Instrukcja obsługi POSline SM2430

POSline czytnik kodów kreskowych SM2430

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla POSline SM2430 (25 stron) w kategorii czytnik kodów kreskowych. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/25
Manual del Usuario
SM2430
ESPECIFICACIONES SUJETAS A CAMBIO SIN PREVIO AVISO.
i
No warranty of any kind is made in regard to this material, including, but not limited to, implied
warranties of merchantability or fitness for a particular purpose. We are not liable for any errors con-
tained herein nor incidental or consequential dam furnishing, performance ages in connection with
or use of this material.
No part of this document may be reproduced, transmitted, stored in a retrieval system, tran-
scribed, or translated into any language or computer language in any form or by any means elec-
tronic, mechanical, magnetic, optical, chemical, manual or otherwise, without express written
consent and authorization.
We reserve the right to make changes in product design without reservation and without notifi-
cation. The material in this guide is for information only and is subject to change without notice.
All trademarks mentioned herein, registered or otherwise, are the properties of their various
respective owners.
Copyright © 2004. All rights reserved.
Radio Notice
This equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions in this manual, it may cause interference to radio commu-
nications. The equipment has been tested and found to comply with the limits for a Class A comput-
ing device pursuant to EN55022 and 47 CFR, Part 2 and Part 15 of the FCC Rules. These
specifications are designed to provide reasonable protection against interference when operated in
a commercial environment.
Radio and Television Interference
Operation of this equipment in a residential area can cause interference to radio or television
reception. This can be determined by turning the equipment off and on. The user is encouraged to
try to correct the interference by one or more of the following measures:
* Reorient the receiving antenna.
* Relocate the device with respect to the receiver.
* Move the device away from the receiver.
* Plug the device into a different outlet so that the device and the receiver are on different
branch circuits.
If necessary the user may consult the manufacturer, an authorized dealer, or experienced
radio/television technician for additional suggestions. The user may find the following booklet pre-
pared by the Federal Communications Commission helpful: “How to Identify and Resolve Radio-TV
Interference Problems.” This booklet is available from the U.S. Government Printing Office, Wash-
ington, DC 20402 U.S.A., Stock No. 004000003454.
For CE-countries
This scanner is in conformity with CE standards. Please note that an approved, CE-marked
power supply unit should be used in order to maintain CE conformance.
ii
Laser Safety
The Dual-Laser Omnidirectional Vertical Scanner complies with safety standard
IEC 60825 for a Class I laser product. It also complies with CDRH as applicable
to a Class IIa laser product. Avoid long term staring into direct laser light.
Radiant Energy: The Dual-Laser Omnidirectional Vertical Scanner uses two
low-power visible laser diodes operating at 650nm in an opto-mechanical scan-
ner resulting in less than 3.9µW radiated power as observed through a 7mm
aperture and averaged over 10 seconds.
Do not attempt to remove the protective housing of the scanner, as unscanned
laser light with a peak output up to 0.8mW would be accessible inside.
Laser Light Viewing: The scan window is the only aperture through which
laser light may be observed from this product. A failure of the scanner motor,
while the laser diode continues to emit a laser beam, may cause emission lev-
els to exceed those for safe operation. The scanner has safeguards to prevent
this occurrence. If, however, a stationary laser beam
is emitted, the failing scan -
ner should be disconnected from its power source immediately.
Adjustments: Do not attempt any adjustments or alteration of this product. Do
not remove the protective housing of the scanner. There are no user-service-
able parts inside.
Caution: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous laser light exposure.
Optical: The use of optical instruments with this product will increase the eye
hazard. Optical instruments include binoculars, magnifying glasses, and micro-
scopes but do not include normal eye glasses worn by the user.

Specyfikacje produktu

Marka: POSline
Kategoria: czytnik kodów kreskowych
Model: SM2430

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z POSline SM2430, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje czytnik kodów kreskowych POSline

POSline

POSline SL2030 Instrukcja

13 Września 2024
POSline

POSline SC2110 Instrukcja

13 Września 2024
POSline

POSline SL2020 Instrukcja

13 Września 2024
POSline

POSline SC2100b Instrukcja

13 Września 2024
POSline

POSline SM2410B Instrukcja

13 Września 2024
POSline

POSline SC2140 Instrukcja

13 Września 2024
POSline

POSline SM2450 Instrukcja

13 Września 2024
POSline

POSline TPC7020C Instrukcja

13 Września 2024
POSline

POSline SC2100 Instrukcja

13 Września 2024
POSline

POSline SM2410 Instrukcja

13 Września 2024

Instrukcje czytnik kodów kreskowych

Najnowsze instrukcje dla czytnik kodów kreskowych

Posiflex

Posiflex CD-3602U Instrukcja

9 Października 2024
Posiflex

Posiflex CD-3202U Instrukcja

9 Października 2024
Datalogic

Datalogic CBX500 Instrukcja

9 Października 2024
Brady

Brady IRX200 Instrukcja

8 Października 2024
Newland

Newland HR33 Marlin filaire Instrukcja

8 Października 2024
Wasp

Wasp WDI9600 Instrukcja

7 Października 2024
Wasp

Wasp WLS9500 Instrukcja

7 Października 2024
Wasp

Wasp WCS3900 Instrukcja

7 Października 2024
Wasp

Wasp WDI4600 Instrukcja

7 Października 2024
Wasp

Wasp WLR8900 Instrukcja

7 Października 2024