Instrukcja obsługi Soundmaster SCD2100

Soundmaster Odtwarzacze/nagrywarki CD SCD2100

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Soundmaster SCD2100 (4 stron) w kategorii Odtwarzacze/nagrywarki CD. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
WARNING
Risk of electric shock
Do not open!
Caution: To reduce the risk of electric shock, do not remove the cover
(or back). There are no user serviceable parts inside. Refer servicing to
qualified service personnel.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
PRODUCTO LASER CLASE 1
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
CAUTION - INVISIBLE LASERRADIATION WHEN OPENING
THE COVER OR PRESSING THE SAFETY INTERLOCK.
AVOID EXPOSURE TO THE LASER BEAM.
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household waste
at the end of its life cycle. Return it to a collection point for the
recycling of electrical and electronic devices. This is indicated by
the symbol on the product, user manual or packaging.
The materials are reusable according to their markings. By reusing, recycling
or other forms of utilization of old devices you make an important contribution
to the protection of our environment.
Please contact your local authorities for details about collection points.
• Use the device in dry indoor environments only.
• Protect the device from humidity.
• Do not open the device. RISK OF ELECTRIC SHOCK ! Refer opening and servicing to qualified personnel.
• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the
specifications on the rating plate.
• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
• A damaged mains cable or plug must immediately be replaced by an authorized service center.
• In case of lightning, immediately disconnect the device from the mains supply.
• Children should be supervised by parents when using the device.
• Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
• Do not expose the device to direct sunlight or other heat sources.
• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
• Do not cover the ventilation openings!
• Install the device at a safe and vibration-free location.
• Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/customer
center.
• The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.
• Only use mercury and cadmium-free batteries.
• Used batteries are hazardous waste and NOT to be disposed of with the household waste!!! Return the batteries to your dealer or to
collection points in your community.
• Keep batteries away from children. Children might swallow batteries. Contact a physician immediately if a battery was swallowed.
• Check your batteries regularly to avoid battery leakage.
Used batteries are hazardous waste and NOT to be disposed
of with the household waste! legally As a consumer you are
obligated all batteries to return for environmentally responsible
recycling – no matter whether or not the batteries contain harmful
substances*).
Return batteries free of charge to public collection points in your community
or to shops selling batteries of the respective kind.
Only return fully discharged batteries.
*) marked Cd = cadmium, Hg = mercury, Pb = lead
EN 1
LOCATION OF CONTROLS
EN 2
3
12 11 2 20
4
5
1
15 16
13
18
17
19
14
10
6
1
7
8
9
1 Speakers
11 LED Display
2 CD Compartment
12 Power Indicator
3 REPEAT Button
13 Handle
4 RANDOM Button
14 FUNCTION Switch
5 STOP Button
15 TUNING Control
6 PLAY/PAUSE Button
16 VOLUME Control
7 PROGRAM Button
17 Antenna
8 SKIP DN Button
18 Aux-In Jack
9 SKIP UP Button
19 AC Socket
10 Battery Compartment
20 FM ST LED Indicator
AC Operation
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the
voltage of your local area. Unravel the AC power cord, insert one end into the AC socket on the set,
and the other end into a standard AC outlet.
Attention
1. Do not plug or unplug the power cable while you have wet hands.
2. When planning not to use this unit for a long time, disconnect the power cable from the wall
outlet.
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to
avoid shock risks caused by damaged cable.
Battery Operation
Disconnect the AC cord set completely. Open the battery compartment door and insert 6 pieces
UM-2 "C" size batteries into the battery compartment with battery polarity as shown inside the
battery compartment.
EN 3
Radio Operation
1. Set the FUNCTION switch to FM ST or FM position.
2. Rotate the TUNING control to tune to your desired radio station.
3. Adjust the sound level by rotating the VOLUME control.
4. To turn off the radio, set the FUNCTION switch to OFF position.
FM Stereo Indicator
When turn to a FM stereo broadcast the "FM ST." LED Indicator will light up.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations.
CD Operation
1. Set the FUNCTION switch to the CD/AUX position.
2. Insert the CD disc in the CD compartment and close the CD door, the unit will start reading
the disc, the LED display will show the total number of tracks of the entire disc after reading.
3. To start playing the CD, press the PLAY/PAUSE button.
4. Adjust the VOLUME Control to the desired volume level.
5. To stop playing the CD, press the STOP button.
Skip Mode
1. During play or pause mode, press the SKIP UP button to go to the next track.
2. During play or pause mode, press the SKIP DN button to go back to the beginning of the
track.
3. During play mode, press the SKIP DN button twice will go back to the previous track.
Programming the CD Player
The programming of the CD player should be done during STOP mode.
1. Press the PROGRAM button, the LED display will show ‘ 01 ‘ and flash continuously.
2. Press the SKIP UP or SKIP DN buttons to select the desired track.
3. Press the PROGRAM button again to store this track in memory, the LED will show ‘ 02 ‘ and
flash continuously.
4. Repeat steps from 2 to 3 to store more tracks in memory. You can store up to 20 tracks in the
memory.
5. Press the PLAY/PAUSE button to play the disc in the programmed order.
6. To stop playing, press the STOP button.
7. To cancel the programming list, press the STOP button and open the CD door or set the
FUNCTION switch to OFF position.
Repeat Mode
Repeat 1 : Press the REPAT button once, the repeat LED indicator will light and flash continuously.
This single track will be repeated.
Repeat All : Press the REPEAT button twice, the repeat LED indicator will stay lighted. The whole
disc will be played continuously.
To Cancel Repeat Function : Press the REPEAT button until the lighted repeat LED indicator
turned off.
Random Mode
Press the RANDOM button in stop mode or during play, all tracks on the disc will be played in
random order selected by the CD player.

Specyfikacje produktu

Marka: Soundmaster
Kategoria: Odtwarzacze/nagrywarki CD
Model: SCD2100

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Soundmaster SCD2100, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Odtwarzacze/nagrywarki CD Soundmaster

Soundmaster

Soundmaster SCD6500USB Instrukcja

8 Października 2024
Soundmaster

Soundmaster SCD3750 Instrukcja

6 Października 2024
Soundmaster

Soundmaster CD9220 Instrukcja

2 Października 2024
Soundmaster

Soundmaster SCD 6800MP3 Instrukcja

14 Września 2024
Soundmaster

Soundmaster RCD1180 Instrukcja

9 Września 2024
Soundmaster

Soundmaster CD9290 Instrukcja

5 Września 2024
Soundmaster

Soundmaster KCD50 Instrukcja

5 Września 2024
Soundmaster

Soundmaster MCD400 Instrukcja

4 Września 2024
Soundmaster

Soundmaster SCD 2700USB Instrukcja

4 Września 2024
Soundmaster

Soundmaster RCD 1400 Instrukcja

2 Września 2024

Instrukcje Odtwarzacze/nagrywarki CD

Najnowsze instrukcje dla Odtwarzacze/nagrywarki CD

Aiwa

Aiwa PCD-1000BT Instrukcja

13 Stycznia 2025
Technics

Technics SL-G700 Instrukcja

12 Stycznia 2025
OK

OK OPC 200CD Instrukcja

11 Stycznia 2025
Philips

Philips TAZ6000 Instrukcja

11 Stycznia 2025
AKAI

AKAI BM004A-614 Instrukcja

5 Stycznia 2025
Rotel

Rotel Michi Q5 Instrukcja

4 Stycznia 2025
Klipsch

Klipsch PD-10AE Instrukcja

1 Stycznia 2025
Marantz

Marantz SA-17S1 Instrukcja

30 Grudnia 2025
Taga Harmony

Taga Harmony TCD-50 Instrukcja

25 Grudnia 2024
S.M.S.L

S.M.S.L PL100 Instrukcja

16 Grudnia 2024