Instrukcja obsługi Teac PD-501HR-S

Teac odtwarzacz CD PD-501HR-S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Teac PD-501HR-S (43 stron) w kategorii odtwarzacz CD. Ta instrukcja była pomocna dla 30 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/43
D01179820B
Z
PD-501HR
CD Player
OWNER’S MANUAL
MODE D’EMPLOI
MANUAL DEL USUARIO
2
IMPORTANT SAFETY PRECAUTIONS
CAUTION
o DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO
EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS
ARE INSIDE.
o IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
o USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IN USA/CANADA, USE ONLY ON 120 V SUPPLY.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
For Canada
Industry Canada’s Compliance Statement:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
For U.S.A.
This equipment complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions: 1) This device may not
cause interference and 2) This device must accept any interference,
including interference that may cause undesired operation of the
device.
Information to the user:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the equipment and/or the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
Changes or modifications to this equipment not expressly approved
by TEAC CORPORATION for compliance will void the user’s warranty.
“DSD” is a registered trademark.
Other company names and product names in this document are the trademarks or registered trademarks of their respective owners.
3
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with
the manufacturer's instructions.
8)
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
o The apparatus draws nominal non-operating power from the AC
outlet with its POWER or STANDBY/ON switch not in the ON position.
o The mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
o Caution should be taken when using earphones or headphones
with the product because excessive sound pressure (volume) from
earphones or headphones can cause hearing loss.
o Do not expose this apparatus to drips or splashes.
o Do not place any objects filled with liquids, such as vases, on
the apparatus.
o Do not install this apparatus in a confined space such as a book
case or similar unit.
o The apparatus should be located close enough to the AC outlet
so that you can easily reach the power cord plug at any time.
o If the product uses bat teries (including a battery pack or
installed batteries), they should not be exposed to sunshine, fire
or excessive heat.
o CAUTION for products that use replaceable lithium batteries: there
is danger of explosion if a battery is replaced with an incorrect
type of battery. Replace only with the same or equivalent type.
Products with Class construction are equipped with a power sup-
ply cord that has a grounding plug. The cord of such a product
must be plugged into an AC outlet that has a protective ground-
ing connection.
CAUTION
WARNING
Q Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading
to fire, injury or the staining of nearby things. Please read and
observe the following precautions carefully.
oBe sure to insert the batteries with correct positive (+) and
negative (_) orientations.
oUse batteries of the same type. Never use different types of bat-
teries together.
oIf the remote control is not used for a long time (more than a
month), remove the batteries to prevent them from leaking.
oIf the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
oDo not use batteries of types other than those specified. Do not
mix new batteries with old ones or use different types of batter-
ies together.
oDo not heat or disassemble batteries. Never throw batteries into
fire or water.
oDo not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
oNever recharge a battery unless it is confirmed to be a recharge-
able type.
This product has been designed and manufactured according to FDA
regulationstitle 21, CFR, chapter 1, subchapter J, based on the
Radiation Control for Health and Safety Act of 1968”, and is classified as
class laser product. There is not hazardous invisible laser radiation
during operation because invisible laser radiation emitted inside of
this product is completely confined in the protective housings.
The label required in this regulation is as follows:
&(57,),&$7,21
5)*4 130%6$5 $0.1-*&4 8*5)  $'3
  "/%   &9$&15 '03
%&7*"5*0/4 16346"/5 50 -"4&3 /05*$&
/0  %"5&% +6/&  
&$87,21 
&/$66 % 9,6,%/( $1' ,19,6,%/( /$6(5 5$',$7,21
:+(1 23(1
$92,' (;32685( 72 7+( %($0
9256,&+7 
6,&+7%$5( 81' 816,&+7%$5( /$6(5675$+/81*
./$66( % :(11 *(g))1(7
1,&+7 '(0 675$+/ $866(7=(1
注意 - 打开时有%类可见及不可见激光辐射
避免光束照
Laser :
Type: SW 653L VP
Manufacturer: Hitachi Media Electronics Co., Ltd.
Laser output:
90.1 mW (DVD) and 144 mW (CD) on the objective
lens (Typical)
Wavelength: 785 nm (CD) typ
661 nm (DVD) typ
Standard: IEC60825-1: 2007


Specyfikacje produktu

Marka: Teac
Kategoria: odtwarzacz CD
Model: PD-501HR-S
Kolor produktu: Srebrny
Rodzaj zasilania: Prąd przemienny
Wysokość produktu: 81.2 mm
Szerokość produktu: 290 mm
Głębokość produktu: 244 mm
Waga produktu: 4200 g
Zakres temperatur (eksploatacja): 5 - 35 °C
Obsługiwane formaty audio: CD-A, DSD, PCM, WAV
Przewody: Prąd przemienny
Wyjście liniowe: Tak
Współczynnik zawartości harmonicznych: 0.0013 %
Stosunek sygnału do szumu: 116 dB
Zasięg częstotliwości: 20 - 80000 Hz
Zmieniarka CD: Nie
Zakres dynamiczny: 103 dB
Wejście cyfrowe audio: 1
Odtwarzacz CD-R: Tak
Odtwarzacz CD-RW: Tak
Wyjście cyfrowe audio: 1
Cyfrowy tuner: Nie

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Teac PD-501HR-S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje odtwarzacz CD Teac

Instrukcje odtwarzacz CD

Najnowsze instrukcje dla odtwarzacz CD

Tascam

Tascam CD-A700 Instrukcja

7 Października 2024
Ideen Welt

Ideen Welt K 1216 N Instrukcja

28 Września 2024
Tascam

Tascam CD-RW901MKII Instrukcja

28 Września 2024
Tascam

Tascam CD-200iB Instrukcja

28 Września 2024
Tascam

Tascam cdrw900 Instrukcja

28 Września 2024
Tascam

Tascam CD-RW900MKII Instrukcja

28 Września 2024
Quadral

Quadral Aurum C8 Instrukcja

27 Września 2024
Elta

Elta 5786 Instrukcja

27 Września 2024
Audiolab

Audiolab 8200CDQ Instrukcja

27 Września 2024
Mx Onda

Mx Onda MXDM114 Instrukcja

26 Września 2024