Instrukcja obsługi Yamaha DA824

Yamaha Konwerter audio/wideo DA824

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Yamaha DA824 (19 stron) w kategorii Konwerter audio/wideo. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/19
DA CONVERTER
Owner’s Manual
E
ON OFF
POWER
DA CO NVERTER
LOCKPEAK
SIGNAL
NOMINAL
PEAK
SIGNAL
NOMINAL
1 2 3 4 5 6 7 8
Keep This Manual For Future Reference.
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST
be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all
installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the
problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on
different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in
is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service
Division, 6600 Orangethorpe Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
WARNING: THIS APPARATUS MUST BE EARTHED
IMPORTANT
THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must be
connected to the terminal in the plug which is marked by the letter E
or by the safety earth symbol or coloured GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured RED.
* This applies only to products distributed by YAMAHA KEMBLE
MUSIC (U.K.) LTD.
i
DA824—Owner’s Manual
Important Information
Please read before operating the DA824
Warnings
• Do not subject the DA824 to extreme temperatures, humidity, direct sunlight, or dust,
which could be a potential fire or electrical shock hazard.
• Do not allow water to enter the DA824 or allow it to become wet. Fire or electrical shock
may result.
• Connect the power cord only to an AC outlet of the type stated in this Owner’s Manual
or as marked on the DA824. Failure to do so is a fire and electrical shock hazard.
• Hold the power-cord plug when disconnecting from an AC outlet. Never pull the cord.
A power cord damaged through pulling is a potential fire and electrical shock hazard.
• Do not touch the power plug with wet hands. Doing so is a potential electrical shock
hazard.
• Do not place heavy objects, including the DA824, on top of the power cord. A damaged
power cord is a fire and electrical shock hazard. In particular, be careful not to place
heavy objects on a power cord covered by a carpet.
• Do not scratch, bend, twist, pull, or heat the power cord. A damaged power cord is a
fire and electrical shock hazard.
• If the power cord is damaged (e.g., cut or a bare wire is exposed), ask your dealer for a
replacement. Using the DA824 with a damaged power cord is a fire and electrical shock
hazard.
• Do not plug several devices into the same AC outlet. This may overload the AC outlet,
and could be a fire or electrical shock hazard. It may also affect the performance of some
equipment.
• If you notice any abnormality, such as smoke, odor, or noise, or if a foreign object or
liquid gets inside the DA824, turn it off immediately. Remove the power cord from the
AC outlet and consult your dealer for repair. Using the DA824 in this condition is a fire
and electrical shock hazard.
• Do not place small objects on top of the DA824. Metal objects falling inside the DA824
is a fire and electrical shock hazard.
• If a foreign object or water gets inside the DA824, turn it off immediately. Remove the
power cord from the AC outlet and consult your dealer for repair. Using the DA824 in
this condition is a potential fire and electrical shock hazard.
• Should the DA824 be dropped or the cabinet be damaged, turn off the power, remove
the power plug from the AC outlet, and contact your dealer. If you continue using the
unit without heeding this instruction, fire or electrical shock may result.
• Do not remove the DA824’s cover. You could receive an electrical shock. If you think
internal inspection, maintenance, or repair is necessary, contact your dealer.
• Do not attempt to modify the DA824. This is a potential fire and electrical shock hazard.
• Do not block the DA824 ventilation slots. Blocking the ventilation slots is a potential
fire hazard.
• Do not place a container with liquid or small metal objects on top of this unit. Liquid
or metal objects inside this unit are a fire and electrical shock hazard.

Specyfikacje produktu

Marka: Yamaha
Kategoria: Konwerter audio/wideo
Model: DA824

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Yamaha DA824, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Konwerter audio/wideo Yamaha

Yamaha

Yamaha DA824 Instrukcja

29 Sierpnia 2024

Instrukcje Konwerter audio/wideo

Najnowsze instrukcje dla Konwerter audio/wideo

Abus

Abus TVAC20001 Instrukcja

10 Października 2024
StarTech.com

StarTech.com VS123HD Instrukcja

9 Października 2024
StarTech.com

StarTech.com VS421HDDP Instrukcja

9 Października 2024
StarTech.com

StarTech.com ST228MX Instrukcja

9 Października 2024
StarTech.com

StarTech.com HDMI2DVI Instrukcja

9 Października 2024
StarTech.com

StarTech.com VGANTSCPRO Instrukcja

9 Października 2024
StarTech.com

StarTech.com CPNT2VGAA Instrukcja

9 Października 2024
StarTech.com

StarTech.com DVI2VGA Instrukcja

9 Października 2024
StarTech.com

StarTech.com VS222HDQ Instrukcja

9 Października 2024
StarTech.com

StarTech.com VS122HDMIU Instrukcja

9 Października 2024