Instrukcja obsługi Chamberlain KLIK2C-P2

Chamberlain nieskategoryzowany KLIK2C-P2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chamberlain KLIK2C-P2 (27 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/27
Universal Wireless Keypad
MODELS KLIK2U, KLIK2U-P2, KLIK2C AND KLIK2C-P2
Introduction . . . . . . . . . . . . . 2
Programming . . . . . . . . . . . 3-7
Installation . . . . . . . . . . . . . . 8
Changing your 4-digit PIN . . . 8
Battery . . . . . . . . . . . . . . . . . 8
FAQs . . . . . . . . . . . . . . . . . . 9
2
To prevent possible SERIOUS INJURY or DEATH from a moving gate or
garage door:
• Install keypad within sight of garage door, out of reach of small children at
a minimum height of 5 feet (1.5 m) above floors, landings, steps or any
other adjacent walking surface, and away from ALL moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit
children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER
permit anyone to cross path of moving gate or door.
Introduction
Thank you for your purchase of the Universal Wireless Keypad.
PLEASE DO NOT RETURN TO THE RETAIL STORE. If for any reason you have
questions or need help with troubleshooting please call: 1-800-442-1255.
Read instructions thoroughly BEFORE beginning. If using this product
with residential door openers, this product must be used only with
door openers manufactured after 1993 that utilize photoelectric
sensors. The photoelectric sensors are always located on or near the
bottom of the door track.
DETERMINE GARAGE DOOR OPENER TYPES:
Proceed with instructions according to your garage door opener type. NOTE: Your motor unit and/or remote control may look different.
TYPE 4
Chamberlain, Sears
Craftsman, LiftMaster, Master
Mechanic, Do It, Genie
Intellicode, Overhead Door,
Stanley, Wayne Dalton or
Linear garage door openers
with: Smart/Learn button.
TYPE 5
Genie Intellicode 2 garage
door openers with: Program/
Set button.
BEFORE STARTING:
You MUST have a Genie
IntelliCode 2 remote control
with at least one button
already programmed to the
opener.
TYPE 2
Genie, Linear and Moore-O-
Matic garage door openers or
receivers with: 2 position DIP
switches.
ON
ON
Opener
Opener
TYPE 1
Chamberlain, Sears
Craftsman, LiftMaster,
Master Mechanic and Do It
garage door openers or
receivers with: 3 position
DIP switches.
Opener
Remote Control
Opener
Remote Control
TYPE 3
Chamberlain, Sears
Craftsman, LiftMaster, Master
Mechanic and Do It garage
door openers or receivers
with: Yellow, white or grey
Smart/Learn buttons.
Opener
Remote Control
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer or
birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
STOP
3
TYPE 1
Chamberlain, Sears Craftsman, LiftMaster,
Master Mechanic and Do It garage door
openers or receivers with: 3 position
DIP switches.
If opener does not function, repeat programming.
Select and write a 4-digit PIN:
__ __ __ __
Determine your opener ID using the list below.
The first DIP switch must be set to the “-” position on your remote and
opener. Record your DIP switch sequence for remaining DIP switches. If
the DIP switch is in the “+” position place a 1, “0” position place a 2, “-”
position place a 3 in the corresponding box in the chart below:
NOTE: Leave any unused switch locations blank.
Enter .
PIN from step 1, press #
Enter .ID from step 2, press #
Enter DIP switch sequence from step
3 and press # key.
To test and use, wait until
lights turn off, enter your PIN
and press the 0 key.
1
Programming
2
3
5
6
7
8
DIP Switch
Sequence 1 2 3 4 5 6 7 8 9
+
0
-3
Press and hold the buttons until keypad *and #
stops flashing.
4
Opener
Remote Control
ID DIP Switch Type
11 9 DIP switch garage door openers (U.S.)
12 9 DIP switch garage door openers (Canada)
15 8 DIP switch garage door openers
19 7 DIP switch garage door openers

Specyfikacje produktu

Marka: Chamberlain
Kategoria: nieskategoryzowany
Model: KLIK2C-P2

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Chamberlain KLIK2C-P2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Chamberlain

Chamberlain

Chamberlain MYQLED2 Instrukcja

21 Września 2024
Chamberlain

Chamberlain KLIK2C-P2 Instrukcja

26 Maja 2024
Chamberlain

Chamberlain 7710CB-P Instrukcja

21 Maja 2024
Chamberlain

Chamberlain T3EML Instrukcja

19 Maja 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Meec Tools

Meec Tools 010-084 Instrukcja

6 Października 2024
Outwell

Outwell Scenic Road 250 Instrukcja

5 Października 2024
Impact

Impact Qualite QL-3560-LED Instrukcja

4 Października 2024
Impact

Impact QuikBalance Instrukcja

4 Października 2024
Impact

Impact CA-112 Instrukcja

4 Października 2024
Impact

Impact Forever Ready Cool FRC-24-LED Instrukcja

4 Października 2024
Impact

Impact LS-BHA Instrukcja

4 Października 2024
Impact

Impact LKB-5C Instrukcja

4 Października 2024
Impact

Impact Varipole Drop Ceiling Adapter Instrukcja

4 Października 2024
Impact

Impact RST-001 Instrukcja

4 Października 2024