Instrukcja obsługi Thermador VTN1DZ


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Thermador VTN1DZ (16 stron) w kategorii Czytać. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/16
THERMADOR.COM
Ventilation Blower Motor
VTN1DZ, VTN2FZ
Installation
INSTRUCTIONS
1
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Safety definitions
9 WARNING
This indicates that death or serious injuries may occur as a
result of non-observance of this warning.
9 CAUTION
This indicates that minor or moderate injuries may occur as a
result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
General information
INSTALLER: Save these instructions for the local electrical
inspector’s use. Please leave these instructions with this
unit for the owner. Show the owner the location of the
circuit breaker or fuse. Mark it for easy reference.
OWNER: Please retain these instructions for future
reference.
Check if this blower is recommended by the manufacturer
to be installed with the hood.
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
To avoid electrical shock hazard, before installing, switch
power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT use
to exhaust hazardous or explosive materials and vapors.
WARNING
To reduce the risk of fire or electric shock, do not use this
blower with any solid-state speed control device.
WARNING
This appliance must be grounded. Improper grounding
can result in a risk of electric shock. Consult a qualified
electrician if the grounding instructions are not completely
understood, or if doubt as to whether the appliance is
properly grounded.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and standards, including fire-
rated construction.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
• .USE ONLY METAL DUCTWORK
To reduce risk of fire and to properly exhaust air,
be sure to duct air outside. DO NOT vent exhaust
air in spaces with walls or ceilings or into attics,
crawl spaces or garages.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden
utilities.
2
9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Proposition 65 Warning
This product may contain a chemical known to the State of
California, which can cause cancer or reproductive harm.
Therefore, the packaging of your product may bear the
following label as required by California:
WARNING
DO NOT repair or replace any part of the appliance unless
specifically recommended in the manuals. Improper
installation, service or maintenance can cause injury or
property damage. Refer to the Installation Manual for
guidance. All servicing should be done by an authorized
service provider.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
WARNING
ELECTRICAL SHOCK HAZARD:
DO NOT remove connections.
DO NOT use an extension cord.
Remove all tape and packaging before using the
appliance. Destroy or recycle the packaging after
unpacking the appliance.
Never allow children to play with packaging material.
State of California Proposition 65 Warning:
: WARNING
Cancer and Reproductive Harm -
www.P65Warnings.ca.gov


Specyfikacje produktu

Marka: Thermador
Kategoria: Czytać
Model: VTN1DZ
Rodzaj zasilania: ATX
Szerokość produktu: 305 mm
Głębokość produktu: 234 mm
Ilość portów Ethernet LAN (RJ-45): 1
Funkcje zarządzania: WOL, WOR, Chasis Intrusion, PXE
Kanały wyjścia audio: 7.1 kan.
Liczba portów USB 2.0: 6
Producent procesora: Intel
Liczba gniazd pamięci: 4
Bez kody korekcyjnego: Tak
Maksymalna pojemność pamięci: 16 GB
Gniazdo procesora: LGA 775 (Socket T)
Rodzaj płyty: ATX
Poziomy raid: 0,1,10
Gniazdo zasilania ATX (24-pin): Tak
Ilość gniazd USB 2.0: 3
Gniazdo wentylatora procesora: Tak
Ilość gniazd w podstawie wentylatora: 2
Złącze audio na przednim panelu: Tak
Gniazdo na obudowie: Tak
Liczba portów PS/2: 2
Port wyjścia S/PDIF: Tak
Zawiera sterowniki: Tak
Układ audio: VIA VT1708S
Kontroler LAN: Atheros L1E
Złącze wentylatora: Tak
Cechy sieci: Gigabit Ethernet
Gniazdo S/PDIF: Tak
Rozmiar pamięci BIOS: 64 Mbit
Ilość portów eSATA: 1
Ilość gniazd SATA: 5
Ilość gniazd IEEE1394: 1
Wejście audio CD/AUX: Tak
Liczba portów IEEE 1394/Firewire: 1
Gniazdo rozszerzeń: 1 x PCIe 2.0 x16,\n3 x PCIe x1,\n2 x PCI
Ilość gniazd COM: 1
Kontrolujący (drugi) rodzaj interfejsu: DMA 133/100/66
Nadmiarowe kontrolery: SATA

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Thermador VTN1DZ, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Czytać Thermador

Instrukcje Czytać

Najnowsze instrukcje dla Czytać

Elica

Elica Illusion PRF0158012 Instrukcja

14 Października 2024
Elica

Elica PRF0104628A Instrukcja

13 Października 2024
Elica

Elica Glacier Instrukcja

13 Października 2024
Elica

Elica Leaf Instrukcja

13 Października 2024
Miele

Miele DA 2906 EXT Instrukcja

8 Października 2024
Miele

Miele DA 2660 Instrukcja

8 Października 2024
Ardo

Ardo VA61INOX Instrukcja

5 Października 2024
Siemens

Siemens LI64MA531 Instrukcja

23 Września 2024
Siemens

Siemens LC98BIT50I Instrukcja

23 Września 2024