RAID Controller or an
Adaptec 2940UW SCSI Controller” in the next section.
If your system does have a RAID controller or an Adaptec 2940UW SCSI
controller installed, perform the steps in “Replacing the SCSI Cable in a
System With a RAID Controller or an Adaptec 2940UW SCSI Controller”
later in this document.


Specyfikacje produktu

Marka: Dell
Kategoria: serwer
Model: PowerEdge 2100

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Dell PowerEdge 2100, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje serwer Dell

Instrukcje serwer

Najnowsze instrukcje dla serwer