Instrukcja obs艂ugi Stiga 110 S
Stiga
Tuingereedschap overig
110 S
Przeczytaj poni偶ej 馃摉 instrukcj臋 obs艂ugi w j臋zyku polskim dla Stiga 110 S (5 stron) w kategorii Tuingereedschap overig. Ta instrukcja by艂a pomocna dla 3 os贸b i zosta艂a oceniona przez 2 u偶ytkownik贸w na 艣rednio 4.5 gwiazdek
Strona 1/5
8211-3009-06
H
G
F
1.
2.
3.
4.
ENGLISH GB
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction book and safety man-
ual before using the machine.
Warning!
Do not put hands or feet under the cover of
the machine when it is running.
Warning!
Beware of objects being flung out. Keep
spectators away.
Beforestartinganyrepairwork, removethe
spark plug cable from the spark plug.
PREPARATION
If this clipping unit is used with the Park model,
the number of revolutions per minute should be re-
duced slightly in order to comply with the current
regulations for approved noise levels:
- Senator and President models: reduce to 3,000
rpm
- Royal, Pro 16, Pro 18 and Pro 20 models: re-
duce to 3,200 rpm
This adjustment torpm shouldonlybe madeby the
retaileroratanauthorisedworkshop,i.e.bypeople
who have the correct skills and equipment.
ASSEMBLY
MOWER DECK
1. Fit the support wheels and the deflector as show
in figure 1.
2. Fit the attachment brackets D on the front axle
studs by using the washers and locking clips (fig 2).
3. Slide in the attachment's fixing arms into the ma-
chine's attachment brackets.
4. Set the v-belt on the machine'scentral belt pulley
F(fig3).
5. The tension roller G should rest on the left-hand
side of the v-belt, seen from the driver's seat (fig 3).
6. Now pull the mower deck forwards so that the
holes in the fixing arms correspond with the holes
on the attachment brackets.
7. Insert the screws and tighten.
8a. Park -1999:
Hook the tension roller spring H into the floor on
the right-hand side (fig 3).
8b. Park 2000-
Hook the tension roller spring H into the fastener,
just behind the front right wheel (fig 3).
9. Lift up the mower deck and hook the chain into
the attachment lifter.
Whenchangingthev-beltordismantlingthemower
deck follow the above procedures in the reverse or-
der.
SETTING
1. Check that the tyres have the correct air pressure.
Front: 0,6 bar (9 psi).
Rear: 0,4 bar (6 psi).
2. To obtain an even cut from the mower deck its
forward and rear edges must be parallel to the
ground.
- Check this by placing the machine on a flat sur-
face.
- If adjustmentis required,adjust using the washers
I at the support wheels (fig 1).
Points 1 and 2 must be carried out for the mower
deck to mow evenly.
USE
MOWING HEIGHT
Themowerdeckhas17fixedmowingheights,from
30 mm to 80 mm.
N.B. The stated mowing heights apply when the
machine is standing on firm ground.
Specyfikacje produktu
| Marka: | Stiga |
| Kategoria: | Tuingereedschap overig |
| Model: | 110 S |
Potrzebujesz pomocy?
Je艣li potrzebujesz pomocy z Stiga 110 S, zadaj pytanie poni偶ej, a inni u偶ytkownicy Ci odpowiedz膮
Instrukcje Tuingereedschap overig Stiga
21 Wrze艣nia 2024
Instrukcje Tuingereedschap overig
- Tuingereedschap overig Stihl
- Tuingereedschap overig Gardena
- Tuingereedschap overig Einhell
- Tuingereedschap overig Hyundai
- Tuingereedschap overig Fuxtec
- Tuingereedschap overig Wolf Garten
- Tuingereedschap overig GLORIA
- Tuingereedschap overig Hozelock
- Tuingereedschap overig Texas
- Tuingereedschap overig Florabest
- Tuingereedschap overig Toro
- Tuingereedschap overig Eurom
- Tuingereedschap overig Gamma
- Tuingereedschap overig Kibani
- Tuingereedschap overig Grouw
- Tuingereedschap overig Lumag
Najnowsze instrukcje dla Tuingereedschap overig
23 Wrze艣nia 2024
23 Wrze艣nia 2024
22 Wrze艣nia 2024
21 Wrze艣nia 2024
19 Wrze艣nia 2024
11 Wrze艣nia 2024
11 Wrze艣nia 2024
7 Wrze艣nia 2024
7 Wrze艣nia 2024
4 Wrze艣nia 2024