Instrukcja obsługi PureGuardian TF2113B


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla PureGuardian TF2113B (10 stron) w kategorii Wentylator. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/10
©2016 Guardian Technologies LLC
Guardian Technologies LLC
26251 Bluestone Blvd. Euclid, OH 44132
1.866.603.5900 www.guardiantechnologies.com
USE & CARE INSTRUCTIONS
3-Speed Oscillating Tower Fan
Model No. TF2113
1-Year Limited Warranty
Customer Service
1.866.603.5900
www.guardiantechnologies.com
Date Purchased month ________ year _________
English French Spanish E - 1 F - 1 S - 1
Use GENUINE Guardian Technologies replacement parts only. REV0319
E-1
®
READ AND SAVE THESE INSTRUCTIONS
WARNINGS
Failure to comply with the warnings listed below may
result in electric shock or serious injury.
When using electrical appliances, basic safety precautions should always be followed including
the following:
1. Read all instructions before using this appliance.
2. To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs,
near heat registers, radiator, stoves or heaters.
4. Carefully discard any plastic wrapping that was used for the packaging.
5. To protect against electrical hazards, DO NOT immerse in water or other liquids.
Do not use near water.
6. Always unplug the appliance before moving it, cleaning or whenever it's not in use. Be sure to
pull out of the outlet by the plug and not the cord.
7. Avoid contact with moving parts.
8. Do not operate in the presence of explosive and/or flammable fumes.
9. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture
or appliances. Arrange cord away from traffic area and where it will not be tripped over.
10. DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate,
after the appliance malfunctions, or if it has been dropped or damaged in any manner.
Call Customer Service.
11. The use of attachments not recommended or sold by the appliance manufacturer may
cause hazards.
12. Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or
leave exposed to high traffic areas.
13. To disconnect, grip lug and pull from wall outlet. Never yank on cord.
14. Always use on a dry, level surface.
15. Do not operate fan until fully assembled with all parts properly in place.
16. To reduce the risk of electrical shock and injury to persons, do not use in window.
17. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do NOT play with the appliance.
18. WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state
speed control device.
E-2 E-3
This product should only be used in accordance with the specifications outlined in
this manual. Usage other than what has been specified here may result in serious
injury. INTENDED USE: This product is intended to circulate the air in indoor living
spaces only. This product is not intended for commercial or industrial uses. Any
other use not recommended by the manufacturer may cause fire, electric shock or
injury to persons.
WARNING: This product can expose you to chemicals including lead or lead
compounds, which are known to the State of California to cause cancer or birth
defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
FUSED SAFETY PLUG
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit
situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user
servicing instructions (follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and the product should be discarded or
returned to an authorized service facility for examination and/or repair.
USER SERVICING INSTRUCTIONS
If your fan loses power and you suspect that the fuse on your fan has blown, grasp plug and
remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
Slide fuse cover, located on the top of the plug, towards the prongs of the plug. (Fig. 1)
Carefully remove the blown fuse and snap a new fuse into place. To reduce the risk of fire, replace
fuse only with 2.5 Amp, 125 volt fuse. Fully close the fuse door by sliding back into place. (Fig. 2)
Discard the blown fuse. The plug should now be ready for normal use.
To reduce the risk of fire, do not replace attached plug. Contains a safety device (fuse) that should
not be removed. Discard product if the attached plug is damaged.
If you need further information on how or when to replace the fuse in the safety plug, please
contact Guardian Technologies customer service.
IMPORTANT - This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.
Fig. 1 Fig. 2
®
E-4
1. Plug into a 120V electrical outlet based on the voltage indicated on the rating label.
2. Select a firm, level flat location at least six inches (15 cm) from
any wall or object for proper air flow. Point air outlet away from wall.
3. Turnon by turning control knob to preferred fan speed.
0 - Off
1 - Low Speed
2 Medium Speed
3 High speed
4. Press “Oscillation button” to make the
tower fan oscillate back and forth.
DIRECTIONS FOR USE
E-5
PRODUCT SPECIFICATIONS AND PARTS
Power Plug
Control Panel
Air Outlet
Air Intake
Base
4 pack of screws
included for base
assembly
ASSEMBLY
1. Carefully unpack your tower fan and the set of 4 screws. Remove all plastic bags.
Remove shipping tape strips from the sides of the fan.
2. Gently turn the fan upside down. Place the front base piece on the bottom of the unit.
3. Place the power cord through the
notch on the back base piece.
4. Connect the back
piece to the front
piece by aligning
the notches.
6. Secure base
to the fan with
the 4 provided
screws.
Power and fan
speed control
Oscillation Button
1. Turn the tower fan off and unplug it before cleaning.
2. The outside of the tower fan can be cleaned with a soft, clean dampened cloth.
3. The air inlet and outlet can be cleaned of dust with a small, soft brush.
4. Do not allow moisture to come in contact with the main body of the tower fan.
Ensure that the fan is switched off from the supply mains before removing the guard.
CLEANING AND MAINTENANCE
END OF SEASON STORAGE
Follow the cleaning instructions if the fan will be stored at the end of the season.
Pack the unit in its original carton and store in a cool, dry location.
TROUBLE SHOOTING GUIDE
Unit won’t operate. Check to make sure the unit is plugged in.
Check to make sure the unit is on.
Check the fuse in the power cord (page 3).
Check to make sure the outlet is working properly.
Check that the base is correctly assembled.
PROBLEM SOLUTION
Decreased air flow. Check to make sure nothing is blocking the air inlet or outlet.
Be sure the plastic bag has been removed from the unit.
O
3
2
1
5. Put the power
cord through
the cord guides.


Specyfikacje produktu

Marka: PureGuardian
Kategoria: Wentylator
Model: TF2113B

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z PureGuardian TF2113B, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Wentylator PureGuardian

Instrukcje Wentylator

Najnowsze instrukcje dla Wentylator

Air King

Air King E130SH Instrukcja

10 Października 2024
TriStar

TriStar VE-5936 Instrukcja

10 Października 2024
Orbegozo

Orbegozo PW 1321 Instrukcja

10 Października 2024
Thermex

Thermex Silent 100 CZ Instrukcja

9 Października 2024
Imarflex

Imarflex IF-375BU Instrukcja

9 Października 2024
Imarflex

Imarflex IF-365BK Instrukcja

9 Października 2024
Kogan

Kogan KARCDCFANLA Instrukcja

9 Października 2024
Westinghouse

Westinghouse 72206 Instrukcja

9 Października 2024
Westinghouse

Westinghouse 78425 Instrukcja

9 Października 2024