Instrukcja obsługi Clarion XN3410
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Clarion XN3410 (19 stron) w kategorii UKF. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/19
Owner’s manual & Installation manual
Mode d’emploi et manuel d’installation
Manual de instrucciones y de instalación
XN AMPLIFIERS
AMPLIFICATEURS XN
AMPLIFICADORES XN
XN 3210
XN 3410
XN3210/XN3410 3
English
Owner’s Manual
INTRODUCTION
The Clarion XN3210 is a full-featured, two-channel amplifier incorporating the
following features:
• Specially coated circuit boards that resists mold, mildew and moisture damage.
• Pulse-Width Modulated (PWM) MOSFET power supply for maximum
performance with minimal distortion.
• Remote turn-on with "soft start" muting to prevent turn-on "thump".
• Variable high-pass/low-pass electronic crossover with a 12dB per octave
slope (adjustable range: 55Hz to 5.5kHz).
• Variable bass boost circuit to reinforce low frequency signals that may be lost
due to subwoofer enclosure design.
• Adjustable input level controls with ground loop isolation to minimize noise
and distortion.
• 2-ohm stereo stable, 4-ohm mono stable.
• Chrome-plated power, speaker and RCA connections.
• Speaker level input.
• Low profile construction with aluminum heat sink for efficient heat dissipation.
The Clarion XN3410 is a full featured, four-channel amplifier adding the following
feature:
• Advanced circuitry design featuring bridgeable and mixed mode operation for
use in various system configurations including 4, 3, or 2 channel systems.
ABOUT THE MANUAL AND WARRANTY
This manual describes the basic requirements to install the Clarion XN3210 and
XN3410 amplifiers. The installation of this amplifier can be quite complex to install.
If you do not posses the necessary knowledge and tools to perform this installation,
please contact your local Clarion Marine Audio dealer.
Keep all instructions and sales receipt for future reference and warranty information.
Warranty information can be found on page 19 of this manual.
TABLE OF CONTENTS
Description ............................................... 4
Input Connections and Audio Controls . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Connections for Power and Speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installation ................................................ 8
Mounting Precautions ....................................... 8
Wiring Precautions ......................................... 8
XN3410 Wiring and Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
XN3210 Wiring and Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Setting the Gain ........................................... 17
Setting the Crossover ....................................... 17
Setting the Subwoofer Bass Boost . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Final System Check ........................................ 18
Troubleshooting ............................................ 18
Product Specs ............................................. 19
4 XN3210/XN3410
English
Owner’s Manual
DESCRIPTION
The XN3210 and XN3410 use an unregulated MOSFET power supply for supe-
rior sound and output wattage. In addition, a toroid-coil is used to transfer power
with minimal performance loss due to heat. To avoid unwanted noise, a double-
sided conformal printed circuit board with strategically placed components keeps
AM RFI subdued.
All of the connections and controls for the XN3210 and XN3410 are conveniently
located at the ends of the amplifier and labeled appropriately. To ensure the best
possible electrical connections, the power, speaker, and RCA inputs are gold-
plated. An additional benefit of the XN3410 is the ability to create a 2, 3, or 4
channel amplified system with a flip of a switch (see Application section). In the
event of component failure or a short circuit, the XN3210 and XN3410 incorpo-
rate safe guards and outboard ATC fuses to prevent damage to the amplifier.
INPUT CONNECTIONS AND AUDIO CONTROLS
The front panel of the XN3410 and XN3210 contain both connections for RCA
and speaker level inputs, along with the audio controls as shown below.
Fig. 1
XN3410
1. CH1-CH2 High Input
2. CH1/CH2 RCA Input
3. CH3/CH4 RCA Input
4. CH1/CH2 Gain Control
5. CH3/4 Gain Control
6. Bass Boost
7. Source Select
8. CH1/2 Mode Switch
9. CH3/4 Mode Switch
10. CH3-CH4 High Input
11. CH1/2 Frequency Control
12. CH1/2 Crossover Mode Switch
13. CH3/4 Frequency Control
14. Frequency Range Multiplier
15. CH3/4 Crossover Mode Switch
16. Power Light Indicator
11011 12 13 14 15
CH1-CH2
HIGH INPUT
2-CH-IN
CH2 CH4
CH1 CH3 CH1/2 CH1/2INPUT
2CH
CH1/2
MONO
CH1
MONOST EREO
2CH
BAS S
CH2
MONO
CH3/4
MONO
ST EREO4CH
CH3/4
CH3/4CH1/2
GAIN
CH 1/2 FREQ Hz RANGE CH 3/4
X-OVER
CH 3/4
FREQ Hz
CH 1/2
X-OVER
0
dB
15
MAX
MIN
MAX
MIN
BASS
BOOST
SOURCE
SELECT
MODE
POWER
CH3-CH4
HIGH INPUT
55
550
110
240
330
55
550
110
240
330
+ CH1
– CH1
+ CH2
– CH2
GND
CH3 +
CH3 –
CH4 +
CH4 –
GND
LPF
X1
X10
HPF OFF LPF HPF OFF
2 3 4 5 6 7 8 9 16
Specyfikacje produktu
| Marka: | Clarion |
| Kategoria: | UKF |
| Model: | XN3410 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Clarion XN3410, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje UKF Clarion
21 Września 2024
16 Września 2024
13 Września 2024
13 Września 2024
9 Września 2024
Instrukcje UKF
- UKF Garmin
- UKF Dual
- UKF Scosche
- UKF Cobra
- UKF Oricom
- UKF Fusion
- UKF Midland
- UKF American International
- UKF Rockford Fosgate
- UKF Wet Sounds
Najnowsze instrukcje dla UKF
29 Września 2024
25 Września 2024
20 Września 2024
17 Września 2024
14 Września 2024
14 Września 2024
1 Września 2024
20 Sierpnia 2024
17 Sierpnia 2024
6 Lipca 2024