Instrukcja obsługi Valk Fixed Speed Commuter 36V

Valk rower elektryczny Fixed Speed Commuter 36V

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Valk Fixed Speed Commuter 36V (33 stron) w kategorii rower elektryczny. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/33

Please note the user must be pedalling in order for the motor to activate.

Colours may vary

User Manual

[Revision 13.0 February 2022 ]

READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY

DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by

this manual may vary in appearance, assembly, inclusions, specifications, and packaging.description,

26" Electric Bike

E&OE © Valk 2 2022

Safety

Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or

equipment or property damage if not understood or followed. Safety messages have the following symbols:

You WILL be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be INJURED if you do

not follow instructions or equipment

damage may occur.

It is vital that you read and understand this

user manual before using the product,

including safety warnings, and any assembly

and operating instructions. Keep the manual

for future reference.

Safety precautions and recommendations

detailed here must be fully understood and

followed to reduce the risk of injury, fire,

explosion, electrical hazard, and/or property

damage.

Safety information presented here is generic

in nature some advice may not be –

applicable to every product. The term

"equipment" refers to the product, be it

electrical mains powered, battery powered or

combustion engine powered.

• - Before Use If you are not familiar with the

safe operation/handling of the equipment or

are in any way unsure of any aspect of

suitability or correct use for your

application, you should complete training

conducted by a person or organization

qualified in safe use and operation of this

equipment, including fuel/electrical handling

and safety.

• Do NOT operate the equipment in

flammable or explosive environments, such

as in the presence of flammable liquids,

gases or dust. The equipment may create

sparks or heat that may ignite flammable

substances.

• Keep clear of moving parts.

• Equipment may be a potential source of

electric shock or injury if misused.

• Do NOT operate the equipment if it is

damaged, malfunctioning or is in an

excessively worn state.

• Do NOT allow others to use the equipment

unless they have read this manual and are

adequately trained.

• - risk Keep packaging away from children

of suffocation! Operators must use the

equipment correctly. When using the

equipment, consider conditions and pay

due care to persons and property.

General Work Area Safety

• Work areas should be clean and well it.

• Do not operate the equipment if

bystanders, animals etc are within

operating range of the equipment or the

general work area.

• If devices are provided for connecting dust

extraction / collection facilities, ensure

these are connected and used properly.

D -ust collection can reduce dust related

hazards.

General Personal Safety

• Wear appropriate protective equipment

when operating, servicing, or when in the

operating area of the equipment to help

protect from eye and ear injury, poisoning,

burns, cutting and crush injuries. Protective

equipment such as safety goggles,

respirators, non slip safety footwear, hard -

hat, hearing protection etc should be used

for appropriate equipment / conditions.

Other people nearby should also wear

appropriate personal protective equipment.

Do not wear loose clothing or jewellery,

which can be caught in moving parts. Keep

hair and clothing away from the equipment.

• Stay alert and use common sense when

operating the equipment. Do not over-

reach. Always maintain secure footing and

balance.

• Do not use the equipment if tired or under

the influence of drugs, alcohol or

medication.

• This equipment is not intended for use by

persons with reduced physical, sensory or

mental capabilities.

General Fuel Safety

• Petrol/fuel/gasoline is extremely flammable

– keep clear of naked flames or other

ignition sources.

• Do not spill fuel. If you spill fuel, wipe it off

the equipment immediately if fuel gets on –

your clothing, change clothing.

• Do NOT smoke near fuel or when

refuelling.

• Always shut off the engine before

refuelling.

• Do NOT refuel a hot engine.

• Open the fuel cap carefully to allow any

pressure build up in the tank to release -

slowly.

• Always refuel in well ventilated areas.

• Always check for fuel leakage. If fuel

leakage is found, do not start or run the

engine until all leaks are fixed.

General Carbon Monoxide Safety-

• Using a combustion engine indoors CAN

KILL IN MINUTES. Engine exhaust

contains carbon a poison you -monoxide –

cannot smell or see.

• Use combustion engines OUTSIDE only,

and far away from windows, doors and

vents.

General Equipment Use and Care

• The equipment is designed for domestic

use only.

• Handle the equipment safely and carefully.

• Before use, inspect the equipment for

misalignment or binding of moving parts,

loose components, damage or any other

condition that may affect its operation. If

damaged, have the equipment repaired by

an authorised service centre or technician

before use.

• Prevent unintentional starting of the

equipment - ensure equipment and power

switches are in the OFF position before

connecting or moving equipment. Do not

carry equipment with hands or fingers

touching any controls. Remove any tools or

other items that are not a part of the

equipment from it before starting or

switching on.

• Do not force the equipment. Use the

correct equipment for your application.

Equipment will perform better and be safer

when used within its design and usage

parameters.

• Use the equipment and accessories etc. in

accordance with these instructions,

considering working conditions and the

work to be performed. Using the equipment

for operations different from those intended

could result in hazardous situations.

• Always keep equipment components

(engines, hoses, handles, controls, frames,

housings, guards etc) and accessories

(cutting tools, nozzles, bits etc) properly

maintained. Keep the equipment clean and,

where applicable, properly lubricated.

• Store the equipment out of reach of

children or untrained persons. To avoid

burns or fire hazards, let the equipment

cool completely before transporting or

storing. Never place or store the equipment

near flammable materials, combustible

gases or liquids etc.

• -The equipment is not weather proof, and

should not be stored in direct sunlight, at

high ambient temperatures or locations that

are damp or humid.

• Do not clean equipment with solvents,

flammable liquids or harsh abrasives.

• For specific equipment safety use and care,

see Equipment Safety.

26" Electric Bike

E&OE © Valk 3 2022

General Electrical Safety

• Inspect electrical equipment, extension

cords, power bars, and electrical fittings for

damage or wear before each use. Repair or

replace damaged equipment immediately.

• Ensure all power sources conform to

equipment voltage requirements and are

disconnected before connecting or

disconnecting equipment.

• When wiring electrically powered

equipment, follow all electrical and safety

codes.

• Wherever possible, use a residual current

device (RCD).

• High voltage / high current power lines may

be present. Use extreme caution to avoid

contact or interference with power lines.

Electrical shock can be fatal.

General Electrical Safety

• Electrically grounded equipment must have

an approved cord and plug and be

connected to a grounded electrical outlet.

• Do NOT bypass the ON/OFF switch and

operate equipment by connecting and

disconnecting the electrical cord.

• Do NOT use equipment that has exposed

wiring, damaged switches, covers or

guards.

• Do NOT use electrical equipment in wet

conditions or in damp locations.

• Do NOT use electrical cords to lift, move or

carry equipment.

• Do NOT coil or knot electrical cords, and

ensure electrical cords are not trip hazards.

General Service Information

• The equipment must be serviced or

repaired at authorised service centres by

qualified personnel only.

• Replacement parts must be original

equipment manufacturer (OEM) to ensure

equipment safety is maintained.

• Do NOT attempt any maintenance or repair

work not described in this manual.

• After use, the equipment and components

may still be hot allow the equipment to –

cool and disconnect spark plugs and/or

electrical power sources and/or batteries

from it before , changing adjusting

accessories or performing repair or

maintenance.

• s Do NOT adjust while the equipment i

running.

• Perform service related activities in suitable

conditions, such as a workshop.

• Replace worn, damaged or missing

warning/safety labels immediately.

Electric Bike Safety

• Handle your control, posture, speed etc so that you are able to maintain stability & stopping ability in the event of, loss of traction, loss of power

from any condition such as battery exhaustion, control disruption, disruption of balance, moisture, overload cut out, protection cut out etc.- - As with

any vehicle or mechanical product, there is always a chance of failure.

• Riding can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. The product can and is

intended to move, and it is therefore possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or -

expertise can eliminate. If such things occur, you can be seriously injured or die, even when using safety equipment and other precautions. RIDE

AT YOUR OWN RISK AND USE COMMON SENSE. FAILURE TO USE COMMON SENSE AND HEED ALL SAFETY WARNINGS AND - -

RECOMMENDATIONS INCREASES RISK OF INJURY. USE THE PRODUCT ONLY WITH APPROPRIATE CAUTION AND SERIOUS

ATTENTION TO SAFE OPERATION.

• Before riding on the road, take time riding in an enclosed area to familiarise yourself with the controls and behaviours of an electrically

assisted bicycle. Try all settings so you are familiar with the results.

• Before every ride, check bicycle condition and ensure that no fasteners are loose, particularly axles, pedals, seat and handlebars.

Ensure that the tyres are inflated to within specification (printed on the tyre sidewall), and that the brakes are operating correctly.

• Maximum load capacity = 120kg.

• Understand and obey any local laws or regulations which may affect locations where the product may be used. Ride defensively.

• -stress This product is manufactured for performance and durability but is not impervious to damage. Stunts or other aggressive riding can over

and damage the product, and the rider assumes all risks associated with how the product is looked after.

• Keep fingers and other body parts away from moving components.

• Always wear suitable protective equipment, such as an approved safety helmet (with chin strap securely buckled). A helmet may be legally

required by local law or regulation in your area. Wear suitable footwear for bicycle riding and clothing that helps make you visible to others.

Battery and Charging

• Never modify the electrical system. Alterations could cause a fire resulting in serious injury and could also damage the electrical system.

• Charge with the supplied or recommended charger only. Use of the wrong charger could cause a fire or explosion resulting in serious injury.

• Ensure the voltage and frequency of the charger is compatible with mains electrical supply.

• Use the battery charger in dry locations only.

• Regularly check the charger for damage to the electrical cord, plug, enclosure and other parts. If any damage or malfunction occurs, do NOT use

the charger until repaired or replaced.

• Use caution when charging.

• Do not operate the charger or charge batteries near flammable materials.

• Do not clean or perform any maintenance on the product when it is being charged.

• Use of an incompatible charger or battery may cause a fire.

• Use only VALK/NISHIRO compatible batteries or chargers.

• USE OF BATTERIES OR CHARGERS OUTSIDE OF THESE TERMS WILL VOID ALL WARRANTY CLAIMS.

Other Safety Reminders

• This manual is provided to help you to get the best performance, comfort, enjoyment and safety from your bicycle. The manual describes specific

care and maintenance procedures that help protect your warranty and ensure trouble free use. Please pay particular attention to the section on -

battery charging and maintenance.

• Read the manual before assembling and riding your bicycle.

Specyfikacje produktu

Marka:	Valk
Kategoria:	rower elektryczny
Model:	Fixed Speed Commuter 36V

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Valk Fixed Speed Commuter 36V, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje rower elektryczny Valk

Valk Cityhop II Instrukcja

26 Września 2024

Valk Fixed Speed Commuter 36V Instrukcja

26 Września 2024

Instrukcje rower elektryczny

Najnowsze instrukcje dla rower elektryczny

Hiboy EX7 Instrukcja

9 Października 2024

Qwic MD11 Speed Instrukcja

8 Października 2024

EMG Speedy Instrukcja

7 Października 2024

EMG Rebel Instrukcja

7 Października 2024

EMG SUV e-dust Instrukcja

7 Października 2024

EMG Bomber One Instrukcja

7 Października 2024

EMG Jammy Instrukcja

7 Października 2024

EMG Marilyn Plus Instrukcja

7 Października 2024

Icon.e EASY Instrukcja

4 Października 2024

Wayscral Classy 615 Instrukcja

4 Października 2024