Instrukcja obsługi Tonar Wash & Dry

Tonar Niesklasyfikowane Wash & Dry

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tonar Wash & Dry (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

The aordable silent and

vinyl washing machine ...

... for an impeccable sound.

Keeping your vinyl records clean is as important as

having good equipment when you want to enjoy

an opmal sound. The Tonar Wash & Dry vinyl

washing machine oers a helping hand to make

your records shiny and bright again. With this

compact and easy-to-use device, you’re ready to

wash your complete record collecon – including

7”, 10” and 12” records – and quickly dry them

with an extremely silent, yet powerful vacuum

system.

The importance of cleaning your vinyl records

Many people associate vinyl records with hearing “pops” and “clicks”. In part, this is the charm of the medium

but it should not get over the top of course. Unless your vinyl has scratches, these pops and clicks are caused by

dust and dirt that has been collected in the grooves. Also contaminaon by air polluon from the trac outside,

cooking fat, grease and tobacco smoke can cause a tough lm to form on the surface of the record. Somemes

even molds and fungi are present if the records have been stored for a prolonged period of me in a humid

environment. If you play a dirty record, the stylus will scrape part of this dirt o the groove and this causes a

thick build-up of grime on the stylus. Ulmately, this will result in complete miss tracking or groove skipping

with permanent damage to your costly stylus and precious records.

All-in-one vinyl Wash & Dry system

The Tonar Wash & Dry is an all-in-one soluon to clean your records in the most easy way. The set includes a

high quality goat hair brush, concentrate for one liter of cleaning uid, a special stainless steel record clamp

with rubber rings to protect the label during washing, and a dust-cover. With just one single buon, you can

control the direcon of the rotaon of the plaer (clockwise or counter clockwise), and acvate the vacuum

arm. Instead of having to change vacuum arms for dierent record formats, the Tonar Wash & Dry uses only one

arm with a switch buon to change between 7”, 10” and 12” records. The vacuum system of the Tonar Wash

& Dry is extremely silent, yet very powerful. The vacuum will collect all the liquid in a reservoir inside of the

device. The wastewater level can be read-o on right hand side of the machine, and can be easily emped with

the hose.

Art. no. 5575 - Wash & Dry 220 Volt

Art. no. 16015 - Wash & Dry 110 Volt

an extremely silent yet powerful vacuum system

all-in-one vacuum arm: ready for any 7” / 10” / 12”

one single control buon: very easy to use

bi-direconal motor acon

How the Tonar Wash & Dry works:

Place the record on the small or large plaer

and then lock the record to the plaer using the

stainless steel record clamp with the label-cover.

Make sure that the vacuum arm is turned away

from the plaer.

Mix the Tonar record cleaning concentrate with 1

litre of puried water, or use the ready-to-use

QS-Tonar Vinyl Cleaning Liquid

Before applying the liquid, it is recommended to

rst remove loose dust from the record with an

an-stac record brush, such as the Tonar Dust

Away carbon ber/velvet combinaon brush.

Then turn the rotary control knob clockwise and

carefully apply the cleaning liquid drop by drop.

Applying just the right amount of cleaning uid is

an art in itself and requires some pracce. Start

with a small amount and add more if required.

Make sure the liquid is evenly distributed on

the surface using the applicaon brush. Once

you are sased with the result, gently put a bit

of pressure on the brush to clean the grooves.

Connue this operaon for 3 or 4 revoluons and

then do the same in the opposite direcon by

turning the rotary knob counter clockwise.

You are now ready to remove both dirt and liquid

using the vacuum system. Vacuuming the LP may

be done in either direcon of rotaon. Rotate the

vacuum-arm over the vinyl, towards the spindle,

then turn on the vacuum motor by pressing the

buon on the control knob. One or two rotaons

of the plaer should be sucient to vacuum and

dry the record. The velvet strips on the boom

of the vacuum-arm will remain dry or almost dry

due to the high sucon power of the Tonar Wash

& Dry.

The waste water level in the reservoir can be

checked from the hose on the right hand side of

the Tonar Wash & Dry. To empty the reservoir, pull

the hose out of the appropriate cavity and place

the hose in a bole or container. You do not have

to lt the machine; the reservoir empes

completely when the machine

simply rests on its feet.

The Tonar Wash & Dry oers a

omplete ready-to-use vinyl cleaning

et, including:

• 50 ml bole with Tonar record

cleaning uid concentrate

• goat hair applicaon brush

• power cord

• stainless steel record clamp

• black aluminum adapter disc for

singles

• label-cover

• extra 7 inch plaer

• all-in-one vacuum-arm 7”-10”-12”

• dust cover

Did you know that it’s important to clean

brand new records?

What most people don’t realise, is that brand new records actually

benet from a quick clean before you take them for a spin. But why

would you need to clean something you’ve literally just purchased?

Nearly every new vinyl record is posively charged with stac electricity.

The stac charge aracts dust and parcles in the immediate proximity,

including ny paper bers from the sleeve. This will lead to hearing

unwanted crackles and clicks while playing the record.

Also, during the producon process, oils and other gummy release

agents are used for the pressing of the records. This will leave a scky

residue on the record surface, which can, in turn, contaminate your

stylus and ulmately diminish the sound quality. Cleaning your newly

purchased records with the Tonar Wash & Dry will contribute to a beer

listening experience and long lasng preservaon of your records.

Specyfikacje produktu

Marka:	Tonar
Kategoria:	Niesklasyfikowane
Model:	Wash & Dry

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Tonar Wash & Dry, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Tonar

Tonar Wash & Dry Instrukcja

23 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024