Instrukcja obsługi Tripp Lite PDUMH30HV

Tripp Lite Listwa zasilająca PDUMH30HV

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tripp Lite PDUMH30HV (40 stron) w kategorii Listwa zasilająca. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/40
1
Owner’s Manual
Metered Rack PDUs
Low-Voltage Models: PDUMH15, PDUMH15S, PDUMH20
High-Voltage Models: PDUMH20HV, PDUMH30HV, PDUMH32HV
Español 9 • Français 17 • Русский 25 • Deutsch 33
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2019 Tripp Lite. All rights reserved.
PROTECT YOUR INVESTMENT!
Register your product for quicker service
and ultimate peace of mind.
You could also win an
ISOBAR6ULTRA surge protector—
a $100 value!
www.tripplite.com/warranty
18-11-317-933059.indb 1 2/20/2019 4:26:36 PM
2
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be
followed during the installation, operation and storage of this product.
Failure to heed these instructions may affect your warranty.
Important Warnings
• The PDU provides the convenience of multiple outlets, but DOES NOT provide surge or line
noise protection for connected equipment.
• The PDU is designed for indoor use only, in a controlled environment, away from excess
moisture, temperature extremes, conductive contaminants, dust or direct sunlight.
• Keep indoor ambient temperature between 32°F and 122°F (0°C and 50°C).
• The PDU must be installed by a qualified technician only.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the proper
overcurrent protection for the installation, in accordance with the plug/equipment rating.
• Connect the PDU to an outlet that is in accordance with your local building codes and that is
adequately protected against excess currents, short circuits and earth faults.
• The electrical outlets supplying power to the equipment should be installed near the equipment
and easily accessible.
• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that
eliminate the connection to ground.
• Be sure to provide a local disconnect device on any models that are permanently installed
without a plug that is easily accessible.
• Never attempt to install electrical equipment during a thunderstorm.
• Individual equipment connected to the PDU should not draw more current than the individual
PDU’s outlet’s rating.
• The total load connected to the PDU must not exceed the maximum load rating for the PDU.
• Do not attempt to modify the PDU, input plugs or power cables.
• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable
parts inside.
• Do not attempt to use the PDU if any part of it becomes damaged.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended.
Important Safety Instructions
18-11-317-933059.indb 2 2/20/2019 4:26:36 PM
3
Installation
A
B
B
C
A
1-1 B
1-2
1-3
Note: The illustrations may differ somewhat from your PDU model.
1 Determine Installation Configuration. The PDUs covered by this owner’s manual support
these installation configurations: 2U, 1U and 0U rackmount; wall-mount and under-counter.
See below for installation configurations pertaining to your specific model. Choose a
configuration and follow the installation instructions in the appropriate section of Step 1
before proceeding to Step 2.
Note: Regardless of installation configuration, the user must determine the fitness of hardware and
procedures before mounting. The PDU and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all applications. Exact mounting configurations may vary.
1-1 2U Rack Installation. Attach the
included brackets to the side of the
PDU with the included screws A. After
installing the brackets, position the
PDU in the rack and install four user-
supplied screws through the unit’s
brackets and into the rack rails B.
1-2 1U Rack Installation. Attach the PDU
to the rack by inserting four user-
supplied screws A through the PDU
mounting brackets B and into the
mounting holes of the rack rail as
shown.
1-3 0U Rack Installation. Part 1: Remove
the screws C attaching the mounting
brackets to the PDU, change the
orientation of the brackets as shown
and reattach the brackets. Use only
the screws supplied by the
manufacturer or their exact equivalent
(#6-32, 1/4” flat head). Part 2: Attach
the PDU vertically by inserting two or
more user-supplied screws A through
the PDU mounting brackets B and
into mounting points in the rack or
rack enclosure.
A
A
B
B
C
18-11-317-933059.indb 3 2/20/2019 4:26:37 PM

Specyfikacje produktu

Marka: Tripp Lite
Kategoria: Listwa zasilająca
Model: PDUMH30HV

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Tripp Lite PDUMH30HV, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Listwa zasilająca Tripp Lite

Tripp Lite

Tripp Lite Metered PDUMH20-6 Instrukcja

21 Września 2024
Tripp Lite

Tripp Lite PDUV20-60 Instrukcja

14 Września 2024
Tripp Lite

Tripp Lite PDUH32HV Instrukcja

13 Września 2024
Tripp Lite

Tripp Lite PDU3EVS6L2130 Instrukcja

11 Września 2024
Tripp Lite

Tripp Lite PDU3XMV6G32 Instrukcja

10 Września 2024
Tripp Lite

Tripp Lite PDUMH32HVATNET Instrukcja

9 Września 2024
Tripp Lite

Tripp Lite PS480806 Instrukcja

9 Września 2024
Tripp Lite

Tripp Lite PDU3V20D354A Instrukcja

9 Września 2024
Tripp Lite

Tripp Lite NSU-G24C2P08 Instrukcja

8 Września 2024
Tripp Lite

Tripp Lite PDU3VN6H50B Instrukcja

7 Września 2024

Instrukcje Listwa zasilająca

Najnowsze instrukcje dla Listwa zasilająca

Furman

Furman Merit M-8DX Instrukcja

14 Stycznia 2025
Brennenstuhl

Brennenstuhl 9+2m H07RN-F3G1,5 Instrukcja

12 Stycznia 2025
Sven

Sven SF-08E-16 Instrukcja

31 Grudnia 2025
Brennenstuhl

Brennenstuhl Estilo Instrukcja

29 Grudnia 2024
Huslog

Huslog EMX-190224 Instrukcja

24 Grudnia 2024
Vivanco

Vivanco EPLS 6ALU Instrukcja

7 Grudnia 2024
Vivanco

Vivanco EPLS 4USB_ALU Instrukcja

7 Grudnia 2024
Vivanco

Vivanco EPLS 4ALU Instrukcja

7 Grudnia 2024
Vivanco

Vivanco EPLS 3_1ALU2M Instrukcja

7 Grudnia 2024
Vivanco

Vivanco EBLS 3W2USB Instrukcja

7 Grudnia 2024