Instrukcja obsługi Viking VDD5300SS

Viking Okap wyciągowy VDD5300SS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Viking VDD5300SS (12 stron) w kategorii Okap wyciągowy. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/12

USE / INSTALLATION GUIDE

5 Series

Rear Downdraft Ventilators

MODEL WIDTH BLOWER (purchased separately)

VDD5300/CVDD5300 30" W. VDVI600 Interior or VDVE900 Exterior

VDD5360/CVDD5360 36" W. VDVI600 Interior or VDVE900 Exterior

VDD5450/CVDD5450 45" W. VDVI600 Interior or VDVE900 Exterior, VDVE1200 Exterior

VDD5480/CVDD5480 48" W. VDVI600 Interior or VDVE900 Exterior, VDVE1200 Exterior

WARNING

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY

TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the address

or telephone number in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent

power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a

prominent warning device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a

qualiﬁ ed person(s) in accordance with all applicable codes

and standards, including ﬁ re-rated construction codes and

standards.

4. Sufﬁ cient air is needed for proper combustion and exhausting

of gases through the ﬂ ue (chimney) of fuel burning equip-

ment to prevent backdrafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local code authori-

ties.

5. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. To reduce the risk of ﬁ re, use only metal ductwork.

8. Do not install this product with the activating switch directly

behind a burner or element. Minimum distance between the

switch and the edge of the burner should be 4 inches.

9. Loose-ﬁ tting or hanging clothing should never be worn when

operating this appliance. They may be ignited by burners/

elements on cooktop.

10. Children should not be left alone or unattended in the area

where this appliance is in use.

11. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may

ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

cooking ﬂ aming foods.

c) Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or ﬁ lter.

d) Use proper pan size. Always use cookware appropriate

for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWINGa:

1. SMOTHER FLAMES with a close-ﬁ tting lid, cookie sheet, or

metal tray, then turn off the burner. BE CAREFUL TO

PREVENT BURNS. If the ﬂ ames do not go out immedi-

ately, EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN - You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - a

violent steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher, and you

already know how to operate it.

B. The ﬁ re is small and contained in the area where it

started.

C. The ﬁ re department is being called.

D. You can ﬁ ght the ﬁ re with your back to an exit.

a Based on “Kitchen Firesafety Tips” published by NFPA.

CAUTION

1. For indoor use only.

2. For general ventilating use only. Do not use to exhaust haz-

ardous or explosive materials and vapors.

3. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

4. Clean ﬁ lters and grease-laden surfaces frequently.

5. Do not repair or replace any part of this appliance unless

speciﬁ cally recommended in this manual. All other servicing

should be done by a qualiﬁ ed technician.

6. Please read speciﬁ cation label on product for further informa-

tion and requirements.

7. To reduce the risk of ﬁ re and electric shock, install this down-

draft only with blower models shown below. Other blower

models cannot be substituted. (Blowers sold separately).

Flex Blower Model VDVI600

Exterior Blower Models VDVE900, VDVE1200

INSTALLER:

Save this manual for Electrical Inspector

and Homeowner to use.

PLANNING

ELECTRICAL SPECIFICATIONS

Model VDVI600 - Internal Flex:

120 VAC • 60 Hz • 3.0 A

Models VDVE900, VDVE1200 - Exterior

120 VAC • 60 Hz • 6.0 A (max.)

TAKE MEASUREMENTS

Due to its ﬂ exible design, this downdraft system can be used to ex-

haust airborne contaminants when cooking with a variety of gas or

electric cooking appliances - including cooktops, rangetops, slide-in

ranges and free-standing ranges.

It can be mounted in island, peninsula, or conventional wall loca-

tion. The blower (purchase separately) and electrical panel can be

mounted to the downdraft unit, inside the cabinet, or in a convenient

remote location.

This unit can be easily installed following these basic steps:

• Cut out the countertop opening.

• Mount the unit in the cabinet.

• Install the blower and electrical panel.

• Connect the ductwork and electrical.

• Mount the trim/door.

• Install the cooking appliance.

Note: the high level of air ﬂ ow of this appliance may effect the gas

ﬂ ame on some types of gas cooktops. This is NORMAL and will cause

no harm, but can be corrected by lowering the speed of the blower.

PLAN THE DUCTWORK

1. Refer to the cooktop installation instructions for dimensions of

cooktop, countertop cut-out, and cabinet requirements. However,

it is recommended that oversized cabinets be used for easier

installation.

2. Cooktop depth can vary greatly from one to another. This may

cause the ﬁ t of these two appliances to be rather tight.

Pay special attention to the areas of potential interference highlighted

above. A countertop with (A) a raised lip and/or (B) a backsplash may

not allow enough ﬂ at countertop for a proper installation. Note that

2-3/4" of ﬂ at countertop is required behind cooktop and that 1-3/4"

is necessary between the back edge of the cooktop and the inside

of cabinet back.

HOUSING

1. The downdraft blower system is designed for use with

8" round ductwork using a ﬂ ex blower or 10" Round

ductwork using a remote blower. (Purchase blowers

separately.) Six (6) different discharge connections are

available - with side-to-side adjustment for accurate

alignment of ductwork:

A = 8" Round, Left Discharge out of Flex Blower

B = 8" Round, Right Discharge out of Flex Blower

C = 8" Round, Down Discharge out of Flex Blower

(Electrical Box to be mounted remotely)

D = 2" x 19¼", Left Discharge out of Housing

to Remote Blower or Flex Blower in remote

location. Use 2" x 19¼" to 8" round transition,

2" x 19¼" to 10" round transition, or 2" x 19¼"

ductwork as appropriate.

E = 2" x 19¼", Right Discharge out of Housing

to Remote Blower or Flex Blower in remote

location. Use 2" x 19¼" to 8" round transition,

2" x 19¼" to 10" round transition, or 2" x 19¼"

ductwork as appropriate.

F = 2" x 19¼", Rear Discharge out of Housing

to Remote Blower or Flex Blower in remote

location. Use 2" x 19¼" to 8" round transition,

2" x 19¼" to 10" round transition, or 2" x 19¼"

ductwork as appropriate.

2. For best performance: Choose the ducting option which

allows the shortest length of ductwork and a minimum

number of elbows and transitions. Check location of

ﬂ oor joists, wall studs, electrical wiring or plumbing for

possible interference.

CONTENTS

These parts are included with your downdraft housing:

1 - Parts Bag

1 - Trim Kit

4 - Support Legs

1 - Electrical Panel

2 - Support Brackets

2-3/4"

2-1/2"

FLEX

BLOWER *

* Remote blowers use 8" or 10" round remote discharge

plate instead of ﬂ ex blower.

Specyfikacje produktu

Marka:	Viking
Kategoria:	Okap wyciągowy
Model:	VDD5300SS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Viking VDD5300SS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Okap wyciągowy Viking

Viking TVWH480DB Instrukcja

6 Października 2024

Viking VCIH56608SS Instrukcja

26 Września 2024

Viking VWH3010RE Instrukcja

23 Września 2024

Viking TVWH360FW Instrukcja

16 Września 2024

Viking VWH3010AR Instrukcja

12 Września 2024

Viking TVWH660AW Instrukcja

12 Września 2024

Viking VBCV54838 Instrukcja

9 Września 2024

Viking VWH3610RE Instrukcja

9 Września 2024

Viking VDD5480SS Instrukcja

8 Września 2024

Viking VDD5450SS Instrukcja

5 Września 2024

Instrukcje Okap wyciągowy

Najnowsze instrukcje dla Okap wyciągowy

Silverline PRW 800 Instrukcja

15 Stycznia 2025

Silverline STW 600 C Instrukcja

15 Stycznia 2025

CATA F 2260 X Instrukcja

15 Stycznia 2025

Bosch DWK09M760 Instrukcja

15 Stycznia 2025

Zanussi ZHC 1000 x Instrukcja

15 Stycznia 2025

AEG-Electrolux X69453MVO Instrukcja

15 Stycznia 2025

Beko CWB 9441 Instrukcja

15 Stycznia 2025

Bosch DWB097A51 Instrukcja

15 Stycznia 2025

Elica EST630SS Instrukcja

15 Stycznia 2025

Atag WS90211EM Instrukcja

15 Stycznia 2025