Instrukcja obsługi Queenaire QT Cyclone QTC1250

Queenaire oczyszczacz powietrza QT Cyclone QTC1250

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Queenaire QT Cyclone QTC1250 (2 stron) w kategorii oczyszczacz powietrza. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/2
QUEENAIRE TECHNOLOGIES, INC.
“The Ozone Specialists”
Queenaire Technologies, Inc.
P.O. Box 133
Ashburn, VA 20146
Toll Free: 1-877-64 OZONE
Tel: 1-703-654-0385 Fax: 1-703-654-0386
Volume
1
Owners Manual
QT Cyclone
Troubleshooting Guide
If you are having problems with your ozone machine please refer to the following instructions:
1. The fan comes on, but the green light does not. Remove the top
cabinet from the unit and check the condition of the ceramic plate.
Replace if broken. Replace top cabinet. Remove and replace the .200
milliamp fuse in the back of the unit. If the green indicator light is still
out contact Queenaire Technologies Customer Service at 1-877-64
OZONE.
2. When you turn the unit on nothing happens. First check your power
source to ensure there is power to the outlet. Plug the unit in. Check
the fuse marked 2 amp on the back of the unit. Replace if blown. If
the unit still does not operate contact Queenaire Technologies Customer Service department at the
number above.
3. If for any reason you are not happy with the performance of this unit contact customer service at
1-877-64 OZONE.
Operating QT Cyclone
Following are basic guidelines for eliminating odors continuously in rooms up to 10,000 cubic feet.
his unit is designed to be used either continuously in areas that have ongoing odor problems
or as a maintenance tool to quickly eliminate odors on a portable basis in areas up to 60,000
cubic feet. You can maximize the results if you expose fabrics fully, open interior doors and
turn on your air handling system. Keep in mind that ozone is a surface agent and must make
contact with the source of the odors to insure complete deodorization. While this unit is designed to
run continuously it should be monitored to insure that ozone levels do not exceed OSHA safety levels
of .04 ppm. Following is a formula and chart to help you determine the best setting for your ozone
unit when dealing with specic odors. This is a general guideline only as the output will vary substan-
tially depending on the odor factor, temperature and humidity.
AREA x ODOR FACTOR = MG/HR REGUIRED
1. Measure the Cubic Footage (L x W x H) of the room to be treated = A (area)
2. Estimate the Odor Factor (B) as follows:
* Light Odors = 0.005
* Medium Odors = 0.018
* Strong Odors = 0.036
3. Multiply A x B to determine MG/HR needed to eliminate the odor.
4. Use the chart to the Right to determine the setting for your unit.
5. Adjust the settings as needed for complete odor control.
Example: A room 50' x 50' x 8' = 20,000 cu/ft x .018 Medium Odor = 360 mg/hr. Set ozone
knob to 4. While smell is not an accurate guide to ozone levels, in levels above .03 ppm ozone
has a very strong unpleasant odor. If you are experiencing a strong odor, headache, dry nose
and/or dry throat, you should either turn the unit down or o to allow the levels to dissipate.
Now that you have determined the approximate MG/HR necessary to eliminate the odor, operating
instructions are as follows:
1. Turn ozone-setting knob to appropriate setting.
2. Set the timer as follows: 1 = 15 min., 2 = 30 min., 3 = 45 min., 4 = 1.5 hr., 5 = 3.5 hr., 6 =
continuous.
3. Plug the unit into a standard outlet.
4. Place the unit on a table or counter o the ground. Ozone is heavier than air, so the higher the better.
5. Turn the unit on.
6. Be sure to monitor the unit and adjust ozone setting as required for complete odor control.
7. Perform maintenance on your QT Cyclone on a monthly basis. Maintenance instructions can be
found on the last page of this manual.
How Does QT Cyclone Eliminate Odors?
All Queenaire Technologies, Inc. units eliminate odors by producing a controlled level of ozone.
Ozone is created naturally in our environment by lightning and the suns ultraviolet rays. It is best
known for its benet in the stratosphere for protecting us from the suns rays. What you may not
know is that it is also that fresh smell you experience after a lightning storm. Ozone is Mother
Nature’s solution to outdoor odor problems. QT Cyclone incorporates a technology that duplicates
the eect of lightning and creates ozone indoors. The end result is the same, a fresh, odor free
environment.
QT Cyclone Maintenance Instructions
The life expectancy of your QT Cyclone unit is 10 - 15 years, provided it is serviced and main-
tained on a regular basis. It is recommended that you perform a simple cleaning and maintenance
of your unit every six months. The lter should be changed monthly. High contaminate areas such
as smoking and garbage rooms may require monthly cleaning. Maintenance kits are available
through your distributor.
Before you begin performing any work to your ozone unit, be sure to unplug the electrical cord.
Step 1.) Remove two screws on the top of the unit as well as the top two screws on each side of the
unit. Remove the top cover from the unit.
Step 2.) Carefully remove the white ceramic generator plates from their frame. The plates should
lift easily by pulling from the top straight up and out of the frame. Use an alcohol wipe to gently
wipe the plates free of any dirt or stains. Inspect the plates carefully for cracks, breaks or irremov-
able stains. The plates can be reused provided there are no breaks or stains.
Step 3.) Use the same alcohol wipe to wipe out the exposed areas inside the unit. Spread the
generator frames apart to wipe the inside of the metal plates that make contact with the generator
plate. Be sure to also wipe the base of the frames completely.
Step 4.) Once the ceramic plates are completely dry, reinsert the plates into the generator frames or
replace the existing plates.
Step 5.) Reattach the top cover to the unit and put screws back in place.
Step 6.) Remove and discard the green lter on the back of the machine and replace with new
filter.
Step 7.) You may at this point have to change your 200mA fuse. To test your fuse, simply turn the
unit on. If the green ozone light comes on you have completed maintenance of the unit and are
ready to put it back in service. If the light does not come on, locate the 200mA fuse holder on the
back of the unit and remove the holder with a at head screwdriver by turning the holder 1/4 turn.
Remove the blown fuse and replace with the fuse enclosed in your maintenance kit. Your unit
should now be ready to go back to work.
Ozone
Setting
1
2
3
4
5
6
7
8
9
10
MG/HR
80 mg/hr
161 mg/hr
220 mg/hr
390 mg/hr
560 mg/hr
625 mg/hr
740 mg/hr
860 mg/hr
980 mg/hr
1200 mg/hr
T

Specyfikacje produktu

Marka: Queenaire
Kategoria: oczyszczacz powietrza
Model: QT Cyclone QTC1250

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Queenaire QT Cyclone QTC1250, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje oczyszczacz powietrza Queenaire

Queenaire

Queenaire QT Tornado QTT625 Instrukcja

12 Września 2024
Queenaire

Queenaire QT Cyclone QTC1250 Instrukcja

9 Września 2024
Queenaire

Queenaire QT Thunder-24 QTT24-II Instrukcja

6 Września 2024
Queenaire

Queenaire QT Storm QTSV Instrukcja

6 Września 2024
Queenaire

Queenaire QT Thunder QTT3F Instrukcja

4 Września 2024

Instrukcje oczyszczacz powietrza

Najnowsze instrukcje dla oczyszczacz powietrza

WDH

WDH 220B Instrukcja

15 Stycznia 2025
Honeywell

Honeywell HPA020 Instrukcja

15 Stycznia 2025
Lanaform

Lanaform LA120319 Instrukcja

15 Stycznia 2025
Lanaform

Lanaform LA120316 Instrukcja

15 Stycznia 2025
Lanaform

Lanaform Borneo - LA120319 Instrukcja

15 Stycznia 2025
Lanaform

Lanaform LA120313 Instrukcja

15 Stycznia 2025
Lanaform

Lanaform LA120209 Instrukcja

14 Stycznia 2025
Lanaform

Lanaform LA120308 Instrukcja

14 Stycznia 2025
Lanaform

Lanaform LA120123 Instrukcja

14 Stycznia 2025
Lanaform

Lanaform LA120318 Instrukcja

14 Stycznia 2025