Instrukcja obsługi Soler & Palau TCDH EXD
Soler & Palau
wiatrak domowy
TCDH EXD
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Soler & Palau TCDH EXD (12 stron) w kategorii wiatrak domowy. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/12
NT_51889901_TCDH-EXd_AN_151001
INSTRUCTION MANUAL
INSTALLATION | WIRING | COMMISSIONING | MAINTENANCE |
TCDH EXd
ATEX Roof Mounted Fans
Motor II 2G Exd IIB T4 Gb or II 2G Exd IIB+H2 T4 Gb
2/12 NT_51889901_TCDH-EXd_AN_151001
1. GENERAL POINTS
1.1 Warnings
This manual applies to centrifugal fans for use in ATEX areas.
A potentially explosive atmosphere (ATEX) is a serious hazard to life, health and safety – strict attention to
risk prevention must be applied by all persons. In Europe ATEX Directive 1994/9/EC applies to products,
and Directive 1999/92/EC applies to worker protection.
This instruction manual contains important information and must be read carefully by competent persons
prior to any handling, transport, inspection or installation of this product. Every care has been taken in the
preparation of the instructions and information; however, it is the responsibility of the installer to ensure
the system complies with relevant national and international regulations, especially safety. This document
refers to direct drive and in-direct drive / belt drive centrifugal fans. Further guidance is contained in the
specic motor manufactures manual, where applicable, supplied with the product.
The manufacturer accepts no responsibility for breakages, accidents or any inconvenience caused by
failure to comply with the instructions contained in this manual.
The fans referred to in this manual have been manufactured in accordance with rigorous quality control
and International standard ISO 9001.
The purchaser, installer, user is responsible for ensuring that the fan is installed, operated and serviced
by qualied personnel, acting in accordance with all safety precautions applicable and as required by law,
regulations and standards in the country applicable.
ATEX Fans, which, according to European Directive 1994/9/EC, are designed and restricted to use in the:-
• Specic application applicable,
• Equipment Group and Category applicable,
• Explosion Group for gases and vapours applicable, or
• Gas or Dust type applicable,
• Temperature class applicable.
SOMMAIRE
1. GENERAL POINTS ............................................................................................................................ 2
1.1 Warnings .................................................................................................................................. 2
1.2 Safety instructions 3 ...................................................................................................................
1.3 Reception – Storage 3 .................................................................................................................
1.4 Guarantee................................................................................................................................. 4
2. PRODUCT PRESENTATION 4 ..............................................................................................................
2.1 Range ....................................................................................................................................... 4
2.2 Construction ............................................................................................................................. 4
2.3 Motorisation .............................................................................................................................. 4
3. INSTALLATION .................................................................................................................................. 4
3.1 Dimensions and weight 5 ............................................................................................................
3.2 Manutention .............................................................................................................................. 5
3.3 Roof fan accessories assembly 5 ................................................................................................
3.4 Roof fan assembly 6 ....................................................................................................................
4. ELECTRICAL WIRING DIAGRAMS .................................................................................................. 7
4.1 Prior cautions............................................................................................................................ 7
4.2 Technical characteristics........................................................................................................... 7
4.3 Motor wiring diagram 8 ................................................................................................................
4.4 Connection with ATEX isolation switch 8 .....................................................................................
4.5 Connection with ATEX dierential pressure switch .................................................................. 8
4.6 Wiring diagram with frequency inverter 8 ....................................................................................
5. COMMISSIONING .............................................................................................................................. 9
6. MAINTENANCE................................................................................................................................ 10
7. WASTE MANAGEMENT – END OF LIFE ........................................................................................ 10
7.1 Treatment of non hazardous waste and packaging 10 ................................................................
7.2 Treatment of WEEE Professional 10 ..........................................................................................
8. PRE-START CHECKLIST .................................................................................................................11
3/12 NT_51889901_TCDH-EXd_AN_151001
The user / employer / competent body is responsible for ATEX risk analysis. Fan equipment is determined
by this ATEX risk. Refer IEC EN 60079-14 Electrical installations in hazardous areas (other than mines)
especially Section 5.
Fan equipment Name plate / Label includes ATEX specication applicable, Fan serial number, Fan type,
motor data, year of manufacture, and where applicable, belt drive, bearing, grease information, CE mark,
and any corresponding documentation.
Any other use, application or installation requiring a superior specication to fan equipment is prohibited.
TCDH EXD fans are designed for room air extraction where the atmosphere presents a risk of explosion
within the meaning of Directive 1994/9/EC ATEX, for use in standard atmospheric conditions as dened in
IEC 60079-0, and following conditions:
• Outdoor installation
• Environment temperature: -20 ° C / + 50 ° C
• Maximum temperature of the exhaust air in continuous operation : 40 ° C
• Relative humidity: max 95 % non-condensing
• Compliance with Directive 1994/9/EC ATEX Group II Category 2 Gas fans , for installation in Zone
1 T4 or 2 T4
• Atmosphere with low salinity, without corrosive chemical components.
1.2 Safety instructions
Safety on site is responsibility of competent personnel and in accordance with applicable International, Na-
tional and Local regulations, especially for hazardous ATEX areas. Fan equipment should be electrically
isolated and locked out before any work started.
Installation of ATEX fan equipment requires extra attention to ensure safe operation.
Safety guard accessories are available from S&P if required due to specic installation.
Safety protective clothing, equipment, hearing protection, and tools may be required.
Ensure fan/motor temperature protection devices are tted and operating correctly, especially for all ATEX
Exd motored products speed controlled by VSD Frequency Inverter
Ensure system operation is safe in event of power cut / power outage / disruption to power supply. If venti-
lation is stopped due to disruption to power supply, ensure no risk due to build-up of hazardous substance,
excessive temperature etc. Care may be needed when restarting fan after disruption to power supply.
Avoid risk of foreign objects, debris being drawn into, or falling into fan impeller.
Allow safe access to fan for inspection, maintenance, replacement of parts, cleaning/housekeeping, espe-
cially for dust hazards. Ensure all necessary safety guards are tted and secure to prevent injury.
The installer is responsible for initial inspection of workplace ATEX system before it is set to work. Refer
IEC EN 60079 - 14
1.3 Reception – Storage
Check that the fan is in perfect condition while unpacking. Any fault or damage caused in origin is covered
by the S&P guarantee. Make sure that the fan coincides with the product you ordered and that the details
on the rating plate full your requirements.
The packaging used for this fan has been designed to support normal transport conditions. The fan must
always be transported in its original packaging as not doing so could deform or damage the product.
Storage must be in a safe, at, controlled environment to prevent damage, especially from water, sand,
dust, moisture, corrosion, temperature. Recommend that duct connections (inow and outow) are closed/
covered to avoid dust / debris entering the equipment.
Storage must not exceed 1 year, without review by supplier / manufacturer for possible damage to motor,
bearings, grease, drive belts. Regular inspection and check list to be completed
Specyfikacje produktu
| Marka: | Soler & Palau |
| Kategoria: | wiatrak domowy |
| Model: | TCDH EXD |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Soler & Palau TCDH EXD, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje wiatrak domowy Soler & Palau
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
26 Czerwca 2024
Instrukcje wiatrak domowy
- wiatrak domowy Gamdias
- wiatrak domowy Gorenje
- wiatrak domowy Philips
- wiatrak domowy SHE
- wiatrak domowy Brentwood
- wiatrak domowy Midea
- wiatrak domowy Panasonic
- wiatrak domowy Nedis
- wiatrak domowy Stanley
- wiatrak domowy Be Cool
- wiatrak domowy Westinghouse
- wiatrak domowy Ardes
- wiatrak domowy Taurus
- wiatrak domowy Orbegozo
- wiatrak domowy Blaupunkt
- wiatrak domowy Siemens
- wiatrak domowy DeWalt
- wiatrak domowy Bimar
- wiatrak domowy Master
- wiatrak domowy Honeywell
- wiatrak domowy Concept
- wiatrak domowy ECG
- wiatrak domowy Matsui
- wiatrak domowy Emerio
- wiatrak domowy Stirling
- wiatrak domowy Renkforce
- wiatrak domowy Thermex
- wiatrak domowy Perel
- wiatrak domowy Fagor
- wiatrak domowy GoldAir
- wiatrak domowy Koenic
- wiatrak domowy Trotec
- wiatrak domowy Klarstein
- wiatrak domowy Cecotec
- wiatrak domowy NewAir
- wiatrak domowy Keystone
- wiatrak domowy Scarlett
- wiatrak domowy TriStar
- wiatrak domowy Dimplex
- wiatrak domowy Baxi
- wiatrak domowy DCG
- wiatrak domowy Brandson
- wiatrak domowy Vornado
- wiatrak domowy G3 Ferrari
- wiatrak domowy Omega Altise
- wiatrak domowy Sunbeam
- wiatrak domowy Heller
- wiatrak domowy Frigidaire
- wiatrak domowy Hunter
- wiatrak domowy Sencor
- wiatrak domowy HiKOKI
- wiatrak domowy Metabo
- wiatrak domowy ProfiCare
- wiatrak domowy Field Controls
- wiatrak domowy Volteno
- wiatrak domowy Cotech
- wiatrak domowy Eurom
- wiatrak domowy Enermax
- wiatrak domowy Maestro
- wiatrak domowy Clas Ohlson
- wiatrak domowy PRIME3
- wiatrak domowy Sogo
- wiatrak domowy Sonnenkönig
- wiatrak domowy Proline
- wiatrak domowy Lifesmart
- wiatrak domowy Lasko
- wiatrak domowy Lian Li
- wiatrak domowy Bestron
- wiatrak domowy Optimum
- wiatrak domowy Columbia Vac
- wiatrak domowy Swan
- wiatrak domowy KDK
- wiatrak domowy Anslut
- wiatrak domowy Logik
- wiatrak domowy Eldom
- wiatrak domowy Kambrook
- wiatrak domowy IHome
- wiatrak domowy Haus & Luft
- wiatrak domowy CSL
- wiatrak domowy Orava
- wiatrak domowy NuTone
Najnowsze instrukcje dla wiatrak domowy
10 Października 2024
10 Października 2024
10 Października 2024
10 Października 2024
28 Września 2024
28 Września 2024
28 Września 2024
28 Września 2024
22 Września 2024
22 Września 2024