TM
INSTRUCTION GUIDE
TM and © Spin Master Ltd. All rights reserved. • Please retain this information for
future reference. • Please remove all packaging materials before giving to children.
• An adult should periodically check this toy to ensure no damage or hazards exist, if
so, remove from use. • Children should be supervised during play. • Keep addresses
and phone numbers for future reference. • The item inside this package may vary
from the photographs and/or illustrations. Spin Master reserves the
right to discontinue use of the www.airhogs.com website at any time.
MADE IN CHINA.
20057643, 20057644 GEN REV 0
T44452_0001_20057643_GEN_IS_R1R1
SPIN MASTER LTD., 450 FRONT STREET WEST,
TORONTO, ON M5V 1B6 CANADA
Customer Care: 1-800-622-8339
Fax: 416-364-8005
Email: customercare@spinmaster.com
Imported into EU by:
SPIN MASTER INTERNATIONAL, S.A.R.L.,
16 AVENUE PASTEUR, L-2310, LUXEMBOURG
www.spinmaster.com
4
23
HOW TO INSTALL YOUR BATTERIES
CONTENTS
BECOMING FAMILIAR WITH YOUR CONTROLLER CHARGER
HOW TO CHARGE YOUR SKY STUNT™
1. Carefully remove charge
plug from controller/charger.
2. Switch plane to OFF/CHG
position. 3. Switch
controller/charger to CHG
position. 4. Insert charge
plug into charge port.
5. The charge indicator will
turn ON. 6. When charging is
complete both charge
indicator and power indicator
will turn ON.
PRE-FLIGHT ENVIRONMENT CHECK
1. Location – Adequate space, grass or other soft terrain, free of obstacles.
2. Weather – Avoid wet and/or cold conditions.
3. Wind – Avoid strong winds.
Hereby, Spin Master Ltd., declares that this
Sky Stunt™ is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC. <http://www.airhogs.com>
a
Warning: CHOKING HAZARD – Small Parts.
BATTERY INSTALLATION – CONTROLLER/CHARGER
1. Open the battery door with a screwdriver (A). 2. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
3. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (B). 4. Replace
battery door securely (C). 5. Check your local laws and regulations for correct recycling and/or battery disposal.
®
SKY STUNT™
Charge
Port
Power Switch
a WARNING:
CHOKING HAZARD – Small parts.
Not for Children under 3 years.
Repairs
Clear Tape
Direction Stick
(LEFT/RIGHT)
Charger
Cable Cover
Steering
Trim Knob
Power
Indicator
Stunt
Button
Throttle Stick
(Speed control)
Charge
Indicator
Power Switch
ON/CHG OFF
Antenna
x 1 x 1x 1 x 2x 1
HOW TO FLY YOUR SKY STUNT™
1. Fully extend controller/charger antenna.
2. Switch controller/charger to the ON position.
3. Power indicator will turn ON. 4. Switch plane
to the ON position. 5. When launching the plane,
use partial throttle. Launch the plane into the
wind and parallel to the ground.
=
CONTROLLING PLANE FLIGHT
TROUBLESHOOTING
PROBLEM
Plane will not start or has
low power.
Plane will not turn.
Plane is flying too low.
Plane is flying too high.
Motors don’t stop when
controller/charger is turned OFF.
CAUSE
1. Plane not charged.
2. Battery power is drained.
3. Plane was not set to OFF
during charging.
4. Controller/charger was not set
to CHG while trying to charge.
1. Controller/charger is not ON.
2. Controller/charger antenna is
not extended.
3. It’s a windy day.
1. Needs more power.
2. The six AA batteries in the
controller/charger are drained.
Need to decrease power.
Radio interference from some
other source.
SOLUTION
1. Charge plane for a complete charge cycle.
2. Replace the controller/charger batteries after
approximately 8 to 10 flights.
3. The plane won’t accept a charge in the ON position.
Always set to OFF before charging.
4. The controller/charger will NOT charge in the OFF
or ON position. Always set the controller/charger to
CHG before attempting to charge.
1. Set controller/charger to ON.
2. Fully extend controller/charger antenna before flying.
3. Do not fly in strong winds. Strong windy conditions
will limit and prevent your ability to control the plane.
1. Push the throttle UP.
2. Charge plane for a complete charge cycle or, if
batteries are completely drained, replace batteries.
Pull the throttle DOWN.
Turn the switch on the plane to OFF.
NOTE: If normal function of the product is disturbed or interrupted, strong electro-magnetic interference may be causing the issue.
To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another
location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
1. To make the plane
climb, move the throttle
stick forward.
2. To FLY LEFT,
move the direction
stick left.
5. To LAND,
select a soft
grassy area
and pull the
throttle stick
back slowly.
4. To perform a
stunt, just hold
down the STUNT
button. Try
tapping or holding
the STUNT button
down to do
different stunts.
3. To FLY RIGHT,
move the direction
stick right.
TRIMMING YOUR PLANE
11
4
4
2
2
5
5
3
3
6
6
3
3
11
44
22
55
B
B
TM
ON/CHG
OFF
ON/CHG
OFF
OFF/CHG ONOFF/CHG ON
ON/CHG
OFF
ON/CHG
OFF
=
1
Replacing
Propeller
stunt plane
AACC
SCAN ME
10+
YRS
OFF/CHG ONOFF/CHG ON
OFF/CHG ON
OFF/CHG ON
Quick Start Guide
Customer Care:
1-800-622-8339
customercare@spinmaster.com
BATTERY SAFETY INFORMATION: • Requires 6 x 1.5-V
AA batteries (not included). • Batteries are small objects.
• Replacement of batteries must be done by adults. • Follow
the polarity (+/-) diagram in the battery compartment.
• Promptly remove dead batteries from the toy. • Dispose of
used batteries properly. • Remove batteries for prolonged
storage. • Only batteries of the same or equivalent type as
recommended are to be used. • DO NOT incinerate used
batteries. • DO NOT dispose of batteries in fire, as batteries
may explode or leak. • DO NOT mix old and new batteries or
types of batteries (i.e. alkaline/standard). • DO NOT use
rechargeable batteries. • DO NOT recharge non-rechargeable
batteries. • DO NOT short-circuit the supply terminals.
Your Air Hogs® Sky Stunt™ is equipped with a Lithium Polymer
battery. SPECIAL LiPo BATTERY INSTRUCTIONS:
• Never charge battery unattended. • Charge battery in isolated area.
Keep away from flammable materials. • Do not expose to direct sunlight.
• There is a risk of the batteries exploding, overheating, or igniting. Do not
disassemble, modify, heat, or short circuit the batteries. Do not place them
in fires or leave them in hot places. • Do not drop or subject to strong
impacts. • Do not allow the batteries to get wet. • Only charge the batteries
with the specified Spin Master™ battery charger. • Only use the batteries in
the device specified by Spin Master. • Carefully read the instruction guide,
and use the batteries correctly. • In the unlikely event of leakage or
explosion use sand or a chemical fire extinguisher for the battery.
• Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly and battery removal must be
performed by an adult. Do not use any tools for disassembly. Pulling, tearing, and deforming of the product during disassembly, while necessary,
should be as limited as possible. Do not compress the product at any time. Ensure product is turned off. Find a point where the two body halves
meet; the nose of the aircraft or where the wing meets the body. Start to peel the halves apart, separating them where they are glued together;
remove any tape as necessary. Separate product body halves to expose internal electronics. To separate battery from product use scissors to cut
a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are cut and isolated. Dispose of
battery in accordance with your local battery recycling or disposal laws. NOTE: Opening of product and/or removal of battery will render product
inoperative and voids manufacturer warranties, dispose of remaining product components in accordance with local laws.
FCC Statement: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio
communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the
toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the
receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio
technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any
transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be
expressly approved by Spin Master Ltd. or they could void the user’s authority to operate the equipment.
Contains 1 x 3.7 V LiPo battery pack. Requires 6 x 1.5 V AA (LR6)
alkaline batteries (not included). Batteries or battery packs must be
recycled or disposed of properly. When this product has reached
the end of its useful life it should not be disposed of with other
household waste. The Waste Electrical and Electronic Equipment
Regulations require it to be separately collected so that it can be treated using the best
available recovery and recycling techniques. This will minimize the impact on the
environment and human health from soil and water contamination by any hazardous
substances, decrease the resources required to make new products and avoid using up
landfill space. Please do your part by keeping this product out of the municipal waste
stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and
electronic equipment”. You can return an old product to your retailer when you buy a
similar new one. For other options, please contact your local council.
a
WARNING: IF PROPELLER(S)
BECOME DAMAGED OR BROKEN, DO
NOT FLY. FLYING WITH BROKEN
PROPELLER(S) MAY CAUSE DAMAGE
OR LEAD TO INJURY.
a
WARNING: The antenna is not to be
inserted into socket outlets.
a
CAUTION: Never fly near your face.
Keep propeller away from your fingers,
hair, eyes and other body parts. Do not
launch flying toy at people or animals.
If rudder won’t
move.
XX
1
4
3
2
4
1
Folding
Instructions
Fold 1
Fold 2