Instrukcja obsługi Alpine PXE-H650
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Alpine PXE-H650 (28 stron) w kategorii edytor. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/28
PXE-H650
Audio Processor
OWNER’S MANUAL
Caution
• Read this manual thoroughly before starting installation and operation. You will fi nd a number of Safety Warnings in this
manual to tell you about things that could hurt you or other people if you were to ignore the Warnings. We cannot be
responsible for problems resulting from failure to observe the Warnings in this manual.
• This manual uses a symbol to show how to use this product safely and to avoid harm to yourself and others and
damage to your property. Here is what this symbol means. Understanding it is important for reading the Manual.
• Meaning of Symbol:
DO NOT DISASSEMBLE OR ALTER
Attempts to disassemble or alter this product can lead to accidental fi res or electrical shock.
KEEP SMALL ARTICLES OUT OF THE REACH OF CHILDREN
Keep small articles (wire-ties, etc.) out of reach of children. If swallowed, consult a physician immediately.
USE ONLY IN CARS WITH A 12 VOLT NEGATIVE GROUND
Use only in cars with a 12 volt negative (–) ground electrical system. (Check with your dealer if you are not sure.) Failure to
do so may result in fi re, etc.
BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Before doing any electrical wiring, disconnect the cable from the negative (–) terminal of the battery. Failure to do so may
result in electric shock or injury due to electrical shorts.
KEEP ELECTRICAL CABLES TOGETHER TO AVOID OPERATING HAZARDS
Dress the wiring to keep them from interfering with the operation of the steering wheel, gear lever, brake pedals, etc.
DO NOT CUT AWAY INSULATION FROM ANY WIRE TO POWER OTHER EQUIPMENT
Tapping power from wiring to supply voltage to another piece of equipment could exceed the current carrying capacity of
that wire. This could result in fi re or electric shock.
DO NOT INSTALL IN LOCATIONS WHICH MIGHT HINDER VEHICLE OPERATION
Do not install in locations which might create hazards for the vehicle occupants or hinder vehicle operation (such as the
steering wheel or gear shift) by obstructing forward vision or hampering movement etc.
DO NOT DAMAGE PIPES OR WIRING WHEN DRILLING HOLES
When drilling holes in the chassis for installation, take precautions so as not to contact, damage or obstruct pipes, tanks or
electrical wiring. Failure to take such precautions may result in fi re.
DO NOT USE NUTS OR BOLTS IN THE BRAKE SYSTEM FOR INSTALLATION OR GROUND CONNECTIONS
Never use safety-related parts such as bolts or nuts in the steering or brake systems or tanks to make wiring installations
or ground connections. Using such parts could disable control of the vehicle and cause fi re etc.
HALT USE IMMEDIATELY IF A PROBLEM APPEARS
When problems appear, stop using the system immediately and contact the dealer from whom you purchased the
equipment. Some problems which may warrant immediate attention include a lack of sound, noxious odors or smoke
being emitted from the unit, or foreign objects dropped inside the unit.
DO NOT OPERATE THE EQUIPMENT OR LOOK AT THE SCREEN WHILE DRIVING
Do not change settings while driving. If operation requiring a prolonged view of the display is required, stop the vehicle in a
safe location before attempting operation.
HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS
The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the
dealer where you purchased this unit to have the work done.
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST
Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit
may cause smoke or fi re.
MAKE THE CORRECT CONNECTIONS
Failure to make the correct connections can cause fi re or accident to occur.
ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED
Route the cables and wiring so as not to be crimped by moving parts like seat rails or to make contact with sharp spots
which could damage the wiring.
DO NOT RAISE THE VOLUME EXCESSIVELY
Keep the volume at a level where you can still hear outside noises while driving. Driving while unable to hear outside
sounds could cause an accident.
WARNING This symbol means there is something that could cause serious injury or
death to you or other people.
WARNING It is dangerous and illegal for a driver to watch the Video/TV while
driving any vehicle. The driver may be distracted from looking ahead
and an accident could occur.
Temperature
Be sure the temperature inside the vehicle is between +60°C (+140°F) and –10°C (+14°F) before
turning your unit on.
Fuse Replacement
When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse
holder. If the fuse(s) blows more than once, carefully check all electrical connections for shorted
circuitry. Also have your vehicle’s voltage regulator checked.
Maintenance
If you have problems, do not attempt to repair the unit yourself. Return it to your Alpine dealer or
the nearest Alpine Service Station for servicing.
Installation Location
Make sure the PXE-H650 will not be exposed to:
• Direct sun and heat
• High humidity
• Excessive dust
• Excessive vibrations
PRECAUTIONS This symbol means important instructions. Failure to heed them can
result in injury or material property damage.
Specyfikacje produktu
| Marka: | Alpine |
| Kategoria: | edytor |
| Model: | PXE-H650 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Alpine PXE-H650, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje edytor Alpine
4 Września 2024
Instrukcje edytor
- edytor Hikvision
- edytor Roland
- edytor Bose
- edytor Asus
- edytor Allen & Heath
- edytor HP
- edytor Heritage Audio
- edytor Shure
- edytor Datapath
- edytor Zoom
- edytor TC Helicon
- edytor Vivolink
- edytor Eventide
- edytor DBX
- edytor Lindell Audio
- edytor Smart-AVI
- edytor Ashly
- edytor Gefen
- edytor SEADA
- edytor Radial Engineering
- edytor Lectrosonics
- edytor Neutrik
- edytor SPL
- edytor RGBlink
- edytor Rupert Neve Designs
- edytor Dangerous Music
- edytor Matrox
- edytor Intel
- edytor Fredenstein
- edytor Golden Age Project
- edytor Sonifex
- edytor Solid State Logic
- edytor Mathew Lane
- edytor Warm Audio
- edytor Drawmer
- edytor SIIG
- edytor Manley
- edytor MuxLab
- edytor Helix
- edytor Christie
- edytor Rane
- edytor AMD
- edytor Lexicon
- edytor Empirical Labs
- edytor AudioThing
- edytor Avenview
- edytor FabFilter
- edytor Metric Halo
- edytor Henry Engineering
- edytor MyMix
Najnowsze instrukcje dla edytor
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024