Instrukcja obsługi Troy-Bilt Storm 2600
Troy-Bilt
Odśnieżarka
Storm 2600
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Troy-Bilt Storm 2600 (96 stron) w kategorii Odśnieżarka. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/96
Safe Operation Practices • Assembly • Operation • Service And Maintenance
Form No. 769-26467
(May 31, 2022)
OperatOr’s anual M
Snow Blower
2-STAGE AND 3-STAGE (500, 600 & 800 SERIES)
English ...........................................................................................................................Page 2
Spanish (Español) ......................................................................................................... Page 32
French (Français) .......................................................................................................... Page 65
Model Number
Serial Number
Record Product Information
Before setting up and operating your new snowblower,
please locate the model plate on the engine and record
the information in the provided area to the right. You
can locate the model plate by standing at the operator’s
position and looking at the rear, right side of the engine.
This information will be necessary, should you seek
technical support via our web site, Customer Support
Department, or with a local authorized service dealer.
WARNING
Read and follow all safety rules and instructions in this manual before attempting to operate this machine.
Failure to comply with these instructions may result in personal injury - SAVE THESE INSTRUCTIONS.
WARNING
CALIFORNIA PROPOSITION 65
Engine Exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to State of
California to cause cancer and birth defects or other reproductive harm.
NOTE: This Operator’s Manual covers several models. Features may vary by model. Not all features in this manual are
applicable to all models and the model depicted may differ from yours.
2
SAFE OPERATION PRACTICES
Training
1. Read, understand, and follow all instructions on the machine
and in the manual(s) before attempting to assemble and
operate. Keep this manual in a safe place for future and
regular reference and for ordering replacement parts.
2. Be familiar with all controls and their proper operation. Know
how to stop the machine and disengage them quickly.
3. Never allow children under 14 years of age to operate this
machine. Children 14 and over should read and understand
the instructions and safe operation practices in this manual
and on the machine and be trained and supervised by an
adult.
4. Never allow adults to operate this machine without proper
instruction.
5. Thrown objects can cause serious personal injury. Plan your
snow-blowing pattern to avoid discharge of material toward
roads, bystanders and the like.
6. Keep bystanders, pets and children at least 75 feet from the
machine while it is in operation. Stop machine if anyone
enters the area.
7. Exercise caution to avoid slipping or falling, especially when
operating in reverse.
Preparation
Thoroughly inspect the area where the equipment is to be used.
Remove all doormats, newspapers, sleds, boards, wires and other
foreign objects, which could be tripped over or thrown by the
machine.
1. Always wear safety glasses or eye shields during operation
and while performing an adjustment or repair to protect your
eyes. Thrown objects which ricochet can cause serious injury
to the eyes.
2. Do not operate without wearing adequate winter outer
garments. Do not wear jewelry, long scarves or other loose
clothing, which could become entangled in moving parts.
Wear footwear which will improve footing on slippery
surfaces.
3. Use a grounded three-wire extension cord and receptacle for
all machines with electric start engines.
4. Adjust auger housing height to clear gravel or crushed rock
surfaces.
5. Disengage all control levers before starting the engine.
6. Never attempt to make any adjustments while engine is
running, except where specifically recommended in the
operator’s manual.
7. Let engine and machine adjust to outdoor temperature
before starting to clear snow.
WARNING
This symbol points out important safety instructions which, if not followed, could endanger the personal
safety and/or property of yourself and others. Read and follow all instructions in this manual before
attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
When you see this symbol, HEED ITS WARNING!
DANGER
This machine was built to be operated according to the safe operation practices in this manual. As with any type of
power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of
amputating fingers, hands, toes and feet and throwing debris. Failure to observe the following safety instructions could
result in serious injury or death.
3
SAFE OPERATION PRACTICES
Safe Handling of Gasoline
To avoid personal injury or property damage use extreme care
in handling gasoline. Gasoline is extremely flammable and the
vapors are explosive. Serious personal injury can occur when
gasoline is spilled on yourself or your clothes which can ignite.
Wash your skin and change clothes immediately.
1. Use only an approved gasoline container.
2. Extinguish all cigarettes, cigars, pipes and other sources of
ignition.
3. Never fuel machine indoors.
4. Never remove gas cap or add fuel while the engine is hot or
running.
5. Allow engine to cool at least 5 minutes before refueling.
6. Never over fill fuel tank. Fill tank to no more than ½ inch
below bottom of filler neck to provide space for fuel
expansion.
7. Replace gasoline cap and tighten securely.
8. If gasoline is spilled, wipe it off the engine and equipment.
Move machine to another area. Wait 5 minutes before
starting the engine. If fuel is spilled on clothing, change
clothing immediately.
9. Never store the machine or fuel container inside where there
is an open flame, spark or pilot light (e.g. furnace, water
heater, space heater, clothes dryer etc.).
10. Allow machine to cool at least 5 minutes before storing.
11. Never fill containers inside a vehicle or on a truck or trailer
bed with a plastic liner. Always place containers on the
ground away from your vehicle before filling.
12. If possible, remove gas-powered equipment from the truck or
trailer and refuel it on the ground. If this is not possible, then
refuel such equipment on a trailer with a portable container,
rather than from a gasoline dispenser nozzle.
13. Keep the nozzle in contact with the rim of the fuel tank or
container opening at all times until fueling is complete. Do
not use a nozzle lock-open device.
Operation
1. Do not put hands or feet near rotating parts, in the auger
housing or chute assembly. Contact with the rotating parts
can amputate hands and feet.
2. The auger control lever is a safety device. Never bypass its
operation. Doing so makes the machine unsafe and may
cause personal injury.
3. The control levers must operate easily in both directions
and automatically return to the disengaged position when
released.
4. Never operate with a missing or damaged chute assembly.
Keep all safety devices in place and working.
5. Never run an engine indoors or in a poorly ventilated area.
Engine exhaust contains carbon monoxide, an odorless and
deadly gas.
6. Do not operate machine while under the influence of alcohol
or drugs.
7. Muffler and engine become hot and can cause a burn. Do not
touch. Keep children away.
8. Exercise extreme caution when operating on or crossing
gravel surfaces. Stay alert for hidden hazards or traffic.
9. Exercise caution when changing direction and while
operating on slopes. Do not operate on steep slopes.
10. Plan your snow-blowing pattern to avoid discharge towards
windows, walls, cars etc. Thus, avoiding possible property
damage or personal injury caused by a ricochet.
11. Never direct discharge at children, bystanders and pets or
allow anyone in front of the machine.
12. Do not overload machine capacity by attempting to clear
snow at too fast of a rate.
13. Never operate this machine without good visibility or light.
Always be sure of your footing and keep a firm hold on the
handles. Walk, never run.
14. Release auger control lever to disengage power to the auger
when transporting or not clearing snow.
15. Never operate machine at high transport speeds on slippery
surfaces. Look down and behind and use care when backing
up.
Specyfikacje produktu
| Marka: | Troy-Bilt |
| Kategoria: | Odśnieżarka |
| Model: | Storm 2600 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Troy-Bilt Storm 2600, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Odśnieżarka Troy-Bilt
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
1 Października 2024
Instrukcje Odśnieżarka
- Odśnieżarka Worx
- Odśnieżarka BeamZ
- Odśnieżarka Honda
- Odśnieżarka Stiga
- Odśnieżarka Husqvarna
- Odśnieżarka Antari
- Odśnieżarka RYOBI
- Odśnieżarka Meec Tools
- Odśnieżarka Texas
- Odśnieżarka Snow Joe
- Odśnieżarka Alpina
- Odśnieżarka Sun Joe
- Odśnieżarka Power Craft
- Odśnieżarka Eliet
- Odśnieżarka Lumag
- Odśnieżarka Anova
- Odśnieżarka Ergie
- Odśnieżarka Soundsation
- Odśnieżarka Massimo
- Odśnieżarka Jonsered
Najnowsze instrukcje dla Odśnieżarka
12 Października 2024
8 Października 2024
8 Października 2024
5 Października 2024
2 Października 2024
2 Października 2024
29 Września 2024
29 Września 2024
29 Września 2024
29 Września 2024