Instrukcja obsługi QTX QTFX-B4


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla QTX QTFX-B4 (5 stron) w kategorii Maszyna efektów. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/5
www.avsl.com 1 5 UK Manual 60. 64
QTFX- B4
Professional Bubble Machine
Item ref: 160.564UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
www.avsl.com 1 5 UK Manu 60. 64 al
Introduction
Thank you for choosing the QTFX-B4 professional bubble machine as part of your stage effects setup. This
machine is the highest output model in the range and will provide consistent large area coverage. Please read
and keep this manual to ensure maximum performance and avoid damage through misuse.
Unpacking
Your QTFX-B4 should reach you in good condition and should be supplied with IEC mains lead(s) and a wired
handheld remote control. If there are any signs of damage or items missing from the packaging, contact your
dealer immediately.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the QTFX- to dry out B4
and have it checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case.
Refer all servicing to qualified service personnel.
Placement
The QTFX- has an open front fluid tank and should be operated in an upright position. B4
Choose a position where the bubble output is facing the area to be filled.
Ensure easy access to the rear panel and to the bubble fluid tank for refilling and cleaning.
When moving the unit around, take care not to spill the contents of the tank inside the machine.
Safety
Check for correct mains voltage and condition of IEC lead before connecting to power outlet
Check the condition of the remote lead and ensure that it is not trapped
This unit must be earthed
Cleaning
Use a soft dry or slightly damp cloth to clean the casing
Do not use strong solvents for cleaning the unit
Empty contents and rinse the bubble fluid tanks after each use
Setting up
The QTFX- requires bubble fluid to produce the effect. B4
It is recommended to use qtx bubble fluid for best results (160.574UK, 160.575UK)
For bubbles that glow in UV light, qtx UV bubble fluid may be used (160.576UK, 160.577UK)
A chart for recommended fluids is included further along in this document
Pour bubble fluid directly into the front open tank, taking care not to spill on fans beneath the tank
Connect the supplied remote control to the female IEC on the rear panel
Connect the IEC mains plug
www.avsl.com 1 5 UK Manu 60. 64 al
Layout
1. Bubble wand
2. Bubble wheel
3. Tank (pour fluid in here)
4. Front fans (do not cover)
5. Carry handle
6. Castor wheels
Rear panel
7. Rear Fans
8. IEC Power Socket
9. ON/OFF/REMOTE Switch
10. Fluid drain tap
11. Remote Socket
Operation
The QTFX-B4 is operated by a 3-position rocker switch. The centre position is off.
Press this switch to the left for constant bubble output.
Press this switch to the right for remote control of the bubble effec t.
In this mode, bubbles are only produced when the switch on the remote control is pressed.
After use, switch off the machine and disconnect from the mains.
Drain the remaining fluid via the drain tap at the rear of the unit.
Rinse the bubble fluid tank with clean water and drain this also, then close the tap.


Specyfikacje produktu

Marka: QTX
Kategoria: Maszyna efektów
Model: QTFX-B4

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z QTX QTFX-B4, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Maszyna efektów QTX

Instrukcje Maszyna efektów

Najnowsze instrukcje dla Maszyna efektów

Velleman

Velleman vdl660rl Instrukcja

10 Października 2024
Valcom

Valcom V-5580041A Instrukcja

8 Października 2024
Magmatic

Magmatic PMDMX1 Instrukcja

8 Października 2024
Magmatic

Magmatic CRISP Instrukcja

8 Października 2024
Magmatic

Magmatic CRISP MAX Instrukcja

8 Października 2024
Magmatic

Magmatic SIDEWINDER Instrukcja

8 Października 2024
Magmatic

Magmatic JAVELIN Instrukcja

8 Października 2024
BeamZ

BeamZ BLAZE3500 Instrukcja

8 Października 2024