Instrukcja obsługi Whirlpool WH6FB10BS7A0X

Whirlpool Pomywaczka WH6FB10BS7A0X

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Whirlpool WH6FB10BS7A0X (14 stron) w kategorii Pomywaczka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/14

ENQuick Guide

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine’s functional components.

• It is mandatory that the salt reservoir never be empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

lled when the SALT REFILL indicator light in the control panel is lit.

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Only the rst time you do this: ll the salt reservoir

with water.

3. Position the funnel and ll the salt reservoir (see gure)

right up to its edge (approximately 1 kg); it is not unu-

sual for a little water to leak out.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into

the container during the wash program (this could damage the water sof-

tener beyond repair).

Whenever you need to add salt, it is mandatory to complete the pro-

cedure before the beginning of the washing cycle to avoid corrosion.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently prevent-

ing scale buildup on heater, contributing also to better cleaning eciency.

This system regenerates itself with salt, therefore it is required to rell

salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per Eco cycles with water hardness level set to . 6 3

Regeneration process starts in nal rinse and nishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid

dispenser A should be lled when the RINSE AID

REFILL indicator light in the control panel is lit.

NEVER pour the rinse aid directly into the appli-

ance tub.

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device . Introduce the C

detergent into the dry dispenser only. Place the amount of detergent for D

pre-washing directly inside the tub. If all-in-one detergents are used, we

recommend using the TABLET button, because it adjusts the program so

that the best washing and drying results are always achieved.

Usage of detergent not designed for dishwashers may cause malfunc-

tion or damage to the appliance.

Program

Programs description

Drying

phase

NaturalDry

Available options *)

Duration

of wash

program

(h:min)

**)

Water

con-

sumption

(litres/cycle)

Energy

consump-

tion

(kWh/cycle)

Eco 50°- Program is suitable to clean normally soiled tableware, that

for this use, it is the most ecient programme in terms of its com-

bined energy and water consumption, and that it is used to assess

compliance with the EU Ecodesign legislation. 3:35 8.7 0.51

2. Intensive 65° - Program recommended for heavily soiled crockery,

especially suitable for pans and saucepans. 2:45 17.5 1.60

6th Sense® 50-60°- For normally soiled dishes with dried food resi-

dues. Senses the level of soiling on the dishes and adjusts the pro-

gram accordingly. 1:20 - 3:00 7.0 - 14.0 0.70 - 1.10

4. Fast Wash&Dry 50°

- Normally soiled crockery. Everyday cycle, that

ensures optimal cleaning and drying performance in shorter time.

1.25 11.5 1.10

5. Crystals - 45° Program for delicate items, which are more sensitive

to high temperatures, for example glasses and cups. 1:40 12.0 1.20

6. Rapid 30’ - 45° Program to be used for half load of lightly-soiled

dishes with no dried food residues. Without drying. - 0:30 9.0 0.50

Silent

50° - Suitable for night-time operation of the appliance. With

the lowest noise. 3:30 16.0 1.15

Sanitizing - 65° Normally or heavily soiled crockery, with addi-

tional antibacterial wash. Can be used to perform maintenance of

the dishwasher. - 1.50 12.0 1.30

9. Prewash - Use to refresh crockery planned to be washed later.

No detergent to be used with this program. - - 0:10 4.5 0.01

CONTROL PANEL

FIRST TIME USE More information in the Daily Reference Guide on website.

PROGRAMS TABLE

1. On-O / Reset button with indicator light

2. Program selection button with indicator light

3. Multizone button with indicator light

4. Extra Dry button with indicator light / Keylock

5. Eco program indicator light

6. Keylock indicator light

7. Display

8. Program number and remaining time indicator

9. Tablet (Tab) indicator light

10. Closed water tap indicator light

11. Rinse Aid rell indicator light

12. Salt rell indicator light

13. Power Clean® button with indicator light

14. Tablet (Tab) button with indicator light

15. Delay button with indicator light

16. Start/Pause button with indicator light / Drain out

9 16

14 15

65 7 8 11 12 1310

THANK YOU FOR BUYING AWHIRLPOOL PRODUCT.

In order to receive amore complete assistance, please

PLEASE SCAN THE

QR CODE ON YOUR

APPLIANCE IN

ORDER TO HAVE

MORE DETAILED

INFORMATION

Before using the appliance carefully read Safety and Installation Instructions.

After installation, please remember to remove all transport protection parts from

the dishwasher.

Quick Guide

OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected

program (see PROGRAMS TABLE), the corresponding LED ashes rapidly 3 times and beeps will sound. The option will not be enabled.

CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS

1 2 3 4

In case you nd foreign objects (such as broken glass, porcelain, bones, fruit seeds etc.)

please remove them carefully.

NEVER REMOVE the wash-cycle pump protection (black detail) (Fig 4).

To remove the upper spray arm,

turn the plastic locking ring in

aclockwise direction.

The lower spray arm may

be removed by pulling it

upwards.

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.

Note for Test Laboratories: For information on

comparative EN testing conditions, please send an email to the following address:

dw_test_support@europeanappliances.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and

pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-

bration. The sensor calibration can increase program duration up to 20 min.

OPTIONS AND FUNCTIONS Please scan on your product in order to have more detailed information.the QR code

CUTLERY RACK

(loading

example for the

cutlery rack)

The third rack

was designed

to house the

cutlery.

UPPER RACK

(loading

example for the

upper rack)

Load delicate and light

dishes: glasses, cups, sau-

cers, low salad bowls.

The upper rack has tip-up

supports which can be

used in a vertical position

when arranging tea/ des-

sert saucers or in a lower

position to load bowls

and food containers.

FOLDABLE

FLAPS WITH

ADJUSTABLE

POSITION

LOWER RACK

(loading

example for the

lower rack)

For pots, lids, plates, salad bowls,

cutlery etc. Large plates and lids

should ideally be placed at the

sides to avoid interferences with

the spray arm.

The lower rack has tip-up supports

which can be used in a vertical

position when arranging plates or

in a horizontal position (lower) to

load pans and salad bowls easily.

POWER CLEAN®

Power Clean® uses the special water jets in the rear of cavity to wash

more intensively the high dirty items. The lower rack has a Space

Zone, a special pull-out support in the rear of the rack that can be

used to support frying pans or baking pans in upright position, thus

taking up less space. Placing the pots/casseroles faced to the Power

Clean® component please activate the POWER CLEAN® on the panel.

LOADING THE RACKS CAPACITY: 10 standard place-settings

CARE AND MAINTENANCE More information in the Daily Reference Guide on website.

KEY LOCK - A long press (for 3 seconds) of EXTRA DRY button, will activate

the KEY LOCK function. To deactivate the KEYLOCK, long press again.

DELAY - The start of the program may be delayed for a period of time

between and hours.0:30 24

The DELAY function cannot be set once a wash cycle has been started .

TABLET (Tab) - If you use powder or liquid detergent, this option

should be o.

MULTIZONE - If there are not many dishes to be washed, a half load-

ing may be used in order to save water, electricity and detergent.

By default the appliance washes dishes in all racks.

EXTRA DRY - A higher temperature during the nal rinse and an

extended drying phase allow for improving drying.

POWER CLEAN® - Thanks to the additional power jets this option

provides a more intensive and powerful wash in the lower rack, in the

specic area. This option is recommended for washing pots and casseroles.

NaturalDry is a convection drying system which automatically opens

the door during/after drying phase to ensure exceptional drying perfor-

mance every day. Door opens at the temperature that is safe to your kitch-

en furniture.

ENQuick Guide

In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list. For other errors or issues

please contact authorized After-sales Service which contact details can be found in the warranty booklet. Spare parts will be available for a period

of either up to 7 or up to 10 years, according to the specic Regulation requirements.

PROBLEMS POSSIBLE CAUSES SOLUTIONS

The dishwasher does not

ll the water. Display shows:

and , both On/O and F6

START/Pause LEDs are blink-

ing rapidly.

No water in the water supply or the tap is closed.

Make sure there is water in the water supply or the tap running.

The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION) reprogram the

dishwasher and reboot.

The sieve in the water inlet hose is clogged; it is

necessary to clean it.

After having carried out the verication and cleaning, turn o and

turn on the dishwasher and restart a new program.

Dishwasher nishes the cycle

prematurely.

Display shows: and both F15

On/O and START/Pause LEDs

are blinking rapidly.

Drain hose positioned too low or siphoning

into home sewage system.

Check if end of drain hose is placed at correct height (see INSTAL-

LATION).Check for siphoning into home sewage system, install air

admittance valve if necessary.

Air in water supply. Check water supply for leaks or other issues letting air inside.

Detergent leaks.

Depends on the liquid detergent used and can be

emphasized in case of Delay option is activated.

Small leaks will not cause machine malfunction and can be avoided

by changing liquid detergent type or using tablets.

TROUBLESHOOTING

Please scan the on your product in order to have more detailed information.QR code

Policies, standard documentation, ordering of spare parts and additional product information can be found by:

• Using QR code on your product.

• Visiting our website docs.whirlpool.eu/docs and parts-selfservice.europeanappliances.com

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet).

When contacting our After-sales Service, please state the codes provided on your product’s identication plate.

The model information can be retrieved using the QR-Code reported in the energy label.

The label also includes the model identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu.

IEC 436

Specyfikacje produktu

Marka:	Whirlpool
Kategoria:	Pomywaczka
Model:	WH6FB10BS7A0X

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Whirlpool WH6FB10BS7A0X, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Pomywaczka Whirlpool

Whirlpool WIE2C19AUSA Instrukcja

9 Stycznia 2025

Whirlpool WH7FA14BN7A0X Instrukcja

9 Stycznia 2025

Whirlpool WH6FB10BS7A0X Instrukcja

9 Stycznia 2025

Whirlpool WKIO 3T123 6P Instrukcja

5 Stycznia 2025

Whirlpool WH2FD14BN70 Instrukcja

5 Stycznia 2025

Whirlpool WFO 3T242 P Instrukcja

5 Stycznia 2025

Whirlpool WDT531HAPM Instrukcja

4 Stycznia 2025

Whirlpool WDTS7024RZ Instrukcja

4 Stycznia 2025

Whirlpool WSUO 3O23 PF Instrukcja

30 Grudnia 2025

Whirlpool W0B D841A X Instrukcja

25 Grudnia 2024

Instrukcje Pomywaczka

Najnowsze instrukcje dla Pomywaczka

Pitsos POWERJET7 Instrukcja

9 Stycznia 2025

Pitsos DRV4323 Instrukcja

9 Stycznia 2025

Pitsos DRI4515 Instrukcja

9 Stycznia 2025

Pitsos DVT5503 Instrukcja

9 Stycznia 2025

Pitsos DRS5512 Instrukcja

9 Stycznia 2025

Pitsos DGS5568 Instrukcja

9 Stycznia 2025

Pitsos DGS5538 Instrukcja

9 Stycznia 2025

Pitsos DGS5532 Instrukcja

9 Stycznia 2025

Smeg DWAFI314 Instrukcja

9 Stycznia 2025

Emilia EDW62SS Instrukcja

9 Stycznia 2025