Instrukcja obsługi Alula RE218


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Alula RE218 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/2
Flood and Temp Sensor is an integrated environmental
sensor. It detects ood conditions and reports extreme
temperatures.
Features
Titanium probes for unmatched corrosion immunity
IP67 rated waterproof enclosure
GORE
®
vent to prevent seal failure
5 year warranty
Enroll by placing the panel into wireless enrollment mode and
removing the battery tabs, tampering the sensor, or manually
entering the sensor ID.
Loop Conguration
Loop 1 = Freeze
Loop 2 = Heat
Loop 3 = Flood
Install by placing the sensor in the location requiring ood or
temperature detection. If desired, the wall clip can be used to
secure the sensor.
Optional Screw Mounting
Remove the wall clip from the sensor’s body.
Secure the clip to a wall, baseboard or cupboard
using a #6 screw.
Slide the sensor’s body down onto the wall clip
until it snaps into place.
Detects water pooled under the sensor and reports extreme
temperature conditions.
Temperature Trip Points
Heat alarms when over 100°F (38°C)
Heat restores when under 97°F (36°C)
Freeze alarms when under 45°F (7°C)
Freeze restores when over 48°F (9°C)
To replace the batteries, insert a at blade screwdriver into
the front slot and twist. Slide both old batteries out and the
new batteries in. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
I
N
S
T
A
L
L
G
U
I
D
E
I
Verify proper enrollment and operation using your control panel’s installation manual.
Front slot
Mounting Screw Hole
Wall Clip
RE218 Flood & Temp Sensor
Honeywell® Compatible
Resolution Compatibles
Pro Tips
The cover can be removed without removing the wall clip.
Both titanium probes must be in the same puddle for the sensor to detect water.
Tamper detection depends on how the sensor is installed.
Sensor secured to wall: Tamper is indicated when lifted off the clip.
Sensor NOT secured to wall: Tamper is indicated when the cover is removed.
When changing the batteries replace both with new batteries.
Automatic enrollment signals are sent for loop 3 (Flood) when the battery tabs are
removed.
Specications
Physical
Housing Dimensions
Weight with Batteries
Mounting Fastener
2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3.0 cm)
1.34 ounces (38 grams)
#6 screw (not provided)
Environmental
Operating Temperature
Maximum Humidity
Water Resistance
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
IP67 rated (Waterproof for over 30 minutes at 1 meter depth)
Sensor Specications
Frequency
Replacement Batteries
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
Temperature Accuracy
345 MHz
Two Panasonic CR2032
10 years
3.0 VDC (Nominal) 2.3 VDC (Low)
20 mA (Maximum) 0.5 uA (Quiescent)
Cover Tamper, Wall Tamper, Low Battery, Supervision
+/- 2°C
Certication
RE218 FCC, IC
Specications subject to change without notice.
47-0028-02 • REV C • 2018-03-28
Tech Support Line • (888) 88-ALULA • (888) 882-5852
alula.net
WARRANTY
Alula will replace all non-portable products that are defective in
their rst ve (5) years, and all portable products that are defective
in their rst two (2) years.
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-RE218
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by Alula could void
the user’s authority to operate this equipment.
FCC ID: U5X-RE218
TRADEMARKS
Alula is a trademark owned by Alula Holdings, LLC.
“Honeywell” is a trademark owned by Honeywell International, Inc.
Alula products will function with Honeywell systems. However, no
Alula product is produced by, endorsed by, or ofcially associated
with Honeywell. Alula recommends verifying proper enrollment and
operation, per control panel installation instructions, at installation.


Specyfikacje produktu

Marka: Alula
Kategoria: Niesklasyfikowane
Model: RE218

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Alula RE218, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane Alula

Alula

Alula RE118 Instrukcja

1 Października 2024
Alula

Alula RE605 Instrukcja

1 Października 2024
Alula

Alula RE619 Instrukcja

1 Października 2024
Alula

Alula RE305 Instrukcja

1 Października 2024
Alula

Alula RE219 Instrukcja

1 Października 2024
Alula

Alula RE318 Instrukcja

1 Października 2024
Alula

Alula RE105 Instrukcja

1 Października 2024
Alula

Alula RE205 Instrukcja

1 Października 2024
Alula

Alula RE218 Instrukcja

1 Października 2024
Alula

Alula RE119 Instrukcja

1 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024