Instrukcja obsługi SereneLife SLSPSKT205

SereneLife panel słoneczny SLSPSKT205

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla SereneLife SLSPSKT205 (12 stron) w kategorii panel słoneczny. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/12
2 Pcs. Portable Mono Solar Panel Starter Kit
SLSPSKT205
100W x 2 Off-Grid Solar Panel Kit
with 30A PWM Controller with LCD Screen
www.SereneLifeHome.com2
Carefully read through these installation instructions before installing,
operating or servicing PV system. Failure to follow these instructions may
result in bodily injury or damage to property. Keep these instructions!
Working on a PV system (installation, setup, maintenance, repairs) must be
carried out by qualied and authorized persons.
Electrical Characteristics
The tolerance of Electrical Characteristics is ±3% under standard conditions
(irradiance of 1000mW/cm2, AM 1.5 spectrum, and cell temperature of 25°C or
77°F.
WARNING:
Danger of death from electric shock!
• Solar modules generate electricity as soon as they are exposed to light.
One module on its own is below the safety extra low volt level, but multiple
modules connected in series (summing the voltage) or in parallel (summing the
current) represent a danger. The following points must be observed when
handling the solar modules to avoid the risk of re, sparking and fatal electric
shock.
• Do not insert electrically conducting parts into the plugs or sockets!
Fit solar modules and wiring with wet plugs and sockets!
• Exercise utmost caution when carrying out work on wiring and safety equipment
(use insulated tools, insulated gloves, ect.)!
• Do not use damaged modules! Do not dismantle modules!
Do not mark on the rear of the module using sharp objects!
• Exercise utmost caution when working on wiring and the inverter.
Be sure carefully to follow manufacture’s installation instructions!
Articially concentrated sunlight shall not be directed on the module or panel.
Danger of death from arcing!
Modules generate direct current when light shines on them. An arc may be
produced when connections are separated. We therefore recommended covering
modules with a lightproof cloth during installation.
www.SereneLifeHome.com 3
When breaking a connected string of modules (e.g. when disconnecting the DC
line from the inverter under load), a lethally strong arc can occur:
• Never disconnect the solar generator from the inverter while the inverter is
connected to the mains grid—remove the fuse from the AC side on the inverter
rst!
• Ensure cable connections in perfect condition (no splitting, soiling or other
contamination)
GENERAL SAFETY INFORMATION
Ensure that the module is used only in applications for which it is suitable
(see Installing the modules ). All work on a PV system (installation, setup,
maintenance, repairs) must be carried out only by appropriately qualied
and authorized persons. The appropriate DIN standards, construction rules
and safety instructions are to be followed for installation.
UNPACKING THE MODULES AND STORAGE
The utmost care is required when handling the modules.
Be careful when unpacking, transporting, and storing the modules:
• Transport modules in an upright position.
• Carry modules with both hands. Do not use the connection socket as a handle.
• Ensure modules do not bow under their own weight.
• Do not place modules on top of each other.
• Do not subject to load, do not stand on them.
• Do not mark using sharp implements.
• Do not stand on the panel.
• Keep all electrical contacts clean and dry.
If it is necessary to store the modules temporarily, a dry, ventilated room should be
used.
INSTALLING THE MODULES
When installing the modules, please pay attention to: the assembly is to be
mounted over a re resistant roof covering rated for the application.
• Keeping within the maximum permitted load.
The maximum mechanical load on the module must not exceed 5400pa.
To avoid exceeding the maximum mechanical load, site-specic live loads such
as wind and snow should be taken into account.

Specyfikacje produktu

Marka: SereneLife
Kategoria: panel słoneczny
Model: SLSPSKT205

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z SereneLife SLSPSKT205, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje panel słoneczny SereneLife

SereneLife

SereneLife SLSPSKT405 Instrukcja

25 Września 2024
SereneLife

SereneLife SLSPSKT100 Instrukcja

25 Września 2024
SereneLife

SereneLife SLSPSKT205 Instrukcja

25 Września 2024
SereneLife

SereneLife SLSPSKT200 Instrukcja

25 Września 2024
SereneLife

SereneLife SLSPNL10 Instrukcja

25 Września 2024
SereneLife

SereneLife SLSOLBK002 Instrukcja

25 Września 2024

Instrukcje panel słoneczny

Najnowsze instrukcje dla panel słoneczny

Victron Energy

Victron Energy BlueSolar PWM-Light 48-30 Instrukcja

15 Października 2024
CyberPower

CyberPower SCUN25A Instrukcja

9 Października 2024
CyberPower

CyberPower SCUN60A Instrukcja

9 Października 2024
CyberPower

CyberPower CPS1500ESA24 Instrukcja

9 Października 2024
CyberPower

CyberPower CPSHB300ETR Instrukcja

9 Października 2024
CyberPower

CyberPower CPSPV33000ETL-WB Instrukcja

9 Października 2024
CyberPower

CyberPower CPS3000EILCD Instrukcja

9 Października 2024
V-TAC

V-TAC VT-AU450-36V Instrukcja

8 Października 2024
V-TAC

V-TAC VT-450 Instrukcja

8 Października 2024
APSystems

APSystems EZ1 Instrukcja

7 Października 2024