Instrukcja obsługi Wahl Lithium Ion

Wahl kosiarka Lithium Ion

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Wahl Lithium Ion (6 stron) w kategorii kosiarka. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/6

MULTI CUT PET CLIPPER

INSTRUCTIONS

Please read all instructions carefully to familiarise yourself with the Wahl Pet Clipper before using.

Save these instructions for further reference.

For any further assistance or information call customer services on

T: 01227 740066

or visit

W: www.wahl.co.uk

E: customer.services@wahl.co.uk

CONTENTS

IMPORTANT SAFEGUARDS Page 2

OPERATING INSTRUCTIONS Page 3

CLIPPING AND TRIMMING DOGS Page 3

CLEANING AND MAINTENANCE Page 5

DISPOSAL Page 6

WIRING Page 6

PRODUCT REGISTRATION Page 6

GUARANTEE Page 6

IMPORTANT SAFEGUARDS

When using this electrical appliance, especially when children are present, basic safety

precautions should always be observed including the following.

TO REDUCE THE RISK OF FIRE AND

INJURY

1. This appliance can be used by children from aged 14 years and above and persons with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, if they have been given

supervision or instruction concerning use of the appliance in a safe way and understand the hazards

involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made

by children without supervision.

2. Switch off the appliance and unplug from outlet when not in use, before putting on or taking off

attachments and also before cleaning the appliance.

3. Never use your appliance without paying attention. Always unplug this appliance from the electricity

outlet immediately after using.

4. Do not operate the appliance with a broken cord, plug, charger or if the appliance malfunctions, or is

dropped or damaged in anyway.

5. Do not wrap the cord around the appliance.

6. Any servicing or repair must be performed by an authorised service representative.

7. Do not use outdoors or in damp areas.

8. Do not let the cord hang over the edge of the work surface or let it touch any hot surfaces.

9. The use of attachments that are not supplied by the manufacturer may cause re, electric shock or injury

and damage to the appliance.

10. To protect against the risk of electrical shock, never immerse the unit or let it come into contact with

water or any other liquids. Do not use the unit with wet hands. If the appliance should become wet,

damp or fall in water, remove plug from mains socket immediately. Do not put your hands in the water.

Do not take into bathroom.

11. Never carry the unit by its power cord.

12. Do not drop or insert any object into any opening.

13. Use this appliance only for its intended purpose.

14. During use, do not place or leave appliance where it may be damaged by an animal or exposed to

weather.

15. The blades on your clipper have ne teeth for precise cutting. Handle carefully when against the animals

skin in order to avoid irritation.

16. When using any electrical appliance around animals, Wahl recommend the use of a circuit breaker to

minimise risk.

NOTE:This appliance is intended for trimming purposes only.

OPERATING INSTRUCTIONS

WHY GROOM YOUR PET? “A CLEAN PET IS ALSO A HEALTHIER PET”

Regular care removes eas and external parasites which may cause skin disturbances and affect his/her health. Regular grooming (brushing,

combing and supplements) will help reduce hair shedding and keep the hair from becoming excessively matted. Generally, most household pets

do not need extensive care. Only a few minutes a day is enough to help keep your pet healthier, better looking and happier. The time you spend

exclusively with your animal during the grooming session will give the feeling that you are interested in him/her. They will look forward to the special

attention.

HOW TO OPERATE YOUR NEW WAHL PET CLIPPER

By following these simple steps, your quality Wahl pet clipper will provide years of reliable and satisfactory service:-

1. Do not attempt to operate this clipper before oiling blades. Place a few drops of Wahl oil between the blades. Use only Wahl oil and Wahl

Hygienic spray.

2. On Wahl pet clippers, it may be necessary to adjust the power screw to compensate for variance in line voltage. The power screw is located

near the middle of the clipper on the right hand side. To adjust power or stroke, turn the power screw clockwise until the clipper makes a loud

cracking noise caused by the arm hitting the coil. Gradually turn the power screw counter clockwise until the clipper runs quietly.

3. Do not try to sharpen the clipper blades at home if they are dull. Special equipment is needed to re-sharpen the blades. It is equally important

never to wash your blades in water. When the blades do not cut, they may need oiling or re-sharpening, you can return them to Wahl (UK) Ltd,

Herne Bay Trade Park, Sea Street, Herne Bay Kent CT6 8JZ for the attention of Customer Services. Blades will be sharpened for a nominal

charge.

4. To remove cutting blades for sharpening or replacement, loosen and remove the 2 screws on the bottom blade. To replace blades, simply use

the same 2 screws and re-tighten. Blades will need to be re-aligned (Fig 1.b).

5. Aligning the blades on your Wahl Pet clipper. Fig.1a shows how the bottom holes are larger than the shanks of the blade screws. When the

blade screws are loosened, the bottom blade can be aligned. Tighten the screws after the blade is aligned.

The end of top blade teeth should be .79mm to 1.54mm back from the bottom blade. This is important so that the clipper does not cut too close or

allow the moving cutter to touch the skin.

7. Extreme right hand tooth of the top blade must be touching the big tooth on the bottom blade.

BEFORE YOU CUT

1.Make sure your clipper is clean and in perfect working condition.

2.Comb through the coat to remove any tangles, and then bathe your animal in lukewarm water to remove any dirt. We recommend the use of shampoo/

conditioner from the Wahl Shampoo range prior to cutting. There are shampoos available for all types and colours of hair. Please visit www.wahl.co.uk

for more information.

3.Rinse well and allow the coat to dry completely.

4.Comb out any additional tangles to make trimming as easy as possible. This is very important to prevent snags. When using the comb attachments, if

the coat is not clean, dry and tangle free the combs will not remain on the clipper blades.

CLIPPING TIPS FOR ALL BREEDS OF DOGS

Before clipping your dog for the rst time, switch on the clipper for a short time near the animal so it gets used to the noise. If clipping for the rst time,

the clipping process will be slow. Try to move with the dog when clipping. After a few grooming sessions, you will develop your own comfortable style and

grooming will get faster. Take your time and use lots of encouragement and affection.

Dogs know when you are in a hurry and will get nervous, making grooming more difcult.

CLIPPING & TRIMMING DOGS

The rst time you cut hair, cut only a small amount until you have become accustomed to how long each guide comb leaves the hair. Ensure that you

regularly remove trimmed hair from the blades, clean and oil the blades during clipping.

CLIPPING GUIDE GENERAL - FEET

IT IS IMPORTANT TO TRIM OUT EXCESS HAIR ON PADS, OTHERWISE THE PADS WILL BECOME DIRTY AND MATTED CAUSING PAINFUL

WALKING.

Have your dog sit facing you. Bring rear leg forward carefully, (g.2) and clip sides of foot from nail to ends of toes.

Clip on top of toes, stopping at ankle joint. Don’t trim ankle. Spread toes apart with thumb and nger (g.3). Cut hair between toes, being careful not to nick

the webbing. A trimmer with a smaller blade may be easier in this sensitive area.