Instrukcja obsługi Tecmate Optimate Lithium

Tecmate Ładowarka baterii Optimate Lithium

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tecmate Optimate Lithium (40 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/40
PT
CZ
Automatic charger for 12.8V LiFePO4 batteries
Chargeur automatique pour batteries 12.8V LiFePO4
Cargador automático para baterías 12.8V LiFePO
4
Automatische Ladegerät für 12.8V LiFePO
4 Batterien
Automatische lader voor 12.8V LiFePO4 accu’s
Caricabatterie automatico per batterie 12.8V LiFePO
4
Carregador automático para baterias de 12.8V LiFePO
4
Automatisk diagnostisk laddare för 12.8V LiFePO
4-
batterier
Automatická diagnostic naječka pro 12,8v baterie
LiFePO4
MODEL: TM290 (EU), TM291 (US), TM294 (UK),
TM298 (AU)
AC: 100 240V 50-60Hz
0.85A @ 240V / 1.5A @ 100V
DC: 60W 12V 5A ¨
Thermally adjusted
INSTRUCTIONS FOR USE
IMPORTANT: Read completely
before charging
MODE D’EMPLOI
IMPORTANT: à lire avant
d’utiliser l’appareil
MODO DE EMPLEO
IMPORTANTE: a leer antes
de utilizar el aparato
ANWENDUNGSVORSCHRIFTEN
WICHTIG: Vollständig vor der
Benutzung lesen
GEBRUIKSAANWIJZING
BELANGRIJK: Lees volledig
voor gebruik
ISTRUZIONI PER L’USO
IMPORTANTE: da leggere prima
di utilizzare l’apparecchio
INSTRUKTIONER VIKTIGT: läs
följande fullständiga instruk-
tioner för användningen innan
du använder laddaren
INSTRUÇÕES DE UTILIZAÇÃO
IMPORTANTE: Ler antes de
utilizar.
INSTRUKCE PRO POUŽIT.
LEŽIT: Přečtěte si pozorně
před použit.m
Save Charge Maintain Test
Save Charge Maintain Test
1 x 12.8V (4 x 3.2V cells) LiFePO4
Lithium Iron Phosphate
2.5 - 100Ah (charge within 24 hours)
+ -
10 STEPS
TM29x-IN1-170306
copyright @ 2017 TecMate International
10
OptiMate
maintenance
9
TEST after
CHARGE
1
Low Volt
Start (0.5V)
2
TEST before
charge
3
Temperature
check
4
Ultra LOW
VOLT SAVE
5
LOW VOLT
SAVE /
cellmonitoring
6
TEST -
cell damage
7
Cell-balancing
CHARGE
8
OPTIMIZE
0.5V
13.6V
14.4V
4&5.SAVE 6.TEST 7.CHARGE 8.OPTIMIZE 9.TEST 10. MAINTAIN
1.START 2.TEST 3.TEMP
24-7-365
°C/°F
40
-20
0
104
32
-4
2
1
876
5
4
3
TEST > LEDs
TEST
30m - 12h
MAINTAIN
365
CHARGE
24h max
SAVE
15m - 4h
OPTIMIZE
10m - 12h
TEST
10s
6
7
8
34566
LED PANEL
876
90 100%603010%
13.3V 13.6V+ 13.13V13.00V12.80VV
87 7 6
0
10V
3
BMS RESET
PROGRAM > LEDs
2
3
IMPORTANT SAFETY
INSTRUCTIONS FOR CANADA & USA
THIS PORTION OF THE MANUAL CONTAINS IMPORTANT SAFETY INSTRUCTIONS FOR THE OptiMate
LITHIUM BATTERY CHARGER. IT IS OF THE UTMOST IMPORTANCE THAT EACH TIME, BEFORE
USING THE CHARGER, YOU READ AND EXACTLY FOLLOW THESE INSTRUCTIONS. SAVE THESE
INSTRUCTIONS.
AUTOMATIC CHARGER ONLY FOR 12.8V LIFEPO4 (LITHIUM IRON PHOSPHATE ) BATTERIES.
A rechargeable LIFEPO4 battery should comply with IEC62133*.
DO NOT USE FOR NiCd, NiMH, Lead-Acid or any other type of Li-Ion or
NON-RECHARGEABLE BATTERIES.
*IEC62133 - Safety requirements for portable sealed secondary cells containing alkaline or other
non acid electrolytes and for batteries made from them, for use in portable applications.
1. CAUTION : CLASS II APPLIANCE. DO NOT CONNECT TO GROUND.
2. For indoor use only. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock,or injury to persons.
4. To reduce risk of damage to electric plug and cord,pull by plug rather than cord when disconnecting charger.
5. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock.If
extension cord must be used make sure that :
a) pins on plug of extension cord are the same number, size and shape as those of plug on charger.
b) the extension cord is property wired and in good electrical condition,and
c) the conductor wire size is large enough for the AC ampere rating of the charger as specified in the table below.
AC INPUT RATING IN AMPERES
Equal to or greater than But less than
LENGTH OF CORD, FEET
(m)
AWG SIZE OF
CORD
2A 3A 25 (17.6)
50 (15.2)
100 (30.5)
18
18
14
6. Do not operate charger with damaged cord or plug - replace the cord or plug immediately.
7. Do not operate charger if it has received a sharp blow, been dropped,or otherwise damaged in any way; take it to a qualified serviceman.
8. Do not disassemble charger; take it to a qualified serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.Clean only with slightly moist,not wet, cloth.Do not use solvents.
10. WARNING - RISK OF EXPLOSIVE GASES.
a) WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. B ATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR
THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
b) To reduce risk of battery explosion,follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you
intend to use in vicinity of the battery. Review cautionary marking on these products and on engine.
11. PERSONAL PRECAUTIONS.
a) Someone should be within range of your voice OR close enough to come to your aid when you work near a battery.
b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while working near a battery.
d) If battery acid contacts or enters eye, flood eye with cold running water for at least 10 minutes and get medical attention immediately. If battery acid
contacts skin or clothing, wash immediately with soap & water. If acid enters an eye , immediately flood eye with running cold water for at least 10 minutes
& get medical attention immediately.
e) NEVER smoke or allow a spark or flame in vicinity of battery or engine.
f) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause
explosion.
g) Remove personal metal items such as rings, bracelets ,necklaces , and watches when working with a battery. A battery can produce a short-circuit
current high enough to weld a ring or the like to metal, causing a severe burn.
i) NEVER charge a frozen battery.
12. PREPARING TO CHARGE
a) If necessary to remove battery from vehicle to charge,always remove grounded terminal from battery first.
Make sure all accessories in the vehicle are off, so as not to cause an arc.
b) Be sure area around battery is well ventilated while battery is being charged. Gas can be forcefully blown
SAFETY US & CAN


Specyfikacje produktu

Marka: Tecmate
Kategoria: Ładowarka baterii
Model: Optimate Lithium

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Tecmate Optimate Lithium, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Ładowarka baterii Tecmate

Instrukcje Ładowarka baterii

Najnowsze instrukcje dla Ładowarka baterii

MSW

MSW S-CHARGER-20A.2 Instrukcja

15 Października 2024
MSW

MSW S-CHARGER-10A.2 Instrukcja

15 Października 2024
Intenso

Intenso Powerbank 10400 Instrukcja

14 Października 2024
Gembird

Gembird CHM-03 Instrukcja

10 Października 2024
Kostal

Kostal IQ 8.5 Instrukcja

9 Października 2024
Venom

Venom VS5007 Instrukcja

9 Października 2024
Venom

Venom VS5010 Instrukcja

9 Października 2024
Venom

Venom VS2891 Instrukcja

9 Października 2024
Venom

Venom VS2881 Instrukcja

9 Października 2024
Venom

Venom VS2883 Instrukcja

9 Października 2024