Instrukcja obsługi Whirlpool WP 76/1 LD

Whirlpool Pomywaczka WP 76/1 LD

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Whirlpool WP 76/1 LD (8 stron) w kategorii Pomywaczka. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

Whirlpool is a registered trademark of Whirlpool USA 5019 396 01119

GB WP 76 LD

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g. different

loads, options, different sensor settings (only with sensor programmes), different water supply temperatures, as well as water

hardness and power supply voltage.

2) Reference programme for energy label in compliance with EN 50242. - Important information for Test Laboratories: for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

1. OVERVIEW

On button

Off button

Delayed start button

Press the button repeatedly to delay the

start of the programme by 3, 6 or 9 hours.

Then press the START button. The

dishwasher will start at the set time.

Detergent setting upon initial use and when using a different type of

detergent

1. Select the third programme in the relative table.

2. Press the START button for approx. 7 sec. to change the display.

3. Using the START button, select the desired detergent:

“3h” = 2in1, “6h” = 3in1, “9h” = other combined action detergents

(in this way, the rinse aid and/or salt indicator is deactivated). All 3

LEDs light up = Powder detergent (factory setting).

4. Switch the appliance off and then switch it on again. The selected

detergent type will be indicated on the display by the

corresponding LEDs for approx. 3 seconds.

Programme selection button

Press the button repeatedly until the desired programme

indicator lights up.

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the end of

the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected

programme and options are cancelled. Main failure

displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions

are given in chapter 5 “What to do if...”.

Rinse aid level indicator and salt level indicator

These indicator lamps light up when rinse aid or salt

need to be added. Add just before starting a wash

programme.

Table 1.1.

Programme chart Detergent

dispenser Consumption 1)

PProgrammes Available

options Loading instructions large small Litres kWh Minutes

1 Sensor Intensive 60-70°C

Automatic programme

recommended for heavily

soiled crockery with dried-on

or burnt food, for example

pans and saucepans.

X X 13-20 1.10-2.00 100-150 ±1)

2 Quickwash 40°C Lightly soiled crockery, with

no dried-on food. X — 10.0 0.65 30 ± 1)

3Eco 2) 50°C Normally soiled crockery. X X 12.0 1.05 165 ± 1)

4 Intensive 70°C

Recommended programme

for heavily soiled crockery,

especially suitable for pans and

saucepans.

X X 14.0 1.55 155 ± 1)

5 Power Clean 70°C

Recommended programme for

heavily soiled crockery, especially

suitable for pans and saucepans.

Intensive wash with additional

water jets.

X X 16.0 1.80 220 ± 1)

2. QUICK REFERENCE GUIDE

Detailed instructions are given in the following pages, see also chapter “5. What to do if...”

1. Switch on the

appliance

Open the dishwasher door.

Press the ON button.

2. Select a programme Press the button or to bring up the desired programme on the display.

Select options, if available.

3. Select the type of

detergent

The detergent selection procedure varies depending on the dishwasher model.

Chapter “1. Overview” provides instructions for selecting detergent type.

4. Fill in the detergent 4a. Powder/gel/tabs

Fill the detergent dispenser compartments in

accordance with the wash programme selected.

Large compartment A for every wash cycle, additional

small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.)

Place the detergent in compartment A or in the cutlery

basket, as per the manufacturer's recommendations.

5. Check the rinse aid

level

6. Check the salt level Depending on the model:

7. Load the racks

Make sure that the spray arms can turn freely and are not impeded by crockery

or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use

the appliance”, under “How to load the racks”.

8. Start the appliance Press the START button.

9. Turn on the water

tap and close the

dishwasher door

When the door is closed the dishwasher

starts automatically.

Wash cycle

If the appliance is switched off during a

wash cycle, when switched on again it will

resume the cycle from where it was

interrupted. Care must be taken when

opening the door, as steam will escape!

10.End of programme At the end of the programme an acoustic signal will sound.

The START indicator lamp switches off.

11.Open the door,

switch off the

appliance

Press the OFF button. All the indicator lamps switch off.

12. Turn off the water

tap, unload the racks

Unload the appliance, starting from the lower rack in order to avoid any

residual drips of water falling onto crockery below.

Visual indicator in dispenser C

dark ➯sufficient rinse aid present,

clear ➯add rinse aid (approx. 100 ml).

The indicator lamp on the control panel lights up when rinse aid

needs to be added. Not all models are equipped with such an

indicator.

window in salt reservoir cap on bottom of appliance inside

orange ➯when sufficient salt is present,

clear ➯when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs

to be added. Even once salt has been added, the indicator lamp

only switches off after several wash cycles!

Change the programme in progress:

- Press the START button for

about 2 sec., until the START

indicator lamp switches off.

- Close the door.

- (Water drains for up to 60 seconds).

- Open the door.

- Select a new programme.

- Press the START button.

3. HOW TO USE THE APPLIANCE

PROGRAMME SELECTION

Press the button or to bring up the desired programme on the display. The appliance must be switched

on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate

programmes and relative available options are detailed in table 1.1 on page 1.

Programme times stated in the table were obtained under normal conditions and may vary

depending on conditions. Differences of up to 20 minutes are possible with sensor programmes

as a result of the appliance's automatic calibration system.

HOW TO FILL THE DETERGENT DISPENSER

Only fill the detergent dispenser prior to starting a wash programme. Only use detergents

specially recommended for dishwashers, observing the manufacturer's recommended dosage.

Observe the manufacturer's safety warnings!

Open the detergent dispenser compartments by pushing the left lever (lever 1) of the dispenser.

a. Powder/gel/tabs

Fill the detergent dispenser compartments in accordance with the wash programme selected (table 1.1).

Programmes without pre-wash:

pour the entire recommended dosage into compartment A.

Programmes with pre-wash:

pour 2/3 of the recommended dosage into the large compartment

A and 1/3 into the small compartment B.

Dishwasher tabs should be placed, according to the

manufacturer's recommendations, in compartment A or in the

cutlery basket.

If the “Half load” option is selected, detergent dosage should be

reduced by approximately 1/3.

b. Combined action detergents (2 in 1/3 in 1/... etc.)

Combined action detergents should be placed, according to the

manufacturer's recommendations, in compartment A or in the

cutlery basket.

Firmly press the detergent compartment lid shut after filling.

Detergents with rinse aid incorporated may be effective only with longer programmes. In the

case of shorter programmes, detergent residue may be a problem (if necessary, use powder

detergent). Detergents with rinse aid incorporated tend to form excess suds.

The guarantee is not applicable if faults are caused by the use of these products.

HOW TO CHECK/FILL/ADJUST RINSE AID

Not necessary when using a combined action detergent.

a. How to check the rinse aid level

Check the visual indicator C on the rinse aid dispenser: dark = su ear = add rinse aid.fficient rinse aid, cl

In the case of appliances with an electric indicator on the

control panel, the rinse aid indicator lamp lights up red

when rinse aid needs to be added.

b. How to fill the rinse aid dispenser

Open the rinse aid dispenser by pressing the right lever

(lever 2) of the dispenser.

Fill the dispenser with rinse aid up to the “max” line

(approx. 100 ml).

Shut the lid again.

Only use rinse aids recommended for use in domestic dishwashers. Immediately wipe away

any rinse aid spilt accidentally. This prevents the formation of excess suds which can cause a fault

function of the appliance.

Lever 1

Large

compartment A

Small

compartment B

Lever 2Indicator C

max

Specyfikacje produktu

Marka:	Whirlpool
Kategoria:	Pomywaczka
Model:	WP 76/1 LD
Typ kontroli:	Buttons,Rotary
Wbudowany wyświetlacz:	Nie
Położenie urządzenia:	Częściowo wbudowany
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	220 - 240 V
Wysokość produktu:	820 mm
Szerokość produktu:	598 mm
Głębokość produktu:	555 mm
Waga produktu:	32500 g
Szerokość opakowania:	650 mm
Wysokość opakowania:	910 mm
Głębokość opakowania:	675 mm
Rozmiar produktu:	Pełny rozmiar (60 cm)
Kolor drzwiczek:	Nie dotyczy
Kolor panelu sterowania:	Czarny
Regulowana wysokość górnego koszyka:	Tak
Dostosowany do paneli:	Tak
Szerokość przedziału instalacji:	600 mm
Głębokość przedziału instalacji:	560 mm
Minimalna wysokość przedziału instalacji:	820 mm
Głębokość przy otwartych drzwiach:	1166 mm
Liczba miejsc:	13 komplet.
Ilość programów piorących:	6
Poziom hałasu:	49 dB
Czas cyklu:	200 min
Temperatura (maks):	- °C
Prąd:	10 A
Obciążenie:	1900 W
Pobór wody na cykl:	- l
Zużycie energii na cykl:	1.039 kWh
Tryb wyłączenia:	0.5 W
Skala efektywności energetycznej:	A +++ do D
Regulowane nóżki:	Tak
Wskaźnik soli:	Tak
Sterowanie przez Wi-Fi:	Nie
Klasa efektywności energetycznej (stara):	A+
Kategoria prania:	A
Waga wraz z opakowaniem:	34300 g
Roczne zużycie energii:	296 kWh
Kategoria suszenia:	A
Roczne spożycie wody:	3360 l
Regulowanie stopy:	80 mm
Panel drzwi w komplecie:	Nie