Instrukcja obsługi Speco Technologies O2VT1VN

Speco Technologies Kamera monitorujÄ…ca O2VT1VN

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Speco Technologies O2VT1VN (43 stron) w kategorii Kamera monitorująca. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/43
User Manual
2MP IP Camera
O2VB1N/O2VB1VN /O2VT1N /O2VT1VN
Please read this instruction carefully before operating the unit and keep it for further reference
Important Safeguards and Warnings
1. Electrical safety
All installation and operation here should conform to local electrical safety codes.
Use a certified/listed 12VDC Class2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same time; it may result in device damage!
The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installation could run the risk of fire or electrical shock.
2. Environment
Heavy stress, violent vibration or exposure to water is not allowed during transportation, storage and installation.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature conditions.
Do not expose the camera to electromagnetic radiation. Otherwise it may result in CMOS sensor failure.
Do not block any ventilation openings.
Do not allow water and liquid intrusion into the camera.
3. Operation and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor optic component. You can use a blower to clean the dust on the lens surface.
Always use the dry soft cloth to clean the device. If there is too much dust, use a cloth dampened with a small quantity of
neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth)
may result in poor IR functionality and/or IR reflection.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an optical device, please don t touch or wipe cover surface directly during installation and use, please refer ’
to the following methods if dirt is found.
Stained with dirt:
Use oil-free soft brush or hair dryer to remove it gently.
Stained with grease or fingerprint
Use oil-free cotton cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth
and wipe several times if it is not clean enough.
Warning
This camera should be installed by qualified personnel only.
All the examination and repair work should be done by qualified personnel.
Any unauthorized changes or modifications could void the warranty.
Statement
This guide is for reference only.
Product, manuals and specifications may be modified without prior notice. Speco Technologies reserves the right to modify
these without notice and without incurring any obligation.
Speco Technologies is not liable for any loss caused by improper operation.
Regulatory Information
FCC conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
âš« This device may not cause harmful interference.
âš« This device must accept any interference received, including interference that may cause undesired operation.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
âš« Reorient or relocate the receiving antenna.
âš« Increase the separation between the equipment and receiver.
âš« Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Note:
Before installation, check the package and make sure that all components are included.
Contact your rep or Speco customer service department immediately if something is broken or missing in the package.
Accessory name
Amount
Network Camera Unit
1
Junction Box
1
Quick Start Guide
1
Installation Accessories Bag
1
CD
1

Specyfikacje produktu

Marka: Speco Technologies
Kategoria: Kamera monitorujÄ…ca
Model: O2VT1VN

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Speco Technologies O2VT1VN, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kamera monitorujÄ…ca Speco Technologies

Speco Technologies

Speco Technologies VLDT3GM Instrukcja

22 Września 2024
Speco Technologies

Speco Technologies CVC624WDR Instrukcja

20 Września 2024
Speco Technologies

Speco Technologies O4iB2M Instrukcja

20 Września 2024
Speco Technologies

Speco Technologies ZIPTW4B1 Instrukcja

18 Września 2024
Speco Technologies

Speco Technologies O2ID21M Instrukcja

18 Września 2024
Speco Technologies

Speco Technologies Intensifier 2 CVC6246iHR Instrukcja

18 Września 2024
Speco Technologies

Speco Technologies O4DT1 Instrukcja

18 Września 2024
Speco Technologies

Speco Technologies O4iB2 Instrukcja

18 Września 2024
Speco Technologies

Speco Technologies O8D8M Instrukcja

17 Września 2024
Speco Technologies

Speco Technologies CVC5100BPVFW Instrukcja

17 Września 2024

Instrukcje Kamera monitorujÄ…ca

Najnowsze instrukcje dla Kamera monitorujÄ…ca

Trebs

Trebs CCD-401C Instrukcja

15 Października 2024
Hikvision

Hikvision DS-2CE56D5T-AIRZ Instrukcja

15 Października 2024
D-Link

D-Link DCS-7510 Instrukcja

15 Października 2024
Ubiquiti Networks

Ubiquiti Networks UniFi Video UVC-G3-AF Instrukcja

14 Października 2024
Hikvision

Hikvision DS-2TD2137-7/VP Instrukcja

13 Października 2024
Alecto

Alecto DVC-215IP Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2DE7A245IX-AE/S1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2TD2166-15/V1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2325FWD-I Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2323G2-IU Instrukcja

12 Października 2024