Instrukcja obsługi Valcom V-2904
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Valcom V-2904 (14 stron) w kategorii Interkom. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/14
Issue 7
V-2904
UNIVERSAL FOUR DOOR ANSWERING SYSTEM
INTRODUCTION
The V-2904, Universal Four Door Answering
System, when used with Valcom Door Plate
Speakers, provides voice paging with handsfree reply
to up to four doors from any telephone location. The
V-2904 initiates ring-in on the telephone system and
sends a confirmation tone to the door speaker. The
individual at the phone responding to the signal will
determine if access should be allowed. Pressing a
programmed code on the telephone dialpad or
pressing the remote button will unlock the door to
allow admission. The V-2904 also provides an alarm
control output to alert an unauthorized entry.
• Reorient the receiving antenna
• Relocate the equipment with respect to the radio
or television
These instructions contain the specifications and
information necessary to install, operate and maintain
the Universal Four Door Answering System. • Move the equipment further away from the radio
or television
• Plug the equipment into a different branch circuit
FCC Notice
This equipment generates and uses radio frequency
energy and if not installed and used properly, that is,
in strict accordance with the instructions listed in this
User's Manual, may cause interference to radio and
television reception.
NOTE: The manufacturer is not responsible for
any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the user's authority
to operate the equipment.
It has been tested and found to comply with the limits
for a Class B Computing Device in accordance with
the specifications in Subpart B of Part 15 of the FCC
rules, which are designed to provide reasonable
protection against such interference in a residential
installation. If this equipment does cause interference
to radio or television reception, which can be
determined by turning off the equipment and seeing if
the interference stops, the user is encouraged to try
and correct the interference by one or more of the
following measures:
SPECIFICATIONS
Access
• Electronic Key Systems
• PABXs
• 1A2 Key Systems
• Stand Alone Systems
Refer to Figure 1 for a simplified block diagram of a
typical installation.
1 947304
E-Key
C.O.Line
Position
V-2904
Universal
Four Door
Answering
System
Doorplate
Speaker
with
Pushbutton
Up to 4
Locations
FIGURE 1 - SIMPLIFIED BLOCK DIAGRAM OF A TYPICAL INSTALLATION
Power
Supply
Features
• Compatible with PABX, E-Key and 1A2
telephone
• Switch selectable - loop or ground start access
• Provides handsfree talkback to four separate
locations
• RJ11 modular connector for Tip and Ring
connections
• Power ON LED
• Provides contacts for up to four circuits
• Programmable options:
Programming access code
Ring Pattern
Station Identification
Activate lock relay
Duration of lock relay activation
Time door can remain open after unlock
(exit delay time)
Entry delay time
Number of ring cycles
Disable station alarm
Alarm disable code
Station alert tone
• Input for manual door unlock (push button)
• Built-in 30Hz ring voltage generator with on/off
switch
• Ringback tone to speaker
• Calls can be placed On Hold
• Call waiting
• One-way all call with volume control
• Background music input with volume control
• Speaker to phone volume control
• Phone to speaker volume control
• Simultaneous calls placed in queue
• Dial tone
• Confirmation tone
• Compatible with tone dial phones
• Works with Valcom V-1072A doorplate speaker
or other Valcom one-way or talkback speakers.
• Compatible with VPB-260 battery backup
Dimensions/Weight
Dimensions: 8.60" H x 11.00" W x 2.30" D
(21.84cm H x 27.94cm W x 5.84cm D)
Weight: 3.1 lbs. (1.41 kg)
Nominal Specifications
Input Impedance: 600 Ohms
Input Level: -10dBm Nominal
Output Impedance: 45 Ohms
Ring Supply: 90VAC, 30Hz
Suitable for REN of 5.0
Power Requirements
Power Supply: -24VDC filtered
600mA minimum
Environment
Temperature: 0 to 40°C
Humidity: 0 to 85% (non-precipitating)
2
Components
The following equipment is recommended when
using the V-2904:
• 1 - V-2904 Universal Four Door Answering
System
• 1 - C. O. Line Position (Electronic Key
System); 1 - Loop Trunk Position (PABX) or 1 -
400 type line card (1A2 key)
• 1 - Dedicated single line phone*
• 1 to 4 Valcom Doorplate Speaker(s)**
• 1 - VP-624B Power Supply
* A single line telephone cannot be connected to
both the V-2904 and an incoming central office
line.
** It is recommended that one talkback speaker
be used per door station. Use of more than one
talkback speaker per station may result in damage
to the V-2904. Up to 40 one-way amplified
speakers may be connected to a zone if the zone is
to be used as a one-way paging zone.
DESIGN
The V-2904, Universal Four Door Answering System
was designed to provide voice paging with handsfree
reply to up to four door speakers from a telephone
location. The V-2904 initiates ring-in on the
telephone system and sends a confirmation tone to the
door when a button is pressed at the door (Valcom
doorplate speakers are normally used in this
application). The individual at the phone responding
to the signal can converse with the person at the door
and determine if access should be allowed. If the
door is equipped with an electric strikeplate, the
person at the phone can enter a programmed code on
the telephone dial pad or press a remote button to
unlock the door to allow admission. When the system
is in use and another call is placed from a different
station, the person on the telephone will hear a call
waiting tone corresponding to that door location.
(Example: Beep-Beep for Station 2). The call will
remain waiting for a programmed period of time. If
this additional call remains unanswered, it will drop
off after the programmed period of time for call
waiting.
The V-2904 provides an alarm control output for
unauthorized entry. When the door lock relay is
activated and the door remains open longer than the
programmed period of time, a ground potential will
appear on pin 3 of the V-2904 (unauthorized door
opening) that can be used to signal a customer
provided alarm, auto dialer, etc. Also, if the phone is
on hook, the phone will begin ringing in a pattern
designating which door failed to close. (Example:
Station 3 - ring-ring-ring). If the phone is off hook,
any activity the phone is involved in will be
terminated and the phone will receive a momentary
warble tone, a station indication tone, the ringback
tone and be connected to the station with an open
door. After hangup, if the door is not closed, the
alarm condition will continue. If another
unauthorized entry is detected, it will override the
older one. When this new alarm condition is
resolved, the system will revert to the previous alarm
condition until all alarm conditions are resolved.
When indication arrives that a door is open while
door station is inactive, such as a break-in, the system
waits the programmed period of time (entry delay
time) for a confirmation of entry indicating the
opening as legitimate. When this does not arrive in
the programmed time frame or if it arrives and the
door is not closed at the end of the programmed time
period, an alarm will sound in the same manner as
described above.
The V-2904 also provides a background music input
and is designed to automatically cut off at individual
stations during a page or during an alarm situation. If
background music is to be installed, a low level music
source such as the Valcom V-2952 FM Tuner will be
required.
Another feature of the V-2904 is the All Call Page.
By pressing the number "8" or "0" on the telephone
dialpad, the person at the phone can make a one-way
announcement to all stations. The All Call is also
overridden during an Alarm Condition.
INSTALLATION
Cabling
A 25 pair cable with a female amphenol connector
should be run from the V-2904 to a 66B-type
punchdown block. The cables should be terminated
on the connecting block in standard color code.
Refer to Figure 2 - Block Connections for the
suggested pinout locations.
Mounting
The V-2904 is designed to be wall or shelf mounted.
When wall mounting the V-2904, secure the unit to
wall studs or a suitable brace, away from heat sources
or strong magnetic fields (motors, fans, power
supplies, etc.) with controls and connectors
accessible. (A plywood backboard 2 feet square and
at least 1/2 inch thick attached to wall studs would be
considered a suitable brace).
Four #10 x ¾ inch flat-head wood screws are
included for mounting. Fasten two screws on the
mounting surface, allowing them to protrude 1/8 inch
to ¼ inch. Place the chassis of the V-2904 onto the
screwheads at the mounting slots.
3
Specyfikacje produktu
Marka: | Valcom |
Kategoria: | Interkom |
Model: | V-2904 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Valcom V-2904, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Interkom Valcom
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
Instrukcje Interkom
- Interkom Philips
- Interkom Hikvision
- Interkom Panasonic
- Interkom Alcatel
- Interkom Viking
- Interkom ORNO
- Interkom Vimar
- Interkom Dahua Technology
- Interkom Emos
- Interkom Somfy
- Interkom DiO
- Interkom DataVideo
- Interkom EtiamPro
- Interkom Planet
- Interkom Axis
- Interkom Elro
- Interkom Marmitek
- Interkom ZKTeco
- Interkom Akuvox
- Interkom Busch-Jaeger
- Interkom Fibaro
- Interkom Hanwha
- Interkom Avidsen
- Interkom TOA
- Interkom Byron
- Interkom Monacor
- Interkom M-e
- Interkom Becken
- Interkom Smartwares
- Interkom Sygonix
- Interkom WHD
- Interkom Extel
- Interkom Steren
- Interkom Siedle
- Interkom Chacon
- Interkom Konig
- Interkom DoorBird
- Interkom Gira
- Interkom Russound
- Interkom Comelit
- Interkom Aiphone
- Interkom RTS
- Interkom Bitron
- Interkom Hollyland
- Interkom Leviton
- Interkom Ritto
- Interkom Syscom
- Interkom Pentatron
- Interkom CyberData Systems
- Interkom COMMAX
- Interkom Bintec-elmeg
- Interkom Eartec
- Interkom Gewiss
- Interkom Seco-Larm
- Interkom GEV
- Interkom Mobotix
- Interkom FlyingVoice
- Interkom Vibell
Najnowsze instrukcje dla Interkom
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024