Instrukcja obsługi Yamaha NS-777

Yamaha Speaker NS-777

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Yamaha NS-777 (40 stron) w kategorii Speaker. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/40
1
English
Thank you for selecting a YAMAHA speaker system.
Read these precautions carefully before using your
speakers.
To assure the finest performance, please read this
manual carefully. Keep it in a safe place for future
reference.
Install the speaker in a cool, dry, clean place - away from
windows, heat sources, sources of excessive vibration,
dust, moisture and cold. Avoid sources of humming
(transformers, motors). To prevent fire or electrical
shock, do not expose the speaker to rain or water.
To prevent the enclosure from warping or discoloring,
do not place the speaker where it will be exposed to
direct sunlight or excessive humidity.
Do not place the following objects on the speaker:
Glass, china, small metallic, etc.
If glass etc. falls by vibrations and breaks, it may
cause bodily injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and
bodily injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may
cause damage to the speaker, and/or you may get an
electric shock.
Do not place the speaker where foreign objects such as
water drips might fall. It might cause a fire, damage to
the speaker, and/or bodily injury.
Do not place the speaker where it is liable to be knocked
over or struck by falling objects. Stable placement will
also ensure better sound performance.
Placing the speaker on the same shelf or rack as the
turntable can result in feedback.
Never put a hand or a foreign object into the port located
on the rear of the speaker as this might cause bodily
injury and/or damage to the speaker.
When moving the speaker, do not hold the port as it
might cause bodily injury and/or damage to the speaker.
Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speaker may be damaged.
When using an amplifier with a rated output power
higher than the nominal input power of the speaker, care
should be taken never to exceed the speaker’s maximum
input.
Do not attempt to clean the speaker with chemical
solvents as this might damage the finish. Use a clean, dry
cloth.
Do not attempt to modify or fix the speaker. Contact
qualified YAMAHA service personnel when any service
is needed. The cabinet should never be opened for any
reasons.
Secure placement or installation is the owner’s
responsibility. YAMAHA shall not be liable for any
accident caused by improper placement or
installation of speaker.
The speaker is constructed with the majority of the weight
located in its upper portion, and is thus susceptible to
falling over if proper care is not taken to insure its stability.
If the speaker falls over, it may damage the speaker or be
the cause of injury (or even death) to persons and/or
damage to personal property.
For safe and proper use of the speaker:
Position the speaker in a location that is solid, level,
smooth, and low (with respect to the floor).
Do not push or apply pressure to the side of the speaker
when moving, or lean objects against the side of the
speaker.
Do not sit on or set objects on top of the speaker.
Vibrations or jolts associated with earthquakes and other
phenomena or activities may cause the speaker to fall over.
For safety reasons, using commercially available products
that increase stability in the speaker is recommended
(metal fittings or chains, etc.).
Use the stands included with the speaker to
increase stability:
Be sure to use the stands regardless of where the speaker is
positioned. Attaching the stands included with the speaker
reinforces the base of the speaker not to fall over.
Please be cautioned that even though the stands are
connected, this does not guarantee that the speaker will not
fall over.
NS-777/NS-555 Speaker System
OWNER’S MANUAL
PRECAUTIONS
PRECAUTIONS WHEN
POSITIONING THE SPEAKERS
2
.
When placing the speakers, be sure to use the stands to
increase stability.
Note
The provided stands are in two types. Two stands are for the right
side and others are for the left side. Attach each stand to the proper
position on the bottom of the speaker by following the figure
below.
Use the 8 specified holes located on the base of the speaker.
Procedure:
1First, put the screw through the washer, then through
the inner hole of the stand, and screw it into the outside
hole of the speaker. Do not tighten too much at this
point.
2Put a screw through the outer hole on the stand, and
screw it into the other hole on the base of the speaker.
3Tighten both of the screws firmly.
4Attach a pad to the bottom of the end portion of the
stand.
5Attach the other stands to the other corners of the base
of the speaker in the same way and confirm that all 4
stands have been firmly attached.
Note
Be carefull not to apply force to the side of the speaker, otherwise
the speaker may fall causing damage to the speaker or personal
injury.
ATTACHING THE STANDS
(L) (R)
Stand (R x 2, L x 2)
Pad x 4 Washer x 4 Screw
(25mm) x 8
Back
(L)
(R)
(R)
(L)
Front
View from the bottom of the speaker
Outer hole
Inner hole
3
English
This speaker system is capable of standard connections and bi-wired connections. Before
making connections, make sure that the amplifier is switched off.
[Standard Connection]
°
°
°
°° CONNECTIONS
Connect the screw-type input terminals at the rear of the
speaker to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
Connect the (+) terminals on the amplifier (or receiver)
and the speaker using one side of the cable. Connect the
(–) terminals on both components using the other side of
the cable.
Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity (+,
–). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to Connect:
1Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
2Loosen the terminal knob.
3Insert the bare wire.
4Tighten the knob and secure the cable. Test the
firmness of the connection by pulling lightly on the
cable at the terminal.
Note
Do not let the bare speaker wires touch each other to avoid
damaging the speaker or the amplifier, or both of them.
Using a Banana Plug
1Tighten the terminal knob.
2Simply insert the banana plug into the terminal.
CONNECTIONS TO YOUR AMPLIFIER
SPEAKERS
A
B
LR
++
+
Amplifier or
Receiver
Tighten
Loosen
Leave the short bars
in place when
connecting.
NS-777/NS-555 (R)
Speaker output
terminals of the
amplifier
Short bar
NS-777/NS-555 (L)
Good No Good
Banana Plug

Specyfikacje produktu

Marka: Yamaha
Kategoria: Speaker
Model: NS-777

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Yamaha NS-777, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Speaker Yamaha

Yamaha

Yamaha YST-SW215 Instrukcja

4 Października 2024
Yamaha

Yamaha NS-F71 Instrukcja

4 Października 2024
Yamaha

Yamaha NS-B150 Instrukcja

1 Października 2024
Yamaha

Yamaha DHR12M Instrukcja

11 Września 2024
Yamaha

Yamaha C215V Instrukcja

2 Września 2024
Yamaha

Yamaha NS-777 Instrukcja

30 Sierpnia 2024
Yamaha

Yamaha VSX8 Instrukcja

29 Sierpnia 2024
Yamaha

Yamaha S15W Instrukcja

27 Sierpnia 2024
Yamaha

Yamaha NS-F330 Instrukcja

23 Sierpnia 2024
Yamaha

Yamaha NS-AW350 Instrukcja

22 Sierpnia 2024

Instrukcje Speaker

Najnowsze instrukcje dla Speaker

Sonoro

Sonoro Escape P6 Air Instrukcja

4 Października 2024
Audison

Audison Prima AP 4 Instrukcja

4 Października 2024
ION

ION Sport Boom Instrukcja

4 Października 2024
Phoenix Gold

Phoenix Gold ZDSV4C Instrukcja

4 Października 2024
Phoenix Gold

Phoenix Gold ZX65C Instrukcja

4 Października 2024
Phoenix Gold

Phoenix Gold ZX35C Instrukcja

4 Października 2024
Dynaudio

Dynaudio Core 59 Instrukcja

4 Października 2024
Phoenix Gold

Phoenix Gold ZPX654 Instrukcja

4 Października 2024