Instrukcja obsługi Scandomestic SD 46

Scandomestic Chłodzenie zamrożenia SD 46

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Scandomestic SD 46 (4 stron) w kategorii Chłodzenie zamrożenia. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

SD 46

SD 76

SD 92

User manual

Scandomestic A/S · Thrigesvej 2 · DK-8600 Silkeborg

T + 45 7242 5571 · F + 45 8622 5571 · scandomestic.dk

TRANSPORTATION AND INSTALLATION

1 Place on level oor and remove the bottom packing, in order

to decrease the shock and noise.

The angle between the compartment body and ground

should be no more than 45°

2 Enough space should be left between the freeze and the

wall for ventilation.

3 Place the freezer away from heat source and do not expose

to direct sunshine.

4 Do not install where there is moisture or where it can easily

be splashed by water.

5 Do not place the freezer in environment prone to freezing.

6 The appliance should not be used in open air and should not

be exposed to rain.

ADJUSTMENT AND RUNNING

1 Adjustment of temperature: The storing temperature can be

adjusted by the thermostat of the compartment. The ther-

mostat should be adjusted according to different environ-

ment temperature and the food by rotating the knob of the

thermostat. The knob rotates clockwise from ”1” to “7”(or

direction arc)and the inside temperature turns down in

summer (anti-clockwise rotation)and up in winter(clockwise

rotation). It is usually xed to a certain point before leaving

the factory. Do not adjust too often or touch the other parts.

2 Trial running: plug in and wait. The marked drop in tempe-

rature within half an hour indicates that the freezer works

properly.

The compressor should be left to run for a period of time(6

hours in summer 4 hours in winter )before putting the food

in.

SAFETY PRECAUTIONS

1 The freezer should use a single 3-pin socket with (13A)fuse.

A multi –plug outlet should not be used.

2 You should install a suitable automatic voltage regulator not

less than 500w when the voltage is outside the range from

187V to 242V.

3 The sockets of the freezer should be connected to stable

xed connection. Under no circumstance should the wiring

be connected to such facilities as water pipe, gas pipe and

so on.

4 Once power is cut off, wait for at least 5 minutes before

plugging in again to avoid damaging the compressor or the

system.

5 Do not put combustible ,explosive or volatile dangerous

articles, heavily corrosive acid or alkali of liquid in glassware

into the freezer.

6 Children should be kept away from the freezer to avoid da-

mage to the inner container or any accidents being incurred

7 If the power cable damages, for avoid dangerous, must by

manufactory or its maintain a set or similar profession job

the personnel replaces.

FREEZING METHODS

1 Do not put too much food into the freezer or exceed the

loading line.

2 proper space should be allowed between foods to ensure

cooling air circulation.

3 Never use corrosive detergent, hot water, or washing power

to clean the freezer.

4 Do not use water to scour the freezer. Do not use hard bru-

shes or wire brushes to clean the freezer.

5 Do not use metal or sharp tools for defrosting.

6 Do not use electric heaters to heat up and defrost.

7 The green lamp is a power indicating lamp. When the power

is on, the lamp will be on.

TROUBLE SHOOTING:

The design and production comply with the relative security

standard of China. If you nd it does not work as usual, please

examine and handle it according to the following table rst. If

the situation does not improve, you must contact our after-sale

service center or our special repair division to examine and repair

the appliance.

The following problems are not causes of breakdown:

There is a sound of liquid owing in the freezer It is the

sound of refrigerant owing in the circulating pipeline of the

refrigerating system.

- It is normal.

Too noisy

- The freezer is not installed in a level ground.

- Change the position.

The refrigerating system does not work for a It is an indicator

of high quality for its long time but the inside temperature is

very good insulation and low cooling retention low.

- It is normal.

Trouble Possibilities Check up Solutions Remarks

Compressor

does not work

Power is off The fuse is broken Check the fuse Replace the fuse If it is necessary plea-

se contact after-sales

service for repair

The connection bet-

ween plug and socket

is not good

Check the socket Repair or replace the

socket

The circuit of input and

output is out of use

Make sure that the

power is on

Check the circuit with

electric instrument

The thermostat knob is not in the

proper position

Check the thermostat Rotate the thermo-

statto the proper

position

Ask for professional

help

Compres-

sor keeps on

working

The tempe-

rature inside

is too high

Frost on the evaporator

is too thick

Check whether the

frost is thicker than

6-8mm

Defrost regularly

The door is being ope-

ned too frequently

Reduce the times of

opening

Too much food has

been stored at once

Take out some of the

food

The tempe-

rature inside

is OK

The ambient tempera-

ture is too high .while

the thermostat indica-

tes a small number

Make sure whether

the knob is indica-

ting at the“5-6”(or

deeper)

Adjust the thermostat

knob

The thermostat knob

on”2-4”is better(or

proper)

The thermostat does

not work

Replace the thermo-

stat

Ask for after-sales

service

Too noisy The oor is not level Make sure that the

freezer is level

Put pad under the

castors

The screw in fan or condenser is loose The screw is loose Rotate the xed screw

The refrigerating circuits touch each

other

Separate them

Specyfikacje produktu

Marka:	Scandomestic
Kategoria:	Chłodzenie zamrożenia
Model:	SD 46
Kolor produktu:	Szary
Typ produktu:	Zamrażarka witrynowa
Długość przewodu:	1.8 m
Położenie urządzenia:	Wolnostojący
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	220 - 240 V
Wysokość produktu:	500 mm
Szerokość produktu:	570 mm
Głębokość produktu:	500 mm
Waga produktu:	30000 g
Szerokość opakowania:	610 mm
Wysokość opakowania:	535 mm
Głębokość opakowania:	565 mm
Poziom hałasu:	50 dB
Prąd:	1.2 A
Obciążenie:	150 W
Klasa wydajności energetycznej:	E
Skala efektywności energetycznej:	Od A do G
Zawias drzwiczek:	Prawy
Światło wewnętrzne:	Tak
Waga wraz z opakowaniem:	34000 g
Liczba półek:	2 pół.
Roczne zużycie energii:	2760 kWh
Zużycie energii:	7.5 kWh/24h
Pojemność netto:	42 l
Urządzenie rozmrażające:	R290a
Zakres temperatur (strefa 1):	-9 - -24 °C
Pojemność brutto:	45 l
Materiał frontów:	Szkło
Tryb klimatu:	N
Zamykanie:	Nie
Średnia waga chłodnicza:	90 g
Ilość stref temperatury:	1
System chłodzenia:	Statyczne