Instrukcja obsługi Simrad RS12 VHF


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Simrad RS12 VHF (72 stron) w kategorii walkie talkie. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/72
simrad-yachting.com
ENGLISH
RS12 VHF
User Guide
Simrad - RS12 Operation and Installation Instructions2
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a normal installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an output on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced technician for help.
A shielded cable must be used when connecting a peripheral to the serial ports.
IMPORTANT SAFETY INFORMATION
Please read carefully before installation and use.
DANGER
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards, Obey all safety messages that follow this symbol to
avoid possible injury or death.
WARNING WARNING indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury
CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided,
could result in minor or moderate injury.
CAUTION CAUTION used without the safety alert symbol indicates a potentially
hazardous situation which, if not avoided, may result in property damage.
DISCLAIMER: It is the owner’s sole
responsibility to install and use the instrument
and transducers in a manner that will not
cause accidents, personal injury or property
damage. The user of this product is solely
responsible for observing safe boating
practices.
NAVICO HOLDING AS. AND ITS SUBSIDIARIES,
BRANCHES AND AFFILIATES DISCLAIM ALL
LIABILITY FOR ANY USE OF THIS PRODUCT
IN A WAY THAT MAY CAUSE ACCIDENTS,
DAMAGE OR THAT MAY VIOLATE THE LAW.
Governing Language: This statement,
any instruction manuals, user guides and
other information relating to the product
(Documentation) may be translated to,
or has been translated from, another
language (Translation). In the event of any
conflict between any Translation of the
Documentation, the English language version
of the Documentation will be the official
version of the Documentation.
This manual represents the RS12 as at the
time of printing. Navico Holding AS. and its
subsidiaries, branches and affiliates reserve
the right to make changes to specifications
without notice.
Copyright © 2012 Navico Holding AS.
Simrad© is a registered trademark of Navico
Holding AS.
Simrad - RS12 Operation and Installation Instructions 3
MMSI and License Information:
You must obtain a user MMSI (Marine Mobile Service Identity) and enter it into your RS12
in order to use the DSC functions. Contact the appropriate authorities in your country. If
you are unsure who to contact, consult your Simrad dealer.
The user MMSI is a unique nine digit number, similar to a personal telephone number. It is
used on marine transceivers that are capable of using DSC (Digital Select Calling).
Depending upon your location, you may need a radio station license for the RS12. You
may also need an individual operator’s license.
Simrad recommends that you check the requirements of your national radio
communications authorities before operating DSC functions.
IMPORTANT:
1. DSC functions will not operate on the RS12 until your MMSI has been entered. Refer to section
4.2 for details.
2. The radio channels installed into this Simrad VHF radio may vary from country to country de-
pending upon the model and government or national communications authority regulations.
3. Navico recommends that you check the radio operating licensing requirements of your country
before using this Simrad VHF radio. The operator is solely responsible for observing proper radio
installation and usage practices.
4. A DSC warning label is supplied with this Simrad VHF radio. To comply with FCC regulations,
this label must be axed in a location that is clearly visible from the operating controls of this
radio. Make sure that the chosen location is clean and dry before applying this label.
RF Emissions Notice:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. This device’s antenna must be installed in accordance with provided instructions; and it must
be operated with minimum 96 cm spacing between the antennas and all persons body (excluding
extremities of hands, wrist and feet) during operation. Further, this transmitter must not be co-located
or operated in conjunction with any other antenna or transmitter.


Specyfikacje produktu

Marka: Simrad
Kategoria: walkie talkie
Model: RS12 VHF

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Simrad RS12 VHF, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje walkie talkie Simrad

Instrukcje walkie talkie

Najnowsze instrukcje dla walkie talkie

Midland

Midland LXT490 Instrukcja

14 Października 2024
SilverCrest

SilverCrest SPMR 8000 A1 Instrukcja

13 Października 2024
GoGen

GoGen BOB VYSILACKY Instrukcja

9 Października 2024
Motorola

Motorola Mag One BPR40 Instrukcja

9 Października 2024
BaoFeng

BaoFeng UV-82 Instrukcja

8 Października 2024
Motorola

Motorola Talkabout T72 Instrukcja

7 Października 2024
Yaesu

Yaesu VX-2R Instrukcja

7 Października 2024
Yaesu

Yaesu FT-4XR Instrukcja

7 Października 2024
Yaesu

Yaesu FT-1500M Instrukcja

7 Października 2024
Yaesu

Yaesu FT-4VR Instrukcja

7 Października 2024