Instrukcja obsługi Wagner Airless HEA Control Series 250M
Wagner
pistolet do malowania
Airless HEA Control Series 250M
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Wagner Airless HEA Control Series 250M (1 stron) w kategorii pistolet do malowania. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/1
DOING A SPRAY TEST BEFORE
STARTING YOUR PROJECT
Before taking on your project simply take a piece of cardboard and do a
couple of spray tests. This will help you to achieve the right settings on the
paint sprayer:
× After installing the correct spray tip in the holder, try different
spray directions (e.g. vertical or horizontal) as shown by the arrow
on the tip.
× Adjust the pressure on the unit. While thicker materials (e.g. wall
paint) require more pressure, thinner ones (e.g. wood stains) need
less pressure.
× If your pattern is tailing, your spray tip might be incorrect, your spray
gun filter might be clogged or the paint is not diluted enough (for
further instructions see manual).
SPRAYING TIPS FOR EVEN
COVERAGE
× Spray at a constant speed and at an even distance from the surface.
The best distance is 20 to 30 cm between the spray tip and the
surface. For ceilings and hard to reach places WAGNER oers a wide
variety of accessories like extensions, longer hoses, etc.
× Make sure you are spraying at right angles to the surface. It is
important to move your entire arm back and forth rather than just
exing your wrist, otherwise one end of the pattern will be thicker
than the other and will cause overspray.
× The spray gun should be triggered by turning it on and o with each
stroke. Do not trigger the gun during the middle of a stroke. This will
result in an uneven spray and patchy coverage.
× Overlap each stroke by about 30 % for a smooth coating.
OTHER HELPFUL TIPS
× If you accidentally sprayed too much paint on one area, dab the paint
with a cloth or kitchen roll and spray another thin coat over it.
× During a break of several hours, it is not necessary to clean the entire
unit. The gun can be simply placed in a bucket with water to prevent
the paint in the tip from drying out. You should also cover up the paint
container to prevent the paint from drying out.
For more information, please read the relevant product manual
or visit our FAQs:
go.wagner-group.com/faqs-airless
MASKING AND COVERING
× If possible, empty the room completely. Alternatively, place all the
furniture in the middle of the room and cover it with a dust sheet.
× Cover the oor with a dust sheet, painter eece or cardboard.
× Use masking tape with an integrated drop sheet to cover up large
surfaces such as windows and doors.
× In addition test that the dust sheet does not utter when you get
close to it by just using the paint sprayer to blow air.
At WAGNER we have got you covered and have put together dierent
masking kits with all you need for a wide range of painting applications.
SET-UP
× Make sure to set up the Wagner unit properly (see manual).
CHOOSING THE CORRECT SPRAY
TIP AND FILTER
× For very thick materials, e.g. wall paints, we suggest using a 515, 517
or 619 tip with white lter.
× For thin materials, such as lacquers and stains, we recommend a 311
tip with red lter.
PREPARING COATING MATERIAL
Before putting the suction hose into the material, you need to prepare it:
× Most of the units can spray material straight from the container
without diluting. However, with some more viscous materials,
diluting by 5-10 % can give a better result (e.g. for a 10 L bucket 10 %
dilution means 1 L of water).
× If working with paint, make sure that it is approximately at room
temperature. Warm materials have more viscosity and are easier to
work with. However, do not go below or above the min./max.
temperature advised by the paint supplier.
× If there are any small particles in the paint such as dry paint from the
bucket, it is helpful to lter the paint to get rid of them.
× Dilute the paint with warm water (not hot!) or solvent for solvent-
based paints in accordance with manufacturer‘s instructions.
× Stir the material thoroughly with a stirring stick for at least 2 minutes.
In the case you are working with a bigger volume, e. g. 10 L bucket, it
is better to use a drill and a mixer therefor. Stir well, and always make
sure that there are no lumps in the paint, especially at the bottom
of the bucket. Some of the heavier materials in the paint can sink to
the bottem when the bucket has been standing for a longer time on
the shelve. When not mixed well, the lumps in the paint can clog the
paint sprayer.
In case of any questions, please do not hesitate to contact us directly:
J. Wagner GmbH | Otto-Lilienthal-Strasse 18 | D-88677 Markdorf | Telefon: +49 (0) 7544 / 505 - 0 | Mail: info@wagner-group.com | wagner-group.com
HEA SPRAYING
TIPS & TRICKS
Specyfikacje produktu
Marka: | Wagner |
Kategoria: | pistolet do malowania |
Model: | Airless HEA Control Series 250M |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Wagner Airless HEA Control Series 250M, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje pistolet do malowania Wagner
30 Grudnia 2025
7 Października 2024
2 Października 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024
28 Września 2024
28 Września 2024
20 Września 2024
Instrukcje pistolet do malowania
- pistolet do malowania Worx
- pistolet do malowania Yato
- pistolet do malowania Parkside
- pistolet do malowania Black & Decker
- pistolet do malowania DeWalt
- pistolet do malowania Einhell
- pistolet do malowania Silverline
- pistolet do malowania Ozito
- pistolet do malowania Meec Tools
- pistolet do malowania Westfalia
- pistolet do malowania Aerotec
- pistolet do malowania Ferm
- pistolet do malowania Fieldmann
- pistolet do malowania PowerPlus
- pistolet do malowania XU1
- pistolet do malowania EasyMaxx
- pistolet do malowania Metabo
- pistolet do malowania Cotech
- pistolet do malowania Sun Joe
- pistolet do malowania Tacklife
- pistolet do malowania Jocca
- pistolet do malowania Magnum
- pistolet do malowania Bort
- pistolet do malowania Power Craft
- pistolet do malowania Aqua Joe
- pistolet do malowania Pattfield
- pistolet do malowania Defort
- pistolet do malowania Truper
- pistolet do malowania Abac
- pistolet do malowania Meister Craft
- pistolet do malowania Probuilder
- pistolet do malowania Birchmeier
- pistolet do malowania Holzmann
- pistolet do malowania Wagner SprayTech
- pistolet do malowania Chapin
- pistolet do malowania Elektra Beckum
- pistolet do malowania Paintmaxx
- pistolet do malowania Deco
- pistolet do malowania MSW
Najnowsze instrukcje dla pistolet do malowania
8 Stycznia 2025
3 Stycznia 2025
30 Grudnia 2025
29 Grudnia 2024
15 Października 2024
15 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024