Instrukcja obsługi Structural Concepts HMBC5-E3


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Structural Concepts HMBC5-E3 (38 stron) w kategorii lodówka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/38
Note 1: HMBC2 and HMBC3
have an undivided upper
section.
Note 2: HMBC4, HMBC5,
HMBC6 have an divided upper
section (as shown above).
Model HMBC6
Is Shown Above
Rev G Date: 8.16.2019
I:\Oper Manuals\Standard\Harmony_Combo_Conv_Svc_Abv_Rfg_Slf Svc_Oper_Manual_54383.pub-
Structural Concepts Corporation E. Porter Road Muskegon, MI 49441 Phone: 231.798.8888 Fax: 231.798.4960 www.structuralconcepts.com∙ 888
34” DEEP COMBINATION CONVERTIBLE SERVICE ABOVE REFRIGERATED SELF SERVICE CASE-
PLEASE NOTE THE FOLLOWING:
1. THIS OPERATING MANUAL IS APPLICABLE TO MODELS HMBC2, HMBC3, HMBC4, HMBC5 AND
HMBC6 (AND POSSIBLY OTHER MODELS).
2. YOUR SPECIFIC MODEL NUMBER IS LOCATED ON THE SERIAL LABEL ON CASE REAR (NEAR
MAIN POWER SWITCH).
READ AND SAVE THESE INSTRUCTIONS
P/N 54383
INSTALLATION AND
OPERATING MANUAL
2
TABLE OF CONTENTS
TABLE OF CONTENTS ………………………………………………………………………………….…...
OVERVIEW / NSF® TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS …………………...…...
INSTALLATION: REMOVAL FROM SKID / POSITIONING & ALIGNING CASE / ADJUSTING
LEVELERS ……………………………………………………………....……...…….……………….
INSTALLATION: LOWER FRONT GRILLE and LOWER REAR PANEL REMOVAL /
REPLACEMENT……………………………………………………………………………………….
INSTALLATION: ELECTRICAL CONNECTIONS …………………………………………………………
INSTALLATION: POSITIONING AND ALIGNING UNITS / GLASS SHELVING ……………………...
INSTALLATION: SETUP / POWER CORDS / TEMPERATURE CONTROLLER ……….……….…...
INSTALLATION, CONTINUED: REMOTE UNIT ELECTRICAL LEADS / REFRIGATION & DRAIN
CONNECTIONS …………...………………………………………………...……………………......
INSTALLATION: CASTERS / LEVELERS / CURVED GLASS / REAR DOORS ………………......
INSTALLATION: DISPLAY CASE START UP, LIGHT SWITCH, TEMPERATURE CONTROLLER, -
SATURATED SUCTION TEMPERATURE ………………………………………………………...
INSTALLATION: LED AND FLUORESCENT LIGHTS …………………………………………………...
INSTALLATION: FRONT GLASS ALIGNMENT & ADJUSTMENT ……………………………………..
INSTALLATION: BAFFLES AMBIENT VS. REFRIGERATED CONDITIONS -……………………….
OPTIONAL NIGHT AIR CURTAIN INSTALLATION & OPERATING INSTRUCTIONS ……………...
SECURITY GRID INSTRUCTIONS (OPTIONAL) …………………………………………………….…...
DRAIN, HOSE AND BRACKET PLACEMENT ILLUSTRATIONS …………..…………..……….……..
CLEANING SCHEDULE (TO BE PERFORMED BY STORE PERSONNEL) ……....…………...……..
TROUBLESHOOTING (TO BE PERFORMED BY STORE PERSONNEL) …………………………….
MAINTENANCE (TO BE PERFORMED BY STORE PERSONNEL): REAR DOORS & LIGHT
FIXTURES .................................................................................................................... .............
MAINTENANCE (TO BE PERFORMED BY STORE PERSONNEL): BRACKET RETAINERS /
SHELVES ……………………………………………………………………………………………...
MAINTENANCE (TO BE PERFOMRED BY TRAINED SERVICE PROVIDERS ONLY): TUB AND
EVAPORATOR COIL AREA ACCESS …………………………………………………………….
MAINTENANCE (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY):
CONDENSER PACKAGE / TEMPERATURE CONTROLLER ……….………………………..
MAINTENANCE (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY):
HONEYCOMB AIR DIFFUSER ……………………………………………………………………..
TROUBLESHOOTING GENERAL (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS -
ONLY) .….……………………………………………………………………………………………..
TROUBLESHOOTING CONDENSING SYSTEM (TO BE PERFORMED BY TRAINED SERVICE -
PROVIDERS ONLY) ...……………………………………………………………………………….
TROUBLESHOOTING EVAPORATOR SYSTEM (TO BE PERFORMED BY TRAINED SERVICE -
PROVIDERS ONLY) ….……………………………………………………………………………...
PREVENTIVE MAINTENANCE (TO BE PERFORMED BY TRAINED SERVICE PROVIDERS
ONLY) …....................................................................................................................................
SERIAL LABEL INFORMATION & LOCATION ..…………………………………...…....…….....…
TEMPERATURE CONTROLLER CAREL® -...…..……………………..……..…………………...……..
TECHNICAL SERVICE CONTACT INFORMATION & WARRANTY INFORMATION ...……….….....
2
3 4-
5
6
7
8
9
10
11
12
13
14
15
16
17 18-
19
20
21
22
23
24
25
26
27 29-
30
31
32 33-
34
35 37-
38
3
OVERVIEW / NSF® TYPE / COMPLIANCE / WARNINGS / PRECAUTIONS PAGE 1 of 2 -
WARNING
Hazardous moving parts. Do not operate unit with covers removed.
Fan blades may be exposed when deck panel is removed.
Disconnect power before removing deck panel.
WARNING
Risk of electric shock. Disconnect power before servicing unit.
CAUTION! More than one source of electrical supply is
employed with units that have separate circuits.
Disconnect ALL ELECTRICAL SOURCES before servicing.
WARNING
ELECTRICAL
HAZARD
WARNING
KEEP
HANDS
CLEAR
OVERVIEW
These Structural Concepts Harmony® cases are
designed to merchandise packaged products at 41°F
(5 °C) or less product temperatures (unless custom
cases with wire rack shelving).
Cases should be installed and operated according to
this operating manual s instructions to insure proper
performance. Improper use will void warranty.
TYPE I vs. TYPE II ENVIRONMENTAL CONDITIONS
This unit is designed for the display of products in
ambient store conditions where temperature and
humidity are maintained within a specific range.
Type I display refrigerators are intended for use in an
area where environmental conditions are controlled
and maintained so that the ambient temperature does
not exceed 75 °F (24 °C) and 55% maximum humidity.
Type II display refrigerators are intended for use in an
area where environmental conditions are controlled and
maintained so that the ambient temperature does not
exceed 80 °F (27 °C) and 55% maximum humidity.
If unsure if your unit is Type I or II, see tag next to serial
label. See SERIAL LABEL LOCATION & INFORMATION
LISTED / TECH INFO & SERVICE section in this
manual for sample serial labels.
COMPLIANCE
Performance issues when in violation of applicable
NEC, federal, state and local electrical and plumbing
codes are not covered by warranty.
WARNINGS
Following are important warnings to prevent injury or
death. Please read carefully!
COMPLIANCE
This equipment MUST be installed in compliance with all applicable
NEC, federal, state and local electrical and plumbing codes.
ATTENTION CONTRACTORS
CAUTION! CHECK CONDENSATE PAN POSITION & PLUG
Water on flooring can cause extensive damage!
Before powering up unit, check and confirm that:
Condensate pan is DIRECTLY UNDER condensate drain.
Condensate pan plug is securely plugged into receptacle.
Overflow pan has plug connected to its box. Units with optional
CleanSweep® MUST HAVE two plugs connected.
WARNING: This product can expose you to chemicals, including
Urethane (Ethyl Carbamate), which are known to the state of
California to cause cancer and birth defects or other reproductive
harm. For more information go to P65Warnings.ca.gov.


Specyfikacje produktu

Marka: Structural Concepts
Kategoria: lodówka
Model: HMBC5-E3

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Structural Concepts HMBC5-E3, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje lodówka Structural Concepts

Instrukcje lodówka

Najnowsze instrukcje dla lodówka

Samsung

Samsung RT32K5030EF Instrukcja

15 Października 2024
Liebherr

Liebherr CBNes 4875 Instrukcja

15 Października 2024
Frigidaire

Frigidaire FFPH44M4LM Instrukcja

15 Października 2024
AEG

AEG Santo 70318 KG1 Instrukcja

15 Października 2024
Whirlpool

Whirlpool ART 550 Instrukcja

15 Października 2024
Indesit

Indesit TLA 1 (UK) (0) Instrukcja

15 Października 2024
Hotpoint

Hotpoint HTH18GBCCC Instrukcja

15 Października 2024
Zanker

Zanker ZKK8021 Instrukcja

15 Października 2024
Hoover

Hoover HFF 618 DW Instrukcja

15 Października 2024
Frigidaire

Frigidaire FRT15HB3DQ Instrukcja

15 Października 2024