Instrukcja obsługi WhiteLine MT-KL61A

WhiteLine Chłodzenie zamrożenia MT-KL61A

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla WhiteLine MT-KL61A (26 stron) w kategorii Chłodzenie zamrożenia. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/26
W hite Line
USER MANUAL
Gebrauchsanweisung
Manuel d’instructions
Gebruiksaanwijzing
LARDER
VOLLRAUM KÜHLSCHRANK
Espace plein Larder
Volledige ruimte provisiekast
MT- KL61A
Service-helpline: 0031-(0) 78 65 22 115
E-mail: info@tedsinternational.nl
- 1 -
Please read the following instruction carefully before using your refrigerator.
-Do not put hot food inside the refrigerator.
-Wrap all food items with a plastic protection film to avoid dehydration and lose
food flavor.
-If you do not use the refrigerator for a long period of time, disconnect power,
clean the inside parts, put the refrigerator in a dry area and leave the door
slightly open.
Ⅰ. GENERAL
The refrigerator is extensively used in places such as hotels, offices, houses
and student dormitories. It is mostly suitable for refrigerating and conserving
foods such as fruits and beverages. It enjoys the advantages of small size,
light weight, high efficiency and low energy consumption.
Ⅱ.UNPACKING,REPACKING AND MOVING
1.Unpacking
Just cut off the packing band, then pull the carton up.
2. Repacking
Please remember to put the original foamed pads in place.
3. Moving
Be sure refrigerator stays in upright position during moving it.
Do not tilt it for more than 45°from upright. Never upset it.
Do not apply force on any external part such as pipe, condenser, door and its
handle for moving, refrigerator must be well packed and secured in long
distance transportation to avoid damage from impacting and or great rocking.
Ⅲ. OPERATION
1. Before the refrigerator is plugged in, check the following:
-There must not be any damage on all electrical wire
-Earthing screw must be well fixed.
-Wall outlet must be properly earthed.
Be sure that everything is in normal condition and the refrigerator can be
plugged in.
2. When operating for the first time
When operating is in normal condition and the refrigerator without any load
until it auto stops at the desired temperature, Usually it takes 2 or 3 hours.
Then set the thermostat to the required setting and place foods in.
3. Temperature control
The refrigerator’s temperature can be adjusted by turning the knob of the thermostat.
The closer to “7”position the knob is set, the lower the temperature becomes. A
medium setting is the most suitable for general operation. The position “7”is cool
than the position “3”.
Refrigerator’s temperature will vary depending on the quantity of foods stored and
the frequency of the door opening, In order to maintain good cooling efficiency and
save energy, We recommend you not to store too much foods and not to open the
door too frequently.
CAUTION: When the thermostat has been turned clockwise to “7”position, do
not attempt to turn it more over. Otherwise it will be damaged.
Ⅳ.DEFROSTING
CAUTION: Never use any sharp of metallic instruments (e.g. knives) to
remove frost/ice from the evaporator as this will damage the evaporator. A
punctured evaporator will cause serious problems.
Ⅴ: CLEANING AND MAINTENANCE
1. To clean the refrigerator, disconnect power supply and remove foods,
shelves, trays etc. Use a solution mixed with 2 spoons of baking soda per litre
of warm water to clean the interior. Then wipe it clean with fresh water.
Never use acids, chemical thinner, gasoline, benzene or the like for cleaning
any part of the refrigerator.
Never use oiling water and benzene to clean plastic parts because they may
deform or damage the plastic parts.
2. Too much foods or a too large container in the refrigerator will affect cold air
circulation, so some free space must be left. It is recommended that about
70% storage volume is loaded.
Do not store volatile and or explosive materials such as ethers, gasoline,
liquefied petroleum gas, adhesives etc. in the refrigerator. Otherwise there will
be a danger of explosion caused by electric sparks.
Ⅵ. SAFETY INSTRUCTIONS
1. Before plugging your refrigerator in check that the electric supply in your
house must comply with the rating (voltage, frequency) of the refrigerator,
the rating plate is usually on the back of the refrigerator. The refrigerator
should always be plugged in its own individual electrical outlet to prevent
overload, which could cause a possible fire hazard from overheating wires.
Do not splash water on the refrigerator as this will cause electrical leakage
or failure. If the power cord becomes damaged, ask on electrician to

Specyfikacje produktu

Marka: WhiteLine
Kategoria: Chłodzenie zamrożenia
Model: MT-KL61A

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z WhiteLine MT-KL61A, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Chłodzenie zamrożenia WhiteLine

WhiteLine

WhiteLine MT-KL61A Instrukcja

23 Września 2024
WhiteLine

WhiteLine MT-DD 269A Instrukcja

22 Września 2024
WhiteLine

WhiteLine MT-KF 51A Instrukcja

18 Września 2024
WhiteLine

WhiteLine MT- KL 45 A Instrukcja

17 Września 2024

Instrukcje Chłodzenie zamrożenia

Najnowsze instrukcje dla Chłodzenie zamrożenia

Koenic

Koenic KFZ 531 E NF Instrukcja

7 Października 2024
Respekta

Respekta KS1220 Instrukcja

6 Października 2024
Marynen

Marynen cm 2684 dt Instrukcja

5 Października 2024
Junker

Junker JC30KB30 Instrukcja

5 Października 2024
Marynen

Marynen CM 1700 TC Instrukcja

5 Października 2024
Marynen

Marynen cm 1894 t Instrukcja

5 Października 2024
Marynen

Marynen cm 2826 dt Instrukcja

5 Października 2024
Junker

Junker JC20GB20 Instrukcja

5 Października 2024
Marynen

Marynen CM 1040T Instrukcja

5 Października 2024
Marynen

Marynen CM 2890F Instrukcja

5 Października 2024