Instrukcja obsługi Prem-i-air EH1418

Prem-i-air Nawilżacz EH1418

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Prem-i-air EH1418 (15 stron) w kategorii Nawilżacz. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/15

Page 1

EH1418

Compressor Dehumidiﬁer

Déshumidiﬁcateur Compresseur

Page 2

IMPORTANT

Installer and Users please note:

These instructions should be read carefully and left with the user of the product

for future reference.

BEFORE USE

You must inspect the product including its cable and plug for any signs of

damage. If the product is damaged, DO NOT use it, and contact your supplier

immediately.

PRODUCT SAFETY

This appliance can be used by children aged from 8 years and above

and persons with reduced physical, sensory or mental capabilities or lack of

experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand the hazards

involved.

Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without

supervision.

Place the appliance on a ﬁrm ﬂat stable surface.

Make sure that air intakes and exhausts are not obstructed.

For indoor use only.

Do not place this appliance within 400mm (16") of curtains or similar items.

Ensure that the appliance stands upright at all times.

Do not use this appliance in the immediate surroundings of a bath, shower or

swimming pool.

Do not place the mains lead beneath a carpet or rug.

Do not use this appliance in locations where paint, petrol or other ﬂammable

liquids are used or stored.

Do not insert any object into this appliance through the grilles. This may

damage the heater or result in overheating or electric shock.

Do not turn oﬀ the mains supply when the appliance is running. Always turn

the rotary humidistat control to the OFF position, and wait 3 minutes before

disconnecting the mains supply. This protects the compressor from damage.

Do not leave the product unattended for long periods of time.

Ensure that the product does not tip over whilst there is water in the bucket.

Page 3

INSTALLATION

Place the appliance on a ﬁrm, ﬂat level surface.

If continuous drainage is to be used, unscrew and remove the bung from the

drainage port (on the back of the appliance, half-way up, on the right-hand side),

and connect a drainage hose to the port. Use a hose with an internal diameter of

12mm (½"). Make sure that the hose runs downwards throughout its entire

length, and has no kinks. Otherwise the drainage will not work.

The bung can be stored in the bucket in case it is required at a later date. Make

sure that the bucket is ﬁtted correctly into the housing.

OPERATION

• Plug the mains lead into a 13 Amp mains socket.

• If connecting via an extension lead, make sure that the lead is rated at 5

Amps, and that it is fully unwound.

• Place the appliance on a ﬁrm flat level surface.

• Switch the appliance on at the mains socket. Then press the power switch to

start operation.The appliance will wait for 3 minutes whilst the refrigerant

settles before starting to operate, this is to extend the life of the compressor.

• Using the + and ˜ buttons, set the required humidity level on the display. The level can be set between 35% and 80% in 5% increments. The appliance will