Instrukcja obsługi RYOBI One+ RY18BI150B

RYOBI nieskategoryzowany One+ RY18BI150B

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla RYOBI One+ RY18BI150B (4 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 23 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
RY18BI150B
2s
A
B
2s
1
2
3
5
4
6
IMPORTANT!
The product is not intended to be used or cleaned by persons
with reduced physical, sensory, or mental capabilities or lack of
experience or knowledge unless they have been given instructions
concerning the safe use of the product by a person legally
responsible for their safety. They should be supervised while using
the product. Children shall not use, clean, maintain, or play with the
product, which when not in use should be secured out of their reach.
Subject to technical modication.
Safety, performance, and dependability have been given top priority
in the design of your battery inverter.
INTENDED USE
The product may be used for the following purposes:
■operating and charging USB-powered devices
■supplying electrical power for operating compatible small
electronics such as cell phones, tablets, laptops, LED lights, fans,
radios, etc.
■charging RYOBI 18V ONE+ battery packs
The product is intended for indoor use only.
When a battery pack is installed, the product converts DC electricity
to the charging power outputs listed in this manual, allowing the user
to charge and power a variety of devices. If a battery pack is being
charged, the battery inverter does not provide power to any device
connected to the USB-A charging ports.
The product’s AC receptacle has a non-sinusoidal output and is not
recommended for use with certain types of sensitive electronics or
electrical devices containing a compressor. Refer to the electronics’
operator’s manual.
The product is rated at 150 W power output. Check the power rating of
your electrical device before using it with the product. Do not use the
product if the power rating of your electrical device exceeds 150 W.
GENERAL SAFETY WARNINGS
Read and understand all instructions. Failure to follow all
instructions listed below may result in electric shock, re, and/or
serious injury.
■Save these instructions. Refer to them frequently and use them to
instruct others who may use this product. If you loan someone the
product, loan them these instructions also.
■Do not expose the product to rain, wet, or damp conditions. Water
entering the product increases the risk of electric shock.
■Use the product with the provided power supply unit only.
■Do not use the product if it has been dropped or received a sharp
blow. A damaged product increases the risk of fire. Always inspect
the product for damage before use.
■Remove the battery pack from the product when not in use.
■Do not disassemble or modify the product. Electric shock hazard
may occur even when a battery is not installed. Any part that is
damaged should be properly repaired or replaced by an authorised
service centre.
100%
x3
0%
x4
30%
x1
60%
x2
A B C D
2s
1
2
RY18BI150B-120
■To reduce the risk of injury, close supervision is necessary when
the product is used near children.
■Store the product indoors and away from children.
■Use caution when plugging or unplugging other devices into the
product. Do not force plugs into the product.
■If the product is used in a manner not specified by the manufacturer,
the protection provided by this equipment may be impaired.
■Do not overload the product. The product must be used for
powering devices less than the product rating.
■Never block the air vents. Blocked vents may cause overheating.
The product automatically turns off when overheated.
■Keep the product cool. Do not place the product near heat vents
or in direct sunlight.
■Do not use the product around flammable fumes and gases, such
as in the bilge of a boat or near propane tanks.
■Do not put foreign objects into the product.
■Operate the product using only the AC power type listed in the
product specifications.
■The product should never be hard-wired into a circuit.
■Do not leave the product unattended during operation.
■Operate the product only in temperatures between 0°C and 40°C.
■Do not use the product to power life support devices or other
medical equipment.
■Risk of electric shock. When using a grounded appliance, the
product does not provide an electrical path to earth ground. Do
not power devices which are damaged or with damaged or frayed
power cords.
■An internal cooling fan runs to regulate the product’s operating
temperature. Always wait for the fan to stop before disconnecting
the battery pack from the product.
■Use RYOBI 18V ONE+ battery packs only. Do not use battery
packs from other manufacturers.
■Do not at any time, let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken, or destroy plastic, which could
result in serious personal injury.
■The light source of the product is not replaceable. When the light
source reaches its end of life, the product must be replaced.
■Do not use a multiple socket outlet or adaptor on the AC socket.
■Do not recharge primary cells (non-rechargeable).
■Remove the battery pack from the product before charging.
■Do not mix battery packs of different types or levels of use.
■Protect the battery contact terminals from metallic objects to avoid
a short circuit, which can cause fire or explosion.
■Do not charge battery packs that show signs of leaks. Dispose of
them properly.
■Do not place the product and battery pack in an area of extreme
heat or cold. They work best at normal room temperature.
■Never charge a damaged battery pack. Replace damaged battery
packs immediately.
■When charging, the charger and battery pack should be placed in
a location where the temperature is more than 10°C but less than
25°C.
OPERATION
CHARGING THE BATTERY PACK
The green LED on the battery pack ashes when charging the battery
pack and remains on after the battery pack is fully charged.
MAINTENANCE
■When not using or when cleaning the product, disconnect it from
the power supply and remove the battery pack.
■Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents
and may be damaged by their use. Use clean cloths to remove
dirt, dust, oil, or grease.
KNOW YOUR PRODUCT
See illustration.
1. Battery port
2. Area/warning light button
3. Power button
4. USB-C charging port
5. USB-A charging port
6. AC socket
SYMBOLS ON THE PRODUCT
Safety alert
Remove the battery pack before starting any work on
the product.
Beware of electric shock hazard.
Do not expose the product to rain or damp conditions.
Read and understand all instructions before operating
the product. Follow all warnings and safety instructions.
Class II: Protection against electric shock relies on
double insulation or reinforced insulation.
Press the power button for 2 seconds to turn the
product on or o󰀨.
F20A*2
Fast blow fuse
Indoor use only
European Conformity Mark
British Conformity Mark
EurAsian Conformity Mark
Ukraine Conformity Mark
Do not dispose of waste batteries, waste electrical and
electronic equipment as unsorted municipal waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately. Waste
batteries, waste accumulators, and light sources
have to be removed from the equipment. Check with
your local authority or retailer for recycling advice
and collection point. According to local regulations,
retailers may have an obligation to take back waste
batteries and waste electrical and electronic equipment
free of charge. Your contribution to the reuse and
recycling of waste batteries and waste electrical and
electronic equipment helps to reduce the demand
of raw materials. Waste batteries, in particular
containing lithium, and waste electrical and electronic
equipment contain valuable and recyclable materials,
which can adversely impact the environment and the
human health if not disposed of in an environmentally
compatible manner. Delete personal data from waste
equipment, if any.
PRODUCT SPECIFICATIONS
Battery inverter RY18BI150B
Rated supply 18 V d.c.16 A max
288 W max
AC output 230 V d.c. 50 Hz
150 W
USB-A total output 18 W max
5 V d.c. 3 A / 9 V d.c. 2 A / 12 V d.c. 1.5 A
USB-C output PD 30 W max
5 V d.c. 3 A / 9 V d.c. 3 A / 12 V d.c. 2.5 A / 15 V d.c. 2 A / 20 V d.c. 1.5 A
Charge output 18 V d.c. 1.5 A
Dimensions 142 x 90 x 74 mm
Weight 370 g
BATTERY
Model RY18BI150B-120 RY18BI150B-0
Battery pack 2.0 Ah -
Compatible battery packs RB18..

Specyfikacje produktu

Marka: RYOBI
Kategoria: nieskategoryzowany
Model: One+ RY18BI150B

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z RYOBI One+ RY18BI150B, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany RYOBI

RYOBI

RYOBI RY31DP18 Instrukcja

27 Lipca 2024
RYOBI

RYOBI One+ RY18FGA Instrukcja

10 Lipca 2024
RYOBI

RYOBI Max Power RY36PP25A Instrukcja

10 Lipca 2024
RYOBI

RYOBI One+ RY18BI150B Instrukcja

10 Lipca 2024
RYOBI

RYOBI One+ R18DA Instrukcja

9 Lipca 2024
RYOBI

RYOBI One+ R18RW3 Instrukcja

9 Lipca 2024
RYOBI

RYOBI One+ RWTS18 Instrukcja

9 Lipca 2024
RYOBI

RYOBI One+ R15GN18 Instrukcja

8 Lipca 2024
RYOBI

RYOBI One+ RY18HCA Instrukcja

8 Lipca 2024
RYOBI

RYOBI RLT1238 Instrukcja

27 Maja 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Asko

Asko DBI644MIB.S.TW/1 Instrukcja

28 Października 2024
Asko

Asko DFS233IB.S.TW/1 Instrukcja

28 Października 2024
Emko

Emko EZM-9920 Instrukcja

27 Października 2024
Emko

Emko ESM-3712-H Instrukcja

27 Października 2024
Emko

Emko ATS-10 Instrukcja

27 Października 2024
Emko

Emko EAOM-11.2 Instrukcja

27 Października 2024
Emko

Emko EPM-3790 Instrukcja

27 Października 2024
Emko

Emko EPM-7790 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux IAN 108340 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux HG06009A-BS Instrukcja

27 Października 2024