Instrukcja obsługi Chief SSM155
Chief
Projector accessoire
SSM155
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief SSM155 (1 stron) w kategorii Projector accessoire. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000138 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-155, SSM-155, SLB-155 and SLM-155 Interface Brackets
SSB-155, SSM-155, SLB-155 and SLM-155 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT overtighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the .25" nylon spacer over the front threaded insert, and two .1875" nylon spacers over the two remaining mounting holes in the
projector.
4. Place the interface bracket onto the nylon spacers in the bottom of the projector and align the holes in the bracket with the threaded inserts
in the bottom of the projector.
5. Using the M4 x 12mm pan head mounting screws and M4 flat washers, position screws and washers into the center and rear mounting
holes, and position the M4 x 12mm countersink screw into the front center mounting hole. Tighten all fasteners at this time, securing the
bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (2) Spacer, Nylon, .5 x .218 x .25"
(4) 10-24 Thumb Nuts ** (2) Screw, Pan head, M4 x 12mm
(1) All-Points Security Kit (2) Washer, Flat, M4
(1) Screw, M4 x12mm Countersink (1) Spacer, Nylon, .5 x .258 x .1875"
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-
style interface bracket installation.
SLB-155 SLM-155
Towards front of
projector Towards front of
projector
(Note: SSM-style interface bracket connection
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
Specyfikacje produktu
Marka: | Chief |
Kategoria: | Projector accessoire |
Model: | SSM155 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Chief SSM155, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Projector accessoire Chief
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
Instrukcje Projector accessoire
- Projector accessoire Viewsonic
- Projector accessoire Casio
- Projector accessoire Sanus
- Projector accessoire Chipolino
- Projector accessoire NEC
- Projector accessoire Sanyo
- Projector accessoire Vogel's
- Projector accessoire Barco
- Projector accessoire Gabor
- Projector accessoire Kanto
- Projector accessoire Da-Lite
- Projector accessoire AV:link
- Projector accessoire InFocus
- Projector accessoire Projecta
- Projector accessoire Tempest
Najnowsze instrukcje dla Projector accessoire
19 Września 2024
14 Września 2024
14 Września 2024
14 Września 2024
13 Września 2024
9 Września 2024
7 Września 2024
6 Września 2024
6 Września 2024
6 Września 2024