Instrukcja obsługi Saturn ST-FP0051
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Saturn ST-FP0051 (23 stron) w kategorii Blendery. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/23
1
ST-FP0051
BLENDER
БЛЕНДЕР
БЛЕНДЕР
2 3
GB
BLENDER
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause
condensation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.
If the unit has been in transit,
leave it indoors for at least 1.5
hours before starting operation.
IMPORTANT SAFEGUARDS
Before using the electrical appliance,
the following basic precautions should
always be followed including the
following:
1. Read all instructions.
2. Before using check that the voltage
of wall outlet correspond to the one
shown on the rating plate.
3. Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions, or is dropped
or damaged in any manner. Return
appliance to the nearest authorized
service facility for examination, repair
or electrical or mechanical adjustment.
4. If the supply cord is damaged it
must be replaced by the manufacturer
or an authorized service agent or a
qualified technician in order to avoid a
hazard.
5. Unplug from outlet when not in use,
before putting on or taking off parts,
and before cleaning. Always
disconnect the blender from the
supply if it is left unattended and
before assembling, disassembling or
cleaning.
6. Do not let cord hang over edge of
table or hot surface.
7. Do not immerse upper part of
blender into water as this would give
rise to electric shock.
8. Avoid contacting moving parts.
9. Keep hands and utensils out of
container while blending to reduce the
risk of severe injury to persons or
damage to the blender. A scraper may
be used but must be used only when
the blender is not running.
10.The appliance cannot be used for
chopping ice or blending hard and dry
substance, otherwise the blade could
be blunted.
11. To reduce the risk of injury, never
place cutting blade on base without
first putting bowl properly in place.
12. Be sure chopper lid is securely
locked in place before operating
appliance.
13. The use of accessory not
recommended by the manufacturer
may cause injuries to persons.
14. Do not operate the appliance for
other than its intended use.
15. This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliances by a person responsible for
their safety.
16. Children should be supervised to
ensure that they do not play with the
appliance.
17. Do not use outdoors.
18. Save these instructions.
19. Service life 2 years.
HOUSEHOLD USE ONLY
Know your blender (It is suitable
for blending vegetable and fruit)
4
Know your accessory-chopper
Know your accessory-beater
Using your blender
Before the first use, clean the blender
according to the section of “quick
cleaning”.
The time running unit without load
can’t exceed 15s.
Important: Blades are very sharp,
handle with care. Ensure that the
hand-held blender is unplugged from
the power outlet before assembling or
removing attachments.
Instruction for blender
Max operation duration per time
cannot exceed 1 minute, and 3
minutes rest time must be maintained
at two consecutive cycles.
1. To assemble the detachable shaft
with the motor unit, turn the shaft
anti-clockwise direction until
tightened. To disassemble, just turn in
the adverse direction.
2. Simply plug the hand-held blender
to power outlet.
3. Lower the hand-held blender into
food. Then press and hold the low
speed button to start operating. At the
same time you can select desired
speed setting by dialling the speed
control dial, there are five settings: 1,
2, 3, 4, 5 (from low speed to high
speed).
4. You also can start operating by
pressing and hold the high speed
button (turbo button), the appliance
will operate at the highest speed all
the time.
5. To stop the hand-held blender by
releasing the low speed button or high
speed button.
Instruction for chopper
Max operation duration per time
cannot exceed 1 minute, and 2 minute
rest time must be maintained at two
consecutive cycles.
1. Place the chopper bowl on a clean,
level surface.
2. Assemble the stainless chopping
blade into the chopper bowl, as shown
in Fig.1.
3. Place food into the chopper bowl.
Note: remove the bone of the meat,
cut small piece, then place the meat
into bowl, the max quantity of meat
can’t exceed 200g in every blending.
4. Attach the lid onto the chopper
bowl, make sure the tuber on the
inside wall of bowl aligns with the
groove of lid, then put down the lid
and turn it in clockwise direction until
it locks into position.(See Fig.2) To
detach the lid, turn in adverse
direction.
5. Insert the motor unit into the hole
of the chopper lid, and turn in
clockwise direction to lock. (See Fig.3)
5
6. Plug the appliance to power outlet.
Then press and hold the low speed
button or high speed button to start
operating. At the same time you can
select desired speed setting by dialing
the speed control dial, there are five
settings: 1, 2, 3, 4, 5 (from low speed
to high speed).
7. You also can start operating by
pressing and hold the high speed
button (turbo button), the appliance
will operate at the highest speed all
the time.
8. To stop the appliance by releasing
the low speed button or high speed
button of the motor unit.
9. After finishing chopping, unplug the
power outlet firstly, then remove the
motor unit from the chopper lid by
turning it in anti-clockwise.
10. Open the chopper lid by turning it
in anti-clockwise and remove the
chopped food.
Caution:
-To reduce the risk of injury, never
place cutting blade on base without
first putting bowl properly in place.
-Be sure chopper lid is securely locked
in place before operating appliance.
-During operating or after chopping,
for safety, you shall disassemble the
motor unit from the chopper lid firstly,
then remove the chopper lid. Never
remove the chopper lid with the motor
unit in place.
Instruction for egg white beater
Max operation duration per time
cannot exceed 2 minute, and 2 minute
rest time must be maintained at two
consecutive cycles.
1. To assemble the egg white beater
with the motor unit, turn the whisk
anti-clockwise direction until
tightened. To disassemble, just turn in
the adverse direction.
2. Simply plug the hand-held blender
to power outlet.
3.Place egg white into the cup,
generally, two eggs white is enough.
4. Lower the hand-held blender into
food. Then press and hold the low
speed button or high speed button to
start operating.At the same time you
can select desired speed setting by
dialing the speed control dial, there
are five settings: 1, 2, 3, 4, 5 (from
low speed to high speed).
4. You also can start operating by
pressing and hold the high speed
button (turbo button), the appliance
will operate at the highest speed all
the time.
5. To stop the hand-held blender by
releasing the low speed button or high
speed button of the motor unit.
CLEANING AND MAINTENANCE
1. Unplug the appliance and remove
the detachable stem.
Note: Do not immerse the detachable
stem of the blender in water because
overtime the lubrication on the
bearings may wash away.
2. Wash the detachable stem under
running water, without the use of
abrasive cleaner or detergents. After
finishing cleaning the detachable
stem, place it upright so that any
water which may have got in, can
drain out. The stem is dishwashing
safe component.
3. Wash the cup, bowl, beater and
blade in warm soapy water. The bowl,
bowl lid and the beater are not
recommended to place in dishwashing
machine as the plastic component
deteriorates through prolonged use of
dishwasher cleaning.
4. Wipe the motor unit with a damp
cloth. Never
immerse it in
water for
cleaning as an
electric shock
may occur.
5. Dry
thoroughly.
Caution: Blades
are very sharp,
handle with
care.
6. Reassemble
the blender
shaft to motor
unit then place
it upright in
wall bracket
(see Fig.4) or hang it up for saving
space.
Specyfikacje produktu
| Marka: | Saturn |
| Kategoria: | Blendery |
| Model: | ST-FP0051 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Saturn ST-FP0051, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Blendery Saturn
14 Października 2024
6 Lipca 2024
5 Lipca 2024
2 Lipca 2024
Instrukcje Blendery
- Blendery Electrolux
- Blendery AEG
- Blendery Beko
- Blendery Gorenje
- Blendery Sharp
- Blendery Braun
- Blendery Russell Hobbs
- Blendery Tefal
- Blendery Philips
- Blendery SilverCrest
- Blendery Bosch
- Blendery Severin
- Blendery Black & Decker
- Blendery Adler
- Blendery Domo
- Blendery Orbegozo
- Blendery Siemens
- Blendery ECG
- Blendery Kenwood
- Blendery Zelmer
- Blendery Ninja
- Blendery Cuisinart
- Blendery Wilfa
- Blendery Bomann
- Blendery Morphy Richards
- Blendery Klarstein
- Blendery KitchenAid
- Blendery AFK
- Blendery TriStar
- Blendery Princess
- Blendery Waring Commercial
- Blendery Gemini
- Blendery Rommelsbacher
- Blendery Cosori
- Blendery OBH Nordica
- Blendery Swan
- Blendery Aresa
- Blendery Tomado
- Blendery Bellini
- Blendery Oster
- Blendery Sinbo
- Blendery Jata
- Blendery Logik
- Blendery Currys Essentials
- Blendery Aigostar
- Blendery Bella
- Blendery Eldom
- Blendery Kitchen Perfected
- Blendery Hema
- Blendery Mx Onda
- Blendery Vitamix
Najnowsze instrukcje dla Blendery
14 Października 2024
14 Października 2024
13 Października 2024
13 Października 2024
12 Października 2024
12 Października 2024
11 Października 2024
10 Października 2024
10 Października 2024
8 Października 2024