Instrukcja obsługi Tascam CD-302

Tascam Odtwarzacze/nagrywarki CD CD-302

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tascam CD-302 (32 stron) w kategorii Odtwarzacze/nagrywarki CD. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/32

CD-302

Dual CD Player

OWNER’S MANUAL

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The exclamation point within an equilateral triangle is intended to alert the user to the pres-

ence of important operating and maintenance (servicing) instructions in the literature

accompanying the appliance.

The lightning ﬂash with arrowhead symbol, within an equilateral triangle, is intended to alert

the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure

that may be of sufﬁcient magnitude to constitute a risk of electric shock to persons..

This appliance has a serial number

located on the rear panel. Please record

the model number and serial number

and retain them for your records.

Model number

Serial number

WARNING: TO PREVENT FIRE OR SHOCK

HAZARD, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

9101429501

BRAKEBRAKE

2 TASCAM CD-302

Important Safety Precautions

Note for U.K. Customers

DO NOT cut o the mains plug from this

equipment.

If the plug tted is not suitable for the power points in

your home or the cable is too short to reach a power

point, then obtain an appropriate safety approved

extension lead or consult your dealer.

If nonetheless the mains plug is cut o, remove the fuse

and dispose of the plug immediately, to avoid a possible

shock hazard by inadvertent connection to the mains

supply.

If this product is not provided with a mains plug, or one

has to be tted, then follow the instructions given

below:

IMPORTANT: DO NOT make any connection to the

larger terminal which is marked with the letter E or by

the safety earth symbol ç or coloured GREEN or

GREEN-and-YELLOW.

The wires in the mains lead on this product are coloured

in accordance with the following code:

BLUE : NEUTRAL

BROWN : LIVE

As these colours may not correspond with the coloured

markings identifying the terminals in your plug proceed

as follows:

The wire which is coloured BLUE must be connected

to the terminal which is marked with the letter N or

coloured BLACK.

The wire which is coloured BROWN must be

connected to the terminal which is marked with the

letter L or coloured RED.

When replacing the fuse only a correctly rated

approved type should be used and be sure to re-t the

fuse cover.

IF IN DOUBT — CONSULT A COMPETENT

ELECTRICIAN.

TO THE USER

This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference when the equipment is operated in a

commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the

instruction manual, may cause harmful interference to

radio communications.

Operation of this equipment in a residental area is

likely to cause harmful interference in which case the

user will be required to correct the interference at his

own expense.

CAUTION

Changes or modications to this equipment not

expressly approved by TEAC CORPORATION for

compliance could void the user’s authority to operate

this equipment.

TASCAM CD-302

CAUTION:

…

Read all of these Instructions.

…

Save these Instructions for later use.

…

Follow all Warnings and Instructions marked on the audio

equipment.

1) Read Instructions

— All the safety and operating instructions should

be read before the product is operated.

2) Retain Instructions

— The safety and operating instructions should

be retained for future reference.

3) Heed Warnings

— All warnings on the product and in the operating

instructions should be adhered to.

4) Follow Instructions

— All operating and use instructions should be

followed.

5) Cleaning

— Unplug this product from the wall outlet before cleaning.

Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for clean-

ing.

6) Attachments

— Do not use attachments not recommended by the

product manufacturer as they may cause hazards.

7) Water and Moisture

— Do not use this product near water — for

example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet

basement; or near a swimming pool; and the like.

8) Accessories

— Do not place this product on an unstable cart, stand,

tripod, bracket, or table. The product may fall, causing serious injury to a

child or adult, and serious damage to the product. Use only with a cart,

stand, tripod, bracket, or table recommended by the manufacturer, or sold

with the product. Any mounting of the product should follow the manufac-

turer’s instructions, and should use a mounting accessory recommended by

the manufacturer.

A product and cart combination should be moved with care. Quick

stops, excessive force, and uneven surfaces may cause the product and cart

combination to overturn.

10)

Ventilation

— Slots and openings in the cabinet are provided for ven-

tilation and to ensure reliable operation of the product and to protect it

from overheating, and these openings must not be blocked or covered. The

openings should never be blocked by placing the product on a bed, sofa,

rug, or other similar surface. This product should not be placed in a built-in

installation such as a bookcase or rack unless proper ventilation is provided

or the manufacturer’s instructions have been adhered to.

11) Power Sources

— This product should be operated only from the

type of power source indicated on the marking label. If you are not sure of

the type of power supply to your home, consult your product dealer or local

power company. For products intended to operate from battery power, or

other sources, refer to the operating instructions.

12) Grounding or Polarization

— This product may be equipped with

a polarized alternating-current line plug (a plug having one blade wider

than the other). This plug will fit into the power outlet only one way. This

is a safety feature. If you are unable to insert the plug fully into the outlet,

try reversing the plug. If the plug should still fail to t, contact your electri-

cian to replace your obsolete outlet. Do not defeat the safety purpose of the

polarized plug.

13) Power-Cord Protection

— Power-supply cords should be routed so

that they are not likely to be walked on or pinched by items placed upon or

against them, paying particular attention to cords at plugs, convenience

receptacles, and the point where they exit from the product.

14) Outdoor Antenna Grounding

— If an outside antenna or cable

system is connected to the product, be sure the antenna or cable system is

grounded so as to provide some protection against voltage surges and built-

up static charges. Article 810 of the National Electrical Code, ANSI/NFPA

70, provides information with regard to proper grounding of the mast and

supporting structure, grounding of the lead-in wire to an antenna discharge

unit, size of grounding conductors, location of antenna-discharge unit, con-

nection to grounding electrodes, and requirements for the grounding elec-

trode.

"Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to

Section 820-40 of the NEC which provides guidelines for proper grounding

and, in particular, specifies that the cable ground shall be connected to the

grounding system of the building, as close to the point of cable entry as

practical.

15) Lightning

— For added protection for this product during a lightning

storm, or when it is left unattended and unused for long periods of time,

unplug it from the wall outlet and disconnect the antenna or cable system.

This will prevent damage to the product due to lightning and power-line

surges.

16) Power Lines

— An outside antenna system should not be located in

the vicinity of overhead power lines or other electric light or power circuits,

or where it can fall into such power lines or circuits. When installing an

outside antenna system, extreme care should be taken to keep from touch-

ing such power lines or circuits as contact with them might be fatal.

17) Overloading

— Do not overload wall outlets, extension cords, or

integral convenience receptacles as this can result in risk of fire or electric

shock.

18) Object and Liquid Entry

— Never push objects of any kind into

this product through openings as they may touch dangerous voltage points

or short-out parts that could result in a fire or electric shock. Never spill

liquid of any kind on the product.

19) Servicing

— Do not attempt to service this product yourself as open-

ing or removing covers may expose you to dangerous voltage or other

hazards. Refer all servicing to qualied service personnel.

20) Damage Requiring Service

— Unplug this product from the wall

outlet and refer servicing to qualied service personnel under the following

conditions:

when the power-supply cord or plug is damaged.

if liquid has been spilled, or objects have fallen into the product.

if the product has been exposed to rain or water.

if the product does not operate normally by following the operating

instructions. Adjust only those controls that are covered by the operating

instructions as an improper adjustment of other controls may result in

damage and will often require extensive work by a qualified technician to

restore the product to its normal operation.

if the product has been dropped or damaged in any way.

f )

when the product exhibits a distinct change in performance – this

indicates a need for service.

21) Replacement Parts

— When replacement parts are required, be

sure the service technician has used replacement parts specified by the

manufacturer or have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock, or other

hazards.

22) Safety Check

— Upon completion of any service or repairs to this

product, ask the service technician to perform safety checks to determine

that the product is in proper operating condition.

23) Wall or Ceiling Mounting

— The product should be mounted to a

wall or ceiling only as recommended by the manufacturer.

24) Heat

— The product should be situated away from heat sources such

as radiators, heat registers, stoves, or other products (including amplifiers)

that produce heat.

ANTENNA

LEAD IN

WIRE

ANTENNA

DISCHARGE UNIT

(NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250. PART H)

NEC - NATIONAL ELECTRICAL CODE

ELECTRIC

SERVICE

EQUIPMENT

Example of Antenna Grounding as per

National Electrical Code, ANSI/NFPA 70

GROUND

CLAMP

IMPORTANT SAFETY INSTRUCTIONS

Specyfikacje produktu

Marka:	Tascam
Kategoria:	Odtwarzacze/nagrywarki CD
Model:	CD-302

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Tascam CD-302, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Odtwarzacze/nagrywarki CD Tascam

Tascam CD-RW901SL Instrukcja

4 Października 2024

Tascam CD-VT1 Instrukcja

24 Września 2024

Tascam CD-A750 Instrukcja

16 Września 2024

Tascam CD-160 Instrukcja

14 Września 2024

Tascam CC-222SL Instrukcja

12 Września 2024

Tascam CD-X1700 Instrukcja

3 Września 2024

Tascam CD-302 Instrukcja

30 Sierpnia 2024

Tascam CD-VT1MKII Instrukcja

22 Sierpnia 2024

Tascam CD-A630 Instrukcja

13 Sierpnia 2024

Tascam CD-200SB Instrukcja

13 Sierpnia 2024

Instrukcje Odtwarzacze/nagrywarki CD

Najnowsze instrukcje dla Odtwarzacze/nagrywarki CD

Marantz PMD351 Instrukcja

15 Października 2024

Kärcher MC 6430 Instrukcja

11 Października 2024

Technics SL-PA10 Instrukcja

11 Października 2024

Reflexion PCD520MF Instrukcja

9 Października 2024

Auna Reference 802 Instrukcja

9 Października 2024

Advance X-CD1000 EVO Instrukcja

9 Października 2024

Soundmaster SCD6500USB Instrukcja

8 Października 2024

Shanling EC mini Instrukcja

7 Października 2024

Shanling CD80 Instrukcja

7 Października 2024

Shanling SCD1.3 Instrukcja

7 Października 2024