Instrukcja obsługi Snow Joe Pressure Joe SPX1000

Snow Joe myjka ciśnieniowa Pressure Joe SPX1000

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Snow Joe Pressure Joe SPX1000 (10 stron) w kategorii myjka ciśnieniowa. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/10

A Division of Snow Joe® , LLC

Model No. SPX1000 Form No. SJ-SPX1000-880E

OPERATOR’S MANUAL

1450 PSI/1.45 GPM Electric Pressure Washer

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Safety Alert Symbols

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

mWARNING! This indicates a hazardous situation, which,

if not avoided, could result in death or serious injury.

mCAUTION! This indicates a hazardous situation, which,

if not avoided, could result in minor or moderate injury.

mDANGER! This indicates a hazardous situation, which,

if not followed, will result in death or serious injury.

Safety Rules

mWARNING! This appliance is not intended for use

by children or by unassisted, unsupervised persons whose

physical, sensory or mental capabilities prevent them from

using it safely. Children should be supervised to ensure that

they do not play with the appliance.

Before starting up your machine, please check it carefully for

any defects. If you nd any, do not start up your machine and

contact your distributor.

mWARNING! When using the pressure washer, basic

safety precautions should always be followed to reduce the

risk of re, electric shock, and personal injury, including the

following:

• Know how to stop the machine Know your product –

and bleed pressure quickly. Be thoroughly familiar with the

controls.

• All bystanders and pets should Keep bystanders away –

be kept a safe distance away from the work area.

• Do not use this machine for any Use the right product –

job except that for which it is intended.

• Dress properly – Do not wear loose clothing or jewelry.

They can get caught in moving parts. Protective rubber

gloves and non-slip footwear are recommended when

working outdoors.

• Exercise caution to avoid slipping or falling. Caution! –

Wear protective footwear that will protect your feet and

improve your footing on slippery surfaces.

• Watch what you are doing. Use common Stay alert –

sense. Do not operate the pressure washer when you are

tired or under the inuence of alcohol or drugs.

• Do not overreach – Keep proper footing and balance at

all times.

• Avoid unintentional starting – Do not carry plugged-in

machine with nger on the trigger. Make sure the switch is

off before plugging in the machine.

• Never carry the machine by the Do not abuse the cord –

cord or yank the cord to disconnect it from the receptacle.

Keep the cord away from heat, oil, and sharp edges.

• Also use safety footwear, snug-tting Use safety glasses –

clothing, protective gloves, hearing and head protection.

• Water temperature – Pressure washer is not meant to

pump hot water. connect it to a hot water supply as NEVER

it will signicantly reduce the life of the pump.

• store the pressure washer Store indoors – NEVER

outdoors or where it could freeze. The pump will be

seriously damaged.

• Ground Fault Circuit Interrupter (GFCI) – Protection

should be provided on the circuits or outlets to be used for

this pressure washer. Receptacles are available having built-

in GFCI protection and may be used for this measure

of safety.

• The insulation of the power cord should be faultless and

without any cracks. If the power cord is damaged, an

authorized distributor should replace it.

mWARNING! Do not use this appliance without reading

this instruction manual.

mWARNING! Do not use the appliance within range of

persons unless they are wearing protective clothing.

mWARNING! High pressure jets can be dangerous if

subject to misuse. The jet must not be directed at persons,

pets, live electrical equipment or the appliance itself.

• Do not direct the jet against yourself or others in order to

clean clothes or footwear.

• Do not spray ammable liquids.Risk of explosion –

• Disconnect from the electrical power Disconnect tool –

supply before performing any maintenance task.

• High pressure washer must not be Keep children away –

used by children or untrained personnel.

• To ensure appliance safety, use only original replacement

parts from the manufacturer or approved by the

manufacturer.

mWARNING! Water that has own through backow

preventers is considered to be non-potable.

mWARNING! During cleaning, maintenance or when

replacing parts, the machine must be disconnected from its

power source by removing the plug from the socket outlet.

mWARNING! High pressure hoses, ttings, and couplings

are important for the safe operation of the appliance. Use

only hoses, ttings, and couplings recommended by the

manufacturer.

• Do not use the appliance if the Check for damaged parts –

supply cord or other important parts of the appliance are

damaged (e.g. safety devices, high pressure hoses, trigger

gun).

mWARNING! If an extension cord is used, the plug and

socket must be of watertight construction.

mWARNING! Inadequate extension cords can be

dangerous.

• This high pressure washer must not be used at

temperatures below 32ºF (0°C).

mWARNING! Power cords on drums should always be

completely unwound to prevent the cord from overheating.

• Power cord connections should be kept dry and off the

ground.

• Comply with the below requirements for length and cord

specs (Table 1):

• If the power cord is damaged, it must be replaced by the

manufacturer or his service agent or similarly qualied

person in order to avoid a hazard.

• Keep the machine on a stable, at surface during operation,

handling, transportation, and storage. Sudden overturn of

the machine can cause bodily injury.

• In the event of an accident or breakdown, switch off the

machine immediately. (If contact with detergent occurs,

rinse with an abundance of clean water.)

Electrical Safety

ATTENTION: If there are problems with the electrical

MAINS, short voltage drops may appear when starting the

equipment. This can, in turn, inuence other equipment (e.g.

cause a lamp to blink). If the MAINS-IMPEDANCE Zmax <

0.335 OHM, such disturbances are not expected. (In case

of assistance, contact your local supply authority for further

information.)

mWARNING! Electrical Shock Hazard

Before starting up your machine, please check it carefully for

any defects. If you nd any, do not start up your machine and

contact your distributor.

The following should be observed when connecting the high

pressure washer to the electric installation:

• The electric supply connection should be performed by a

qualied person.

• The electric supply to this appliance should include either

a residual current device that will interrupt the supply if the

leakage current to the earth exceeds 30 mA for 30 ms or a

device that will interrupt the earth circuit (GFCI).

IMPORTANT: Only use water without any impurities.

If there is a risk of running sand into the inlet water (i.e. from

your own well), an additional lter should be installed.

Safety devices

The unloader valve can reduce pressure if it exceeds preset

values. The spray gun features a locking device. When the

lock is activated, the spray gun cannot be operated.

• A thermal sensor protects the motor Thermal sensor –

against overloading. The machine will restart after a few

minutes when the thermal sensor has cooled.

• In a double-insulated product, two Double insulation –

systems of insulation are provided instead of grounding.

No grounding means are provided on a double-insulated

product, nor should a means for grounding be added to

the product. Servicing a double-insulated product requires

extreme care and knowledge of the system, and should be

performed only by a qualied service person. Replacement

parts for a double-insulated product must be identical to the

parts they replace. A double-insulated product is marked

with the words “DOUBLE INSULATION” or “DOUBLE

INSULATED”. The symbol “ ” may also be marked on the

product.

• Ground Fault Circuit Interrupter (GFCI) – This pressure

washer is provided with a ground-fault circuit-interrupter

(GFCI) built into the plug of the power-supply cord. This

device provides additional protection from the risk of

electric shock. Should replacement of the plug or cord

become necessary, use only identical replacement parts

that include GFCI protection.

Risk of electrocution

• Inspect cord before using.

• Do not use if cord is damaged.

• Keep all connections dry and off the ground.

Table 1

100

150

Volts

120V

0 – 6

6 – 10

10 – 12

Total length of cord in feet

AWG

Not Recommended

Ampere Rating

More than

Not more than

• Do not touch plug with wet hands.

• Keep cord away from heat and sharp edges.

• Do not spray electrical apparatus and wiring.

Risk of explosion

• Do not spray ammable liquids.

• Do not use acids, bases, solvents, or any ammable

material in this product. These substances can cause

physical injuries to the operator and irreversible damage to

the machine.

Additional safety instructions

• High pressure: keep clear of nozzle.

• Injection hazard: equipment can cause serious injury if the

spray penetrates the skin.

• Do not point the gun at anyone or at any part of the body.

• In case of skin penetration, seek medical aid immediately.

• Before servicing, cleaning or removing any parts, shut off

the power and relieve pressure.

• This machine is not suitable for connection to the potable

water mains.

Product Description

Purpose

• The high pressure cleaner is intended for residential use to

clean vehicles, machines, buildings, facades, etc.

Areas of application

• Never use the machine in potentially explosive areas under

any circumstances!

• The operating temperature must be between 32ºF (0 C) and º

104ºF (+40 C).º

• The machine consists of an assembly with a pump, which

is encased in a shock-absorbing housing. To provide the

operator with an optimal working position, the machine is

equipped with a spray wand and a non-slip handle grip,

whose shape and conguration comply with applicable

regulations.

• Do not cover or modify the spray wand or the spray nozzles

in any way.

• The high pressure cleaner is designed to be used with cold

or lukewarm water; higher temperatures can damage the

pump.

• Do not use water that is dirty, gritty or contains any

chemical products, as these could impair operation and

shorten the life of the machine.

Safety Symbols

The following table depicts and describes safety symbols that

may appear on this product. Read, understand, and follow all

instructions on the machine before attempting to assemble

and operate.

Symbol Description

SAFETY ALERT – indicates

a precaution, a warning or

a danger.

READ THE OPERATOR’S

MANUAL(S) Read, understand

and follow all instructions in the

manual(s) before attempting to

assemble and operate.

For protection against injury,

wear safety goggles and

ear protection.

To reduce the risk of injury,

user must keep all bystanders

at least 15 m away.

Double insulation.

Electrical shock hazard.

SWITCH OFF! Remove plug

from outlet immediately if the

cord is damaged or cut.

Machine not suitable for

connection to the potable

water mains.

Sound power level is

96 dB(A).

WARNING! Keep out of rain

and away from wet areas.

Specyfikacje produktu

Marka:	Snow Joe
Kategoria:	myjka ciśnieniowa
Model:	Pressure Joe SPX1000
Kolor produktu:	Black, Yellow
Źródło zasilania:	Prąd elektryczny
Układ:	Wyprostowany
Ciśnienie robocze (max):	- bar
Tempo maksymalnego przepływu:	330 l/h