Instrukcja obsługi Turbo Scrub Lite


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Turbo Scrub Lite (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/4
TSINST20816-TVP
PLEASE READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE
ATTEMPTING TO OPERATE THE PRODUCT.
PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
SAFETY INSTRUCTIONS
Prior to first operation, read
this manual carefully and
keep it for future use.
This product is not a toy.
Close supervision is required
when any appliance is used
by or near children. Store out
of reach of children.
If the charger cord is
damaged, it must be
replaced by the manufacturer
or its service agent or
similarly qualified person in
order to avoid a hazard.
To protect against the risk of
electric shock, do not put the
battery charger in water or
other liquid. Do not charge
battery if it is wet or shows
signs of corrosion. Do not
place or store appliance
where it can fall or be pulled
into a tub or sink.
Do not incinerate the battery.
It can explode in a fire. A
small leakage from the
battery cell may occur under
extreme usage, charging or
temperature conditions. This
does not indicate a failure.
However, if the outer seal is
broken, cracked or damaged
and this leakage gets on
your skin: wash quickly with
soap and water or neutralize
with mild acid such as lemon
juice or vinegar. If the liquid
gets into the eyes, flush them
immediately with clean water
for a minimum of ten
minutes. Seek medical
attention.
Do not use an extension
cord. Plug the charger
directly into a standard 220V
- 240V power outlet.
Do not attempt to use this
charger with any other
product. Do not attempt to
charge this product with any
other charger.
Use only the charger
supplied by the manufacturer
to recharge.
Do not charge the unit
outdoors, store indoors after
each outdoor use.
Do not use the charger in wet
or damp conditions. Do not
use charger near sinks or
tubs. Do not immerse in
water.
Do not allow the cord to hang
over the edge of a table or
counter or touch hot
surfaces. The charger should
be placed away from sinks or
hot surfaces.
Do not operate charger if it
has received a sharp blow,
been dropped, or otherwise
damaged in any way. Do not
disassemble the charger for
any reason.
For best results, do not
charge a battery when it or
the air temperature is below
5°C {40°F) or above 40°C
(105°F).
Unplug the charger when not
in use and before cleaning.
Do not abuse the cord. Do
not carry the charger by the
cord or yank the cord to
disconnect. Grasp the
charger plug and pull to
disconnect. Keep charger
cord away from heat and sharp
edges.
• Do not operate in the
presence of explosives and/or
other flammable fumes or
liquids.
If abnormal noise, smell,
smoke or any other failure or
breakage is found during the
operation, turn off the switch
and unplug it. Then, contact
the service department
immediately at 0800 587
6133. Do not attempt to
repair by yourself.
Do not store or use close to
high temperatures.
Always use proper eye
protection when using the
Turbo Scrubwith irritating
substances. Rubber gloves
are also recommended.
When changing accessories,
please make sure to turn off
the machine first.
Please make sure to charge
the machine when in the OFF
position.
This appliance is only for
household use, not for
commercial or industrial use.
Always store the unit indoors.
WARNING: When using electric appliances, basic precautions
should always be followed, including the following:
For Parts
& Accessories:
- WARNINGS CONTINUED ON BACK
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS.
3.6V Ni-Mh battery 1300mAh
®
www.highstreettv.com
OPERATION INSTRUCTIONS:
WARNING:
Always use rubber gloves and proper eye wear to avoid
contact from splashing of soaps or detergents on skin and/or
eyes while head is spinning and when brushes are removed
or attached.
When done using Turbo Scrub, turn unit off while brush is
still in contact with surface to avoid getting splashed with
soaps or detergents.
Always test on a small, inconspicuous area before using on
a larger area. Always follow surface manufacturer’s guide-
lines for cleaning and maintenance.
Do not use with abrasive cleaners on any surface.
Avoid exposing the unit to excessive water. If Turbo Scrub
accidentally becomes submerged in water or water gets into
“Charging Port, shake out liquid and allow Turbo Scrub to
dry overnight.
PLEASE RETAIN THESE INSTRUCTIONS
Keep hair, loose clothing, and
all parts of the body away
from moving parts.
Do not use the appliance
when charging cover is open.
Do not submerge the handle in
water or other liquid.
Use only as described in this
manual. Use only
recommended parts.
Only use attachments
recommended or sold by the
manufacturer.
To disconnect, turn all controls
to the OFF (“O”) position, then
remove plug from outlet.
• Do not operate any appliance
with a damaged cord or plug,
or after the appliance
malfunctions or is dropped or
damaged in any manner.
Return appliance to the
nearest authorized service
facility for examination, repair,
or electrical or mechanical
adjustment.
ASSEMBLY INSTRUCTIONS:
1. Be sure ON/OFF button on Handle is in OFF position.
2. Line up connection tab of Head” and “Release Button on
Handle. Press together until you hear a click.
3. To attach brush attachment of your choice, simply line up
tabs of Brush Attachment and Brush Connector onHead
and press together until you hear a click.
1. Choose proper Brush Attachment and attach to Turbo Scrub
as directed in “Assembly Instructions.
• All-Purpose Brush: Best for large jobs, cleaning tile,
and grout.
Corner Brush: Best for corners, door tracks,
and tight spaces.
2. Wet the intended area and apply desired cleaning product.
3. Place tip of brush on surface to be cleaned.
4. Being sure you have a firm hold of the handle, press
ON/OFF button toON” position.
NOTE: DO NOT apply pressure. Turbo Scrub works best
when lightly applied to surface.
5. When done, press ON/OFF button to OFF position.
Clean Turbo Scrub as directed.
CARE & MAINTENANCE:
* Use a damp, non-abrasive cloth to clean Turbo Scrub unit.
If needed, use a mild detergent. Let air dry.
o Do NOT immerse or run under water.
o Do NOT clean with alcohol or Heavy Cleaning
Detergents.
• Rinse Brush attachments under water and clean thoroughly
after use. Let air dry.
1. Be sure ON/OFF button on
“Handle is in OFF position.
2. Open Charging Port Cover
located on bottom ofHandle
of unit.
3. Insert cable end ofWall
Charger” into Charging Port.
4. Plug Wall Chargerinto wall
outlet. Red light next to
“Charging Port will blink RED
to show unit is charging.
5. Allow Turbo Scrub to
charge for 2 hours. Red light
will remain lit when battery is
completely charged.
6. When done, remove “Wall
Adapter” from unit and wall, and
close “Charging Port Cover”.
Do NOT exceed 12 hours of consecutive charging. Doing so
may lead to shortened overall battery life. It is not necessary
to wait until battery power is fully depleted before recharging.
CHARGING INSTRUCTIONS: On/Off
Button
Handle
Head
Wall Charger
Brush
Connector
Head/Extension
Connector
Release Button
Charging Port Cover
CONTENTS:


Specyfikacje produktu

Marka: Turbo Scrub
Kategoria: Niesklasyfikowane
Model: Lite

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Turbo Scrub Lite, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane Turbo Scrub

Turbo Scrub

Turbo Scrub Lite Instrukcja

25 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024